FORD WSS-M1H854-A-2008 FABRIC TVER CLASSIQUE PATTERN DOBBY WOVEN UNLAMINATED TO BE USED WITH FORD WSS-M99P1111-A 《特维尔粗平布图案的不分层多臂提花机织织物 与标准FORD WSS-M99P1111-A一起使用 》.pdf

1、 ENGINEERING MATERIAL SPECIFICATION Material Name Specification Number Date Action Revisions 2008 12 04 N-STATUS No Replacement L. Schmalz, FNA / M. Montgomery, FOE2003 03 28 Revised Para 3.0 inserted ; Para 3.1, 3.2, 3.3, 3.10, 3.11, 4 deleted 2001 04 30 Activated N. Komatsu Printed copies are unco

2、ntrolled Page 1 of 2 Copyright 2008, Ford Global Technologies, Inc. FABRIC, TVER CLASSIQUE PATTERN, DOBBY WOVEN, WSS-M1H854-A UNLAMINATED NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a dobby woven polyester face fabric. 2. APPLICATION This specification was or

3、iginally released for material used as an interior trim fabric for Russia, Model Year 2002. 3. REQUIREMENTS In addition to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A2/A3/A4 as applicable. Material specification requirements are to be used for initial qua

4、lification of materials. 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.4 FABRIC CONSTRUCTION 3.4.1 Fabric Count, +/- 10 % tolerance (ASTM D 3775) Warp 136 ends/1

5、0cm Weft 140 picks/10cm 3.4.2 Fabric Weight, +/- 10 % tolerance 240 g/m (FLTM BN 106-01) 3.5 COMPOSITION (ASTM D 629) Fabric 100 % polyester ENGINEERING MATERIAL SPECIFICATION WSS-M1H854-A Page 2 of 2 Copyright 2008, Ford Global Technologies, Inc. 3.6 YARN CONSTRUCTION (ASTM D 1244) Warp 800 dtex f

6、210 (Polyester, airtexturidsem-dul, round) Weft 800 dtex f 210 (Polyester, airtexturidsem-dul, round) 3.7 METHOD OF DYEING Solution dyed or as approved by Materials Engineering 3.8 FINISHED OPERATIONS As approved by Materials Engineering 3.9 FLAMMABILITY (ISO 3795/SAE J369) Burn rate, max 100 mm/min

7、ute Note: Not required on face fabric when used as a fully bonded composite. 5. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. 5.1 Purchase departments will ensure that both materials defined in this specification and shipped to any one assembly plant will be produced by one supplier only.