ITU-T Q 617-1993 Interworking of Signalling Systems - Logic Procedures for Incoming Signalling System No 7 (ISUP) (Study Group XI) 20 pp《信号系统的交互工作-7号向内信号系统的逻辑程序》.pdf

1、ITU-T RECMN*Q.b37 93 4862593 0589333 675 INTERNATIONAL TELECOMMUNICATION UNION ITU-T TELECOMMUNICATION STANDARDIZATION SECTOR OF ITU INTERWORKING OF SIGNALLING SYSTEMS Q.617 (03/93) INTERWORKING OF SIGNALLING SYSTEMS - LOGIC PROCEDURES FOR INCOMING SIGNALLING SYSTEM No. 7 (ISUP) ITU-T Recommendation

2、 Q.617 (Previously “CCIlT Recommendation”) ITU-T RECMN*Q-bb7 73 m 48b259L 0589LL2 501 m FOREWORD The ITU Telecommunication Standardization Sector (IT-T) is a permanent organ of the International Telecom- munication Union. The ITU-T is responsible for studying technical, operating and tariff question

3、s and issuing Recommendations on them with a view to standardizing telecommunications on a worldwide basis. The World Telecommunication Standardization Conference (WTSC), which meets every four years, established the topics for study by the ITU-T Study Groups which, in their turn, produce Recommenda

4、tions on these topics. ITU-T Recommendation Q.617 was prepared by the ITU-T Study Group XI (1988-1993) and was approved by the WTSC (Helsinki, March 1-12, 1993). NOTES 1 As a consequence of a reform process within the International Telecommunication Union (ITU), the CCITT ceased to exist as of 28 Fe

5、bruary 1993. In its place, the ITU Telecommunication Standardization Sector (ITU-T) was created as of 1 March 1993. Similarly, in this reform process, the CCIR and the IFRB have been replaced by the Radiocommunication Sector. In order not to delay publication of this Recommendation, no change has be

6、en made in the text to references containing the acronyms “CC, CCIR or IFRB” or their associated entities such as Plenary Assembly, Secretariat, etc. Future editions of this Recommendation will contain the proper terminology related to the new ITU structure. 2 telecommunication administration and a

7、recognized operating agency. In this Recommendation, the expression “Administration” is used for conciseness to indicate both a O ITU 1994 All rights reserved. No part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and

8、microfilm, without permission in writing from the IT. Recommendation 4.617 INTERWORKING OF SIGNALLING SYSTEMS - LOGIC PROCEDURES FOR INCOMING SIGNALLING SYSTEM No. 7 (ISUP) (Helsinki, 1993) State nunber State 8sctkm Sheetreference Ttnarrmhg O0 o1 02 o3 o4 o5 o6 o8 o9 10 Idle Wait for further digits

9、Wait for COT Wait for further digits; COT received Wait for digit analysis; COT received Wait for address complete Address complete; Wait for answer Wait for RLC Answered wait for digit anaiysiffi 1,13,16 2 5 8 3 4 10 15 13 16 FIGURE UQ.617 State overview diagram for incoming Signaiiing System No. 7

10、 (ISUP) Recommendation Q.617 (03193) 1 ITU-T RECMN+Q=bL7 73 m 48b257L 0589LL4 384 m Supervisory timers for incoming Signalling System No. 7 (ISUP) ti = 10- 15 s t2=15-20s Waiting for address signal t3 = 20 - 30 s tS = 1 minute t7=4-15 Waiting for continuity Waiting for Address Complete signal Stop r

11、epeat sending of Release on t7 timeout Waiting for Release Complete release Information contents of FITEs and BITES For the information contents of the following FITES and BITES see the contents of the corresponding messages in Recommendation Q.763: FITE A BITE 41 BITE 48 Connect message (CON) BITE

12、X BITE Y Answer Message (ANM) Initiai Address Message (IAM) Call Progress message (CPG) Address Complete Message (ACM) Procedures not shown Procedures related to the following messages are not shown in the logic procedures because of no relevancy for interworking or no usage defined yet: BLO CGU FRJ

13、 UBA BLA CGUA GRA UBL CCR CQM GRS UCIC CFN CQR LPA USR CGB FAA OLM CGBA FAR RSC Indicated fault procedures Pl (State 01,02,03) P2 (State 02,05) Procedure for test-call Procedure for continuity recheck incoming FIGURE 2lQ.617 Notes to incoming Signalling System No. 7 (ISUP) 2 Recommendation Q.617 (M3

14、) 19 6 1 io, 2 ITU-T RECHN*Q.b17 93 q862593 O589335 230 SPITE 1 register function 1 7 SPITE 32 Inseri check I- SPITE 37 Analyse and store service requests 1 I 2 0 SPITE 34 Remow check )oq, I* I- l RIC FIGURE 3/Q.617 (sheet 1 of 16) Incoming Signalling System No. 7 (ISUP) SPITE 3 Deactivate (e) Recom

