ISA TR12 13 02-1999 Investigation of Fire and Explosion Accidents in the Fuel-Related Industries C A Manual by Kuchta《燃油相关工业中火灾和爆炸事故的调查(Kuchta编制的手册)》.pdf

1、 TECHNICAL REPORT ANSI/ISA-TR12.13.02-1999 (R2013) ANSI Technical Report prepared by ISA Investigation of Fire and Explosion Accidents in the Fuel-Related Industries A Manual by Kuchta Reaffirmed Copyright 2013 by ISA. All rights reserved. Printed in the United States of America. No part of this pub

2、lication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means (electronic, mechanical, photocopying, recording, or otherwise), without the prior written permission of the Publisher.ISA67 Alexander DriveP.O. Box 12277Research Triangle Park, North Carolina 27709

3、ANSI/ISATR12.13.021999 (R2013)Investigation of Fire and Explosion Accidents in the Chemical, Mining, and Fuel-Related Industries A Manual by KuchtaISBN: 3 ANSI/ISA-TR12.13.02-1999 (R2013) Preface This preface, as well as all footnotes and annexes, is included for information purposes and is not part

4、 of ANSI/ISA-TR12.13.02-1999 (R2013). This document has been prepared as part of the service of ISA towards a goal of uniformity in the field of instrumentation. To be of real value, this document should not be static but should be subject to periodic review. Toward this end, the Society welcomes al

5、l comments and criticisms and asks that they be addressed to the Secretary, Standards and Practices Board; ISA; 67 Alexander Drive; P. O. Box 12277; Research Triangle Park, NC 27709; Telephone (919) 549-8411; Fax (919) 549-8288; E-mail: standardsisa.org. The ISA Standards and Practices Department is

6、 aware of the growing need for attention to the metric system of units in general, and the International System of Units (SI) in particular, in the preparation of instrumentation standards. The Department is further aware of the benefits to USA users of ISA standards of incorporating suitable refere

7、nces to the SI (and the metric system) in their business and professional dealings with other countries. Toward this end, this Department will endeavor to introduce SI-acceptable metric units in all new and revised standards, recommended practices, and technical reports to the greatest extent possib

8、le. Standard for Use of the International System of Units (SI): The Modern Metric System, published by the American Society for Testing ISA; 67 Alexander Drive; P. O. Box 12277; Research Triangle Park, NC 27709. As a service to industry, the accompanying document, Bureau of Mines Bulletin 680 - Inve

9、stigation of Fire and Explosion Accidents in the Chemical, Mining, and Fuel-Related Industries - A Manual, by Kuchta, 1985, is hereby reprinted in its entirety. This compendium, formerly available from the U.S. Bureau of Mines, contains information essential to an understanding of detection, measure

10、ment, and handling of flammable gases and vapors. For further information, refer to ANSI/ISA-TR12.13.01. ABSTRACT This technical report includes theoretical and practical work carried out and collected by the U.S. Bureau of Mines relating to ignitability, flammability and physicochemical properties

11、of flammable gas mixtures, liquids, and solids. While emphasis of this document is on investigation of fires and explosions, a significant amount of theoretical & practical data related to flammability limits, under varying conditions of proportion, temperature and pressure is included. KEY WORDS Fi

12、re Explosion Flammability limits Flammable Combustible LEL, UEL LFL, UFL Gas This page intentionally left blank. 13 ANSI/ISA-TR12.13.02-1999 (R2013)Appendix IThe following document, Investigation of Fire and Explosion Accidents in the Chemical, Mining, and Fuel-Related Industries - A Manual by Kuchta, is reprinted in its entirety by permission of the publisher, the Bureau of Mines, U.S. Department of the Interior.