FORD WSS-M1H781-A-2008 FABRIC LETHO PATTERN WOVEN JACQUARD TO BE USED WITH FORD WSS-M99P1111-A 《LETHO图案的提花机织织物 与标准FORD WSS-M99P1111-A一起使用 》.pdf

1、 ENGINEERING MATERIAL SPECIFICATION Material Name Specification Number Date Action Revisions 2008 12 03 N-STATUS No Replacement L. Schmalz, FNA / M. Montgomery, FOE 2003 02 24 Revised Para 3.0 inserted ; Para 3.1, 3.2, 3.3, 3.10, 3.11 4 deleted 1998 03 25 Activated N.J. Komatsu Printed copies are un

2、controlled Page 1 of 2 Copyright 2008, Ford Global Technologies, Inc. FABRIC, LETHO PATTERN, WOVEN JACQUARD WSS-M1H781-A NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a woven jacquard polyester face fabric. 2. APPLICATION This specification was released origina

3、lly for material used as an interior trim fabric for the MAZDA 121/GLX/Europe. 3. REQUIREMENTS In addition to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A2/A3/A4. 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must

4、 conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.4 FABRIC CONSTRUCTION 3.4.1 Fabric Count, +/- 5 % tolerance (ASTM D 3775) Warp 270 ends/10 cm Weft 260 picks/10 cm 3.4.2 Fabric Weight, range (FLTM BN 106-01) 330 - 370 g/m23.5 COMPOSITION (ASTM D 629) Fabric

5、 100 % polyester ENGINEERING MATERIAL SPECIFICATION WSS-M1H781-A Page 2 of 2 Copyright 2008, Ford Global Technologies, Inc. 3.6 YARN CONSTRUCTION (ASTM D 1244) Warp 540 dtex f128 (PES, semi-dull, round, air texturized) Weft 730 dtex f144 (PES, bright, trilobal air texturized) -only in 750 dtex f192

6、Truffle (PES, semi-dull, round, air texturized) 3/810 dtex f72 x 3 (PES, bright, trilobal, twist yarn) -only in 830 dtex, f256 Dark Graphite (PES, semidull, round, air texturized) 3/570 dtex, f30 x 3 (PES, bright, trilobal, twist yarn) 3.7 METHOD OF DYEING Yarn dyed or as approved by Materials Engin

7、eering 3.8 FINISHED OPERATIONS As approved by Materials Engineering 3.9 FLAMMABILITY (ISO 3795/SAE J369) Burn Rate, max 100 mm/minute Note: Not required on face fabric when used as a fully bonded composite. 5. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification: 5.1 Purchase departments will ensure that both materials defined in this specification and shipped to any one assembly plant will be produced by one supplier only.