FORD WSS-M1H869-A-2008 FABRIC CHARISMA PATTERN WOVEN JACQUARD UNLAMINATED TO BE USED WITH FORD WSS-M99P1111-A 《CHARISMA图案的不分层提花机织织物 与标准FORD WSS-M99P1111-A一起使用 》.pdf

1、 ENGINEERING MATERIAL SPECIFICATION Material Name Specification Number Date Action Revisions 2008 12 05 N-STATUS No Replacement L. Schmalz, FNA / M. Montgomery, FOE 2003 04 17 Revised Para 3.0 inserted; Para 3.1, 3.2, 3.3, 3.10, 3.11, 4 deleted 2001 09 27 Activated N. J. Komatsu Printed copies are u

2、ncontrolled Page 1 of 2 Copyright 2008, Ford Global Technologies, Inc. FABRIC, CHARISMA PATTERN, WOVEN JACQUARD, WSS-M1H869-A UNLAMINATED NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a woven jacquard polyester face fabric. 2. APPLICATION This specification was

3、 released originally for material used as an interior trim fabric for use in the 2003 model year. 3. REQUIREMENTS In addition to the requirements listed herein, the fabric shall meet all requirements of WSSM8P18-A1/A2/A3/A4 as applicable. Material specification requirements are to be used for initia

4、l qualification of materials. 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.4 FABRIC CONSTRUCTION 3.4.1 Fabric Count, +/- 5 % tolerance (ASTM D 3775) Warp 343 en

5、ds/10 cm Weft 160 picks/10 cm 3.4.2 Fabric Weight, range (FLTM BN 106-01) 285 - 325 g/m23.5 COMPOSITION (ASTM D 629) Fabric 100% Polyester 3.6 YARN CONSTRUCTION (ASTM D 1244) Warp 540 dtex f128 (air texturised, semi-dull, round) Weft 540 dtex f144 (air texturised, bright, trilobal) ENGINEERING MATER

6、IAL SPECIFICATION Material Name WSS-M1H869-A Printed copies are uncontrolled Page 2 of 2 Copyright 2008, Ford Global Technologies, Inc. 3.7 METHOD OF DYEING Yarn dyed or as approved by Materials Engineering 3.8 FINISHED OPERATIONS As approved by Materials Engineering 3.9 FLAMMABILITY (ISO 3795/SAE J

7、369) Burn Rate, max 100 mm/minute Note: Not required on face fabric when used as a fully bonded composite. 5. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. 5.1 Purchase departments will ensure that both materials defined in this specification and shipped to any one assembly plant will be produced by one supplier only.