15、mendation Q.617 (03/93) 3 + c ITU-T RECMN+Q=b17 93 48b2591 0589Llb 157 R Q a- r $! a- 4 w- N Recommendation 4.617 (0-3) 3 9 6 5 3,8 further digits COT receid b SPITE 12 Perfm dgi No analysis for service required I FIGURE 3/Q.617 (sheet 3 of 16) Incoming Signalling System No. 7 (ISUP) UT1 14126-Wd4 1

16、1 Recommendation Q.617 (03193) 5 ITU-T RECMN*Q-b17 93 m 4862591 0589118 T2T m 0- a ci m- a) 6 m m m u) a- m- rc a) Recommendation Q.617 (OY93) 2 A 10,ll 7, 11 2 SPITE 52 Construct call set up r- info message FIGURE 3/Q.617 (sheet 5 of 16) Incoming Signalling System No. 7 (ISUP) Recommendation Q.617

17、(0-3) 7 ITU-T RECMN*Q-b37 93 48b2.591 0589320 688 SPITE 15 Unallocaied SPITES 16, 17 SPITE 18 SPITE 19 No. A, B 4, 12,12 Pi, 8 Bearer capability not probided n I SPITE 54 (Cause 1) REL ti I I I 1 SPITE 54 SPITE 54 SPITE 54 SPITE 54 (Cause 3) (Cause 42) (Cause 34) (Cause 65) I SPITE 35 1 R-ghwk SPITE

18、 34 Remo- check IOOP o SPITE 3 register function o7 FIGURE 3/Q.617 (sheet 6 of 16) Incoming Signalling System No. 7 (ISUP) 8 Recommendation Q.617 (03/93) 7, 15 p2 5 14,13 4,5 o “ intenivorking 6 o FIGURE 314.617 (sheet 7 of 16) Incoming Signalling System No. 7 (ISUP) Recommendation Q.617 (03/93) 9 1

19、4 D 21 4,l: 13 14 SPITE 34 -i FITE 24 D O,. Start tp D -. me dgits? (I o, NOTE - Is outgoing link common channel signalling system? FIGURE 3/Q.617 (sheet 8 of 16) incoming Signalling System No. 7 (ISUP) T114 13092/dO9 10 Recommendation Q.617 (03/93) D 11 12 24 ITU-T RECMNtQmb17 93 = 4862591 0589123

20、397 9 FITE Z 8 FITE Z 1 SPITE 54 1 SPITE 3 01 3 FIGURE 3jQ.617 (sheet 9 of 16) Incoming Signalling System No. 7 (ISUP) Recommendation 4.617 (03/93) 11 ITU-T RECMN*Q=bL7 93 4862571 0589324 223 m SAM BITE 30 13 F 13 22 13 BITE 48 SPITE 4A Speech path may be set up D FITE 1 digits? T1130460-91/dll NOTE

21、 - Is outgoing link common channel signalling system? FIGURE 3/Q.617 (sheet 10 of 16) Incoming Signalling System No. 7 (ISUP) 12 Recommendation Q.617 (03/93) ITU-T RECMN*Q-b17 93 48b2591 0589125 LbT W REL BITE X - - t2 t3 SPITE 3 register function ACM set up? FITE Z FITE Z SPITE 4 StCQ f2 0, - SPITE

22、 54 Cause 31 stop t2 FIGURE 314.617 (sheet 11 of 16) Incoming Signalling System No. 7 (ISUP) stop t3 o, SPITE 3 stop t3 T1141320Wd12 Recommendation Q.417 (03D3) 13 ITU-T RECMN*Q=617 73 4862593 058912b OTb W C 24 BITE Z a SPITE 3 Deactivate register function SPITE 5 conditions releasespeech 1 1 FIGUR

23、E 3/Q.617 (sheet 12 of 16) incoming Signalling System No. 7 (ISUP) 14 Recommendation Q.617 (03/93) ITU-T RECMN*Q*b37 93 4862593 0589327 T32 ALC I - - t7 t5 SPiTE 34 Remow check 2,3,4,7, 11, 14, 16,15 REL I I start t5 I (7) Waitfa Recommendation Q.617 (03/93) 15 17 22.18 17,17 I o 11.14 compl FITE 23

24、 14 14 T113049SQl Id1 5 FIGURE 3/Q.617 (sheet 14 of 16) Incoming Signalling System No. (ISUP) 16 Recommendation Q.617 (03193) 2: H 18,2i 22, z I ITU-T RECMN*Q-b37 93 = 48b2593 0589329 805 10,14,15 (a), 16 o Answered 1 ?iiiiqF equipment FIGURE 3/Q.617 (sheet 15 of 16) incoming Signalling System No. 7 (ISUP) Tl14134GWd16 Recommendation Q.617 (03/93) 17 H 22 ITU-T RECMN*Q=bL7 93 48b259L D589L30 527 m BITE 39 (user) 6, (user) FITE 34 m FITE 35 0 i FOT FITE 23 T1141350-93/d17 OI5 FIGURE 3/Q.617 (sheet 16 of 16) Incoming Signalling System No. 7 (ISUP) 18 Recommendation Q.617 (03193)