FORD WSS-M1H806-A-2008 FABRIC BONSAI PATTERN WOVEN JACQUARD UNLAMINATED TO BE USED WITH FORD WSS-M99P1111-A 《盆景（BONSAI）图案的不分层提花机织织物 与标准FORD WSS-M99P1111-A一起使用 》.pdf

1、 ENGINEERING MATERIAL SPECIFICATION Material Name Specification Number Date Action Revisions 2008 12 03 N-STATUS No Replacement L. Schmalz, FNA / M. Montgomery, FOE2003 04 23 Revised Para 3.0 inserted; Para 3.1,3.2, 3.3, 3.10, 3.11, 4 deleted 1999 04 20 Activated N. J. Komatsu Printed copies are unc

2、ontrolled Page 1 of 2 Copyright 2008, Ford Global Technologies, Inc. FABRIC, BONSAI PATTERN WOVEN JACQUARD, WSS-M1H806-A UNLAMINATED NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a woven jacquard polyester face fabric. 2. APPLICATION This specification was rele

3、ased originally for material used as an interior trim fabric for 1999 Model Year. 3. REQUIREMENTS In addition to the requirements listed herein, the fabric shall met all requirements of WSS-M8P18-A1/A2/A3/A4 as applicable. 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and par

4、t producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.4 FABRIC CONSTRUCTION 3.4.1 Fabric Count, +/- 5% tolerance (ASTM D 3775) Warp 280 ends/10 cm Weft 154 picks/10 cm 3.4.2 Fabric Weight, range (FLTM BN 106-01) 265 - 305 g/m23.5 COMPOSITION (AST

5、M D 629) Fabric 100% polyester ENGINEERING MATERIAL SPECIFICATION WSS-M1H806-A Page 2 of 2 Copyright 2008, Ford Global Technologies, Inc. 3.6 YARN CONSTRUCTION (ASTM D 1244) Warp 540 dtex f128 (Polyester, semi-dull, round, air texturised) Weft 740 dtex f224 (Polyester, semi-dull round, air texturise

6、d) 3.7 METHOD OF DYEING Yarn dyed and spun or as approved by Materials Engineering 3.8 FINISHED OPERATIONS As approved by Materials Engineering 3.9 FLAMMABILITY (ISO 3795/SAE J369) Burn Rate, max 100 mm/minute Note: Not required on face fabric when used as a fully bonded composite. 5. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification 5.1 Purchase departments will ensure that both materials defined in this specification and shipped to any one assembly plant will be produced by one supplier only.