NAVY MIL-C-18186 D (1)-1988 CROWNS SERVICE CAP《军帽加冕》.pdf

1、MIGC- 1 8 1 86D (MC) 19 May 198P -1 This anenmnt which fom a part of Military Specification MIGC-lBl6D(MC), dated 12 Septenber 1984, is approved for use by all Deparbnents and Agencies of the Department of Defense. Page 1 Paragraph 1.2 Line 5 add: “aVpe III-lyester/kol, Gabardine, Green 2212“ Page 2

2、 Paragraph 2.1 . 1 Under specifications-military add: “MIGC-10176 - Cloth, Gabardine , -1, Polyecter/bol“ Page 3 Paragraph 3.3.1 add: “(c) cloth, gabardine, polyester/wool, 10.6 ounce, green shade 2212, mnforming to type II, class 12 of MIM-10176“ k Page 4 Paraqraph 3.3.3 Line 5, 9, and 12 in table

3、UndeV polyester add “III“ Page 8 eration 5.b. add at end: “The bight of the overwe stitching shall be 3/16-inch. Operation 9.a. add at erd: “The bight of the overedge stitchina shall be 3/16-inch.“ Page 9 eration 9.b. Line 3 Delete “.“ after operation an insert “with a 1/4-inch seam. “ Page 12 I Par

4、agraph 3.8 Line% after-%ee“ add, R4.5.301n FSC 8405 Distribution Statenent A: Approved for public release; distribution is unlimited. Page 1 of 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-C- 1 8 1 86D ( W) Page 13 . I After paragraph 4.5.3,

5、 dd new paragraph: “4.5.3.1 Fit test. Crowns shall be fit tested against applicable cap frms in acax?GGXth shecue of crcm sizes kinq purchased, Rie following selected (*) .defects are sppli- cable to crams which improperly fit the mrrecpondinq size cap frane. Saarple cap franec required for this tes

6、t may be obtained fm the procurement acti- vity or as directed by the contracting officer. bead size - Crown size Defect: eadband of crown fitting frm tao loose causing fullness (wrinkles) on band or too tight not permitting crown to be fitted with- out distorting headband of frame. - Defect: Circun

7、ference of tw crown too mall, not permitting crown wire to lie snoothy or distorting crown or quarters affecting appearance. Adjustable crown wires may be adjusted in where necessary. - Defect: Circunference of tap cram too large, not providipg snug fit on crown Wire- or distorting quarters affectin

8、q appearance. Adjustable crown wires may be adjusted where neCeCCa*. Page 15 , Pareqraph 5.1.1 Line 2 after end, insert: “for tuck in closure or a heat seal& bag may be used as an alternate.“ Paqe 16 Paraqraph 5.3.1 Delete in its entirety. Reparing Activity Navy MC project No. 8345-r5076 Page 2 of 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-