NAVISTAR CEMS A-6 PART I-2011 Low Carbon Steel Flat Rolled and Structural Shapes (Includes Appendix).pdf

1、This document is restricted and may not be sent outside Navistar, Inc. or reproduced without permission from Corporate Technical Standards. Suppliers are required to assume all patent liability. 2014 by Navistar, Inc. FEBRUARY 2014 Page 1 of 1 NAVISTAR, INC. CEMS (CORPORATE ENGINEERING MATERIAL SPEC

2、IFICATION) NUMBER: CEMS A-6, PART I TITLE: Low Carbon Steel, Flat Rolled and Structural Shapes CURRENT ISSUE DATE: February 2014 WRITTEN/REVIEWED BY: Materials Engineering APPROVED BY: Materials Engineering SUPERSEDES ISSUE OF: February 2011 PRINTED COPIES OF THIS DOCUMENT MUST BE VERIFIED FOR CURRE

3、NT REVISION This specification may involve hazardous materials, equipment, and procedures. This specification does not purport to address all of the safety issues associated with its use. The user is responsible to consult appropriate safety and health practices and to determine the applicability of

4、 regulatory limits prior to use. Change Notice: Made VOID. This specification is VOID, and has been replaced by MPAPS A-6 Part I. For questions, contact MaterialsEngineeringN VOID This document is restricted and may not be sent outside Navistar, Inc. or reproduced without permission from Corporate T

5、echnical Standards. Suppliers are required to assume all patent liability. 2014 by Navistar, Inc. FEBRUARY 2014 Page 1 of 1 NAVISTAR, INC. CEMS (CORPORATE ENGINEERING MATERIAL SPECIFICATION) NUMBER: CEMS A-6, PART I, APPX TITLE: Low Carbon Steel, Flat Rolled and Structural Shapes - APPENDIX CURRENT

6、ISSUE DATE: FEBRUARY 2014 WRITTEN/REVIEWED BY: Materials Engineering APPROVED BY: Materials Engineering SUPERSEDES ISSUE OF: FEBRUARY 2013 PRINTED COPIES OF THIS DOCUMENT MUST BE VERIFIED FOR CURRENT REVISION This specification may involve hazardous materials, equipment, and procedures. This specifi

7、cation does not purport to address all of the safety issues associated with its use. The user is responsible to consult appropriate safety and health practices and to determine the applicability of regulatory limits prior to use. Change Notice: Made VOID. changes. GENERAL INtorial Changes This specification is VOID, and has been replaced by MPAPS A-6 Part I APPENDIX For questions, contact MaterialsEngineeringN VOID