GMKOREA EDS-T-3503-2008 GLAZING OF VECHICLE.pdf

1、GM DAEWOO Auto 1 individual defect 0.8 mm2 2 locations of defect 0.5 mm2 3 location of defect 0.35 mm2 Individual defects of size 0.1 mm2 are accepted. 2.2.1.3 Defect in the glass Defect in the glass (scratch or edge injury) are not permissible 2.2.2. Covered area EDS-T-3503GLAZING OF VECHICLE PAGE:

2、 23/25 ISSUED DATE: 1992. 05. 02 REVISED DATE: 2008. 10. 23 VERSION: 3 GM DAEWOO Auto measuring point in the center of the stressed range, lined-up on max. transmission. 2.4. Determination of color and transmittance The determination of the chromatic-tone-equal wave-length and transmittance is condu

3、cted according to part 1, cl. 6.8 of these technical delivery conditions. 2.4.1. Color The chromatic-tone-equal wave length of the transmitted light must amount to 570 nm on the whole area. 2.4.2. The glass roof must have following transmittance on the whole area useful for the inspection; light tra

4、nsmittance (102)% IR-transmittance 6% max. radiant transmittance 8% max. 2.5. Test at waviness The glasses for sun-roof may not have any waviness which cause strong distortions on the top view of roof. The glasses are tested according to following method: with a projector (according to ECE-R43, cl.

5、9.2.1.2.1), a screen slide AZ is projected according to DIN 52 350 from 4 m distance on a device, in which a mirror of about same size as the glass to be tested in found. The center of the mirror lying horizontally in the device should be found in center of objective. The mirror is bent with the dev

6、ice by 20against the vertical. In 1 m distance from the mirror, a white area (measurement minimum (0.6 x 1.25)m) bent likewise by 20against the vertical. The objective is adjusted so that the black screen lines are sharply illustrated on the white area. Instead of the mirror, the sample to be tested

7、 is replaced so that the outside of glass is turned of the projector. EDS-T-3503GLAZING OF VECHICLE PAGE: 25/25 ISSUED DATE: 1992. 05. 02 REVISED DATE: 2008. 10. 23 VERSION: 3 GM DAEWOO Auto & Technology 2.5.1. Requirements 2.5.1.1 All black lines must be distinguishable. 2.5.1.2 The width of the black lines must amount to 4 to 15 mm.