1、MIL-A-bo673 (I) I3 7777706 03i107bq 2 M Beneficial comments (recommendations, additions, deletions) and any pertinent data which may be of use in improving this document should be addressed to: Standardization Branch (5241), Indian Head, MD 20640-5000, by using the self-addressed Standardization Doc
2、ument Improvement Proposal (DD Form 1426) appearing at the end of the specification or by letter. Commanding Officer, Naval Ordnance Station, MIL-A-60693( OS) AMENDMENT 1 15 JULY 1986 _- MILITARY SPECIFICATION t ACTUATOR, EXPLOSIVE, ROTARY 1000-27 REMANUFACTURED METAL PARTS ASSEMBLY This amendment f
3、orms a part of Military Specification MIL-A-60693(MU), dated 26 April 1967, and is approved for use within the Naval Sea Systems Command, Department of the Navy, and is available for use by all Departments and Agencies of the Department of Defense PAGE 1 2.1 Delete “MIL-STD-639 Surface Roughness Val
4、ues Preferred for Army Ordnance Material I PAGE 2 Add: “2.2 Other publications. The following document forms a part of this specification to the extent specified herein. Unless otherwise specified, the issues of the document which are DOD adopted shall be those listed in the issue of the DODISS spec
5、ified in the solicitation. specified, the issues of documents not listed in the DODISS shall be the issue of the nongovernment documents which is current on the date of the solicitation. Unless otherwise Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-
6、,-: MIL-A-bOb73 (1) 13 m 777970b 03407b5 4 W MIL-A-60693(OS) AMENDMENT 1 15 JULY 1986 1 ANSI B46.1-78 Surface Texture (Surface Roughness, Waviness and Lay) (Application for copies should be addressed to the American National (Nongovernment standards and other pub1 ications are normally available Sta
7、ndards Insti tute (ANSI), 1430 Broadway, NY 10018.) from the organization which-prepares or which distributes the documents. These documents also may be available in or through libraries or other informational services. )II .PAGE 3 4.3.2, line 1, delete “The Ordnance Standard Finish Blocks prescribed in MIL-STD-639 .I and substitute “The roughness comparison standards prescribed in ANSI 46.1-78 . . .I. Preparing Activity: Navy - OS Project No. 1377-N823 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
copyright@ 2008-2019 麦多课文库(www.mydoc123.com)网站版权所有
备案/许可证编号:苏ICP备17064731号-1