FORD WSS-M1H767-A-2008 FABRIC PINNACLE PATTERN 44 GAGE KNITTED DBR TO BE USED WITH FORD WSS-M99P1111-A 《44 GAGE的小尖塔（PINNACLE）图案的二苯甲酰间苯二酚（DBR）针织织物 与标准FORD WSS-M99P1111-A一起使用 》.pdf

1、 ENGINEERING MATERIAL SPECIFICATIONDate Action Revisions 2008 02 06 N-STATUS No replacement named S. Kornylo 2003 02 18 Revised Para 3.0 inserted ; Para 3.1, 3.2, 3.3, 3.10, 3.11, 4 deleted 1997 11 11 Activated N.J. Komatsu Printed copies are uncontrolled Copyright 2008, Ford Global Technologies, LL

2、C Page 1 of 2 FABRIC, PINNACLE PATTERN, 44 GAUGE KNITTED DBR WSS-M1H767-A NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a 6 bar, 44 gauge DBR knitted simulated velour, polyester bodycloth. 2. APPLICATION This specification was released originally for material u

3、sed as an interior trim fabric for the 99MY CW 170. 3. REQUIREMENTS In addition to the requirements listed herein, the fabric shall meet all requirements of WSB-M8P18-A1/A2/A3/A4. 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys St

4、andard Requirements For Production Materials (WSS-M99P1111-A). 3.4 FABRIC CONSTRUCTION 3.4.1 Fabric Count, +/- 5% tolerance (ASTM D 3887) Warp 90 Wales/10 cm Weft 95 Courses/10 mm 3.4.2 Fabric Weight, range 370 - 410 g/m2(FLTM BN 106-01) 3.5 COMPOSITION (ASTM D 629) Fabric 100% Polyester ENGINEERING

5、 MATERIAL SPECIFICATIONWSS-M1H767-A Printed copies are uncontrolled Copyright 2008, Ford Global Technologies, LLC Page 2 of 2 3.6 YARN CONSTRUCTION (ASTM D 1244) No. 1 bar 100 dtex f20 (polyester, bright, round, texturized) No. 2 bar 100 dtex f32 (polyester, bright, round, texturized) No. 3 bar 167

6、dtex f48 (polyester, semi-dull, octolobal FTF) No. 4 bar 167 dtex f48 (polyester, bright, round, FT) No. 5 bar 100 dtex f32 (polyester, bright, round, texturized) No. 6 bar 100 dtex f20 (polyester, bright, round, texturized) 3.7 METHOD OF DYEING Yarn dyed (No. 3 bar) and spun dyed, (No. 1, 2, 4, 5,

7、6 bar) or as approved by Materials Engineering. 3.8 FINISHED OPERATIONS As approved by Materials Engineering 3.9 FLAMMABILITY (ISO 3795/SAE J369) Burn rate, max 100 mm/minute Note: Not required on face fabric when used as a fully bonded composite. 5. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. 5.1 Purchase departments will ensure that both materials defined in this specification and shipped to any one assembly plant will be produced by one supplier.