HOLDEN HN 2383-2002 ADHESIVE - STRUCTURAL - TWO-PART《粘接剂 双组分结构类》.pdf

1、A.C.N. 006 893 232Holden LimitedEngineering DepartmentMATERIAL SPECIFICATIONNUMBERSHEETRELEASEREVISION:HN 23831 of 2May, 2002NAME: ADHESIVE- STRUCTURALTWO-PARTTHIS DOCUMENT MUST NOT BE REPRODUCED. IF USED IN RELATION TOTHE COMPANYS PRODUCTS THE RECIPIENT IS RESPONSIBLE TO CONFIRMTHE DOCUMENT ISSUE D

2、ATE IS STILL VALID.FORM : I:CentralLaboratoryStandardFormsMaterialSpecificationmatspec.doc1. SCOPEThis specification outlines the requirements of a two-part chemically cross-linking,rubber toughened, acrylic structural adhesive. This rubber toughened/polymethacrylate adhesive may be used for applica

3、tions such as bondingaluminium components used in the construction of luggage carrier rails.2. REFERENCESGMW 3059 HN1000 ASTM D1876 ASTM D10023. REQUIREMENTS3.1 See Table 1Specific Requirement ResultChemical type Elastomer/methyacrylateSpecific gravity 25C 1.04 (Part A), 1.06 (Part B),Viscosity 25C,

4、 mPa.s (cP)Brookfield RVT Spindle 4 20rpm(DIN 54453), MV-D=36 1/S after180s2300 to 4200 (Part A)2300 to 4200 (Part B)Flash point (COC), C 70 (Part A)70 (Part B)Peel strength (ASTM D1876)(grit blasted aluminium) 0.5 N/mm minShear strength(grit blasted mild steel)(ASTM D1002)8.0 MPa minTable 14. APPRO

5、VAL, INSPECTION AND REJECTIONRefer HN 1000, Clauses A and C.A.C.N. 006 893 232Holden LimitedEngineering DepartmentMATERIAL SPECIFICATIONNUMBERSHEETRELEASEREVISION:HN 23832 of 2May, 2002NAME: ADHESIVE- STRUCTURALTWO-PARTTHIS DOCUMENT MUST NOT BE REPRODUCED. IF USED IN RELATION TOTHE COMPANYS PRODUCTS

6、 THE RECIPIENT IS RESPONSIBLE TO CONFIRMTHE DOCUMENT ISSUE DATE IS STILL VALID.FORM : I:CentralLaboratoryStandardFormsMaterialSpecificationmatspec.doc5. HAZARDOUS MATERIALSRefer HN 1000, Clause H.6. RESTRICTED CHEMICALSRefer HN 1000, Clause J.7. APPROVED SUPPLIERS AND MATERIALSAPPROVED SUPPLIER APPROVED MATERIALLoctite Loctite 3271 A/BPrepared by : Mark Franke