FORD WSS-M1H794-A-2008 FABRIC BARNABY PATTERN KNITTED UNLAMINATED TO BE USED WITH FORD WSS-M99P1111-A 《BARNABY图案的不分层经编针织织物 与标准FORD WSS-M99P1111-A一起使用 》.pdf

1、 ENGINEERING MATERIAL SPECIFICATION Material Name Specification Number Date Action Revisions 2008 12 03 N-STATUS No Replacement L. Schmalz, FNA / M. Montgomery, FOE2003 02 21 Revised Para 3.0 inserted ; Para 3.1, 3.2, 3.3, 3.10, 3.11, 4 deleted 1998 07 21 Activated N.J. KomatPrinted copies are uncon

2、trolled Page 1 of 2 Copyright 2008, Ford Global Technologies, Inc. FABRIC, BARNABY PATTERN, KNITTED, UNLAMINATED WSS-M1H794-A NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a 6 bar - 44 gauge DNB knitted, polyester face fabric. 2. APPLICATION This specification

3、was released originally for material used as an interior trim fabric for India. 3. REQUIREMENTS In addition to the requirements listed herein, the fabric shall met all requirements of WSS-M8P18-A1/A2/A3/A4 as applicable. 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part

4、producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.4 FABRIC CONSTRUCTION 3.4.1 Fabric Count, +/- 10 % tolerance (ASTM D387) Wales 90 Wales/10 cm Courses 120 Courses/ 10 cm 3.4.2 Fabric Weight, 290 - 370 g/m2(FLTM BN 106-01) 3.5 COMPOSITION (ASTM

5、 D 629) Fabric 100 % polyester ENGINEERING MATERIAL SPECIFICATION WSS-M1H794-A Page 2 of 2 Copyright 2008, Ford Global Technologies, Inc. 3.6 YARN CONSTRUCTION (ASTM D 1244) No. 1 Bar/No. 6 Bar 76 dtex f 24 (polyester, flat) No. 2 Bar/No. 5 Bar 100 dtex f 36 (polyester, flat) No. 3 Bar/No. 4 Bar 240

6、 dtex f 72 (polyester, false twist) 3.7 METHOD OF DYEING Yarn dyed and spun or as aprovebyMaterials Engineering 3.8 FINISHED OPERATIONS As approved by Materials Engineering 3.9 FLAMMABILITY (ISO 3795/SAE J369) Burn Rate, max 100 mm/minute Note: Not required on face fabric when used as a fully bonded

7、 composite. 5. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification 5.1 Purchase departments will ensure that both materials defined in this specification and shipped to any one assembly plant will be produced by one supplier only.