INTERN CEMS BT-31-2009 Volatile Matter Test《挥发性物质的试验》.pdf

1、 This document is restricted and may not be sent outside Navistar, Inc. or reproduced without permission from Corporate Technical Standards. Suppliers are required to assume all patent liability. 2009 by Navistar, Inc. AUGUST 2009 Page 1 of 1 NAVISTAR, INC. CEMS (CORPORATE ENGINEERING MATERIAL SPECI

2、FICATION) NUMBER: CEMS BT-31 TITLE: Volatile Matter Test Adapted from ORD JR-OME PD #115 dated 21 November 1956. CURRENT ISSUE DATE: August 2009 WRITTEN/REVIEWED BY: Materials Engineering APPROVED BY: Materials Engineering SUPERSEDES ISSUE OF: October 2001 PRINTED COPIES OF THIS DOCUMENT MUST BE VER

3、IFIED FOR CURRENT REVISION This specification may involve hazardous materials, equipment, and procedures. This specification does not purport to address all of the safety issues associated with its use. The user is responsible to consult appropriate safety and health practices and to determine the a

4、pplicability of regulatory limits prior to use. Change Notice: Replaced “International Truck and Engine Corporation” with “Navistar, Inc.” per corporate directive. 1.0 APPLICATION This method covers a procedure for determining evaporation loss in a product such as engine cooling system stopleak comp

5、ound. 2.0 SCOPE This specification describes the test method 3.0 APPARATUS 3.1 Balance with a sensitivity of 0.1 gram 3.2 Gravity-convection oven capable of maintaining 212 + 2 degrees Fahrenheit 3.3 Desiccator 3.4 Petri dish, approximately 100 millimeters in diameter and 15 millimeters in depth 4.0

6、 PROCEDURE 4.1 Weigh the Petri dish to the nearest 0.1 gram. 4.2 Place approximately 20 grams of sample into the dish and weigh sample and dish to the nearest 0.1 gram. 4.3 Set the dish into the gravity-convection oven maintained at 212 + 2 degrees Fahrenheit and heat for 48 hours. 4.4 At the end of

7、 the 48-hour period remove the dish from the oven, place in a desiccator, and allow to cool to room temperature. 4.5 Weigh the dish and its contents to the nearest 0.1 gram. 5.0 REPORT 5.1 Calculate the volatile matter as follows: % Volatile matter = (A-B) 100S where A = weight of dish and sample in

8、 grams B = weight of dish and residue in grams S = weight of sample in grams REPORT THE VALUE OBTAINED AS “VOLATILE MATTER, % BY WEIGHT”. Copyright Navistar International Corporation Provided by IHS under license with INTERNNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-