FORD WSS-M1H836-A-2008 FABRIC DIAMOND II PATTERN WOVEN JACQUARD TO BE USED WITH FORD WSS-M99P1111-A 《DIAMOND II图案的提花机织织物 与标准FORD WSS-M99P1111-A一起使用 》.pdf

1、 ENGINEERING MATERIAL SPECIFICATION Material Name Specification Number Date Action Revisions 2008 12 17 N-STATUS No Replacement B. Haggart, FNA 2003 03 17 Revised Para 3.0 inserted ; Para 3.4 revised ; Para 3.1, 3.2, 3.3, 3.11, 3.12, 4 deleted2000 05 30 Activated Yvonne Bankowski Printed copies are

2、uncontrolled Page 1 of 2 Copyright 2008, Ford Global Technologies, Inc. FABRIC, DIAMOND II PATTERN, WOVEN JACQUARD WSS-M1H836-A NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a Jacquard pattern flat woven body cloth of good quality and uniform composition. 2. AP

3、PLICATION This specification was released originally for material used as an interior trim fabric for 2001 Cougar insert. The fabric used is backcoated and unlaminated. 3. REQUIREMENTS In addition, to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A4 as applic

4、able. 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.4 FABRIC CONSTRUCTION 3.4.1 Fabric Count, +/- 5 % tolerance (ASTM D 3775) Warp 175 warp/10 cm Fill 126 fill/1

5、0 cm 3.4.2 Fabric Weight, range, g/m2(FLTM BN 106-01) Laminated Face with Backcoat N/A 284.2 - 343.2 ENGINEERING MATERIAL SPECIFICATION WSS-M1H836-A Page 2 of 2 Copyright 2008, Ford Global Technologies, Inc. 3.5 COMPOSITION (ASTM D 629) Tolerance as specified in WSS-M8P18-A1/A4 Fabric 100 % Polyeste

6、r Backoating Acrylic 3.6 YARN CONSTRUCTION (ASTM D 1244) Warp 802 dtex, f200 (polyester, air textured) Fill 802 dtex, f200 (polyester, air textured) 3.7 METHOD OF DYEING Yarn Dye, Package Dye 3.8 FINISHING OPERATIONS Needle, Coat, Sigma 3.9 STRETCH & SET Warp Fill (SAE J855) Stretch, %, min 3.0 3.0

7、Set, %, max 0.3 1.0 3.10 FLAMMABILITY (ISO 3795/SAE J369) Burn Rate, max 100 mm/minute Note: Not required on face fabric when used as a fully bonded composite. 5. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. 5.1 Purchase departments will ensure that both materials defined in this specification and shipped to any one assembly plant will be produced by one supplier only.