NAVY MIL-STD-1320-217-1985 TRUCKLOADING MINE UNDERWATER MK 25 CONFIGURATION A IN CRATE MK 110 MOD 0《 MK 25构造水雷在MK 110 MOD 0的装车》.pdf

1、I - MIL-STD-1320 -237 83 W 9399933 0306320 5 WL e CONTAINER DATA MILITARY STANDARD M IL-STD-1320-2I7 TRUCKLOADING 1N CRATE MK 110 MOD O MINE, UNDERWATER MK 52 “Configuration A“ NINES PER COhTAINER I DIMENSIONS 102.5 L X 34.75 If 28.6 H GROSS WEIGHT 1730 LBSI TAAE WT. . 335 LBS CUBE 59 CU FT DOT HAZA

2、RD CLASSIFICATION - EXPL A 1 DO NOT USE FOR SHIPPING WT. NOTES : 1. 2. UNLESS OTHeRWISE SPECIFIED DIHENSIONS ARE IN INCHES. FOR CROSS REFERENCE TO ASSOCIATED TRUCKLOADING, CONTAINERUlbDING AND CARLOADING MILITARY STANDARDS. REFER TO INDEX TO ST-S. mL-HDBK-236 (HAW) AUTHORIZED AND RELEASED FOR HIGHWA

3、Y SHIPMENT (NAVY 1 13 SEPTEMBER 1985 217 (NAVY) GENERAL NOTES 1. 2, 3. 4. 5. 6. I. 6. 9. I TIIIS DOCUMENT GInS DETAILED INSTRUCTIONS FOR TRUCKLOADING THE UNDERWATER MINE MK 52 IN MINE CRATE, SHIPPING AND STORAGE MK 110 MOD O. FOR GENERAL TRUCKLOADING PROCEDURES REFER TO THE GENERAL TRUCKLOADING DOCU

4、MENT, MIL-STD-1520. THE PROCEDURES AND PRACTICES DESCRIBED HEREIN ARE INTENDED FOR 40 FT FLATBED TRAILERS WITH THE TRAILERS TANDEM AXLES LOCATED IN THE “HESTERN POSITION“ 1AT THE EXTREME REAR OF THE TRAILER). HITH METAL FLOORS. EACH STACK OF CONTAINBRS IS SECURBD TOGETHER WITH TWO 1 1/4 X -035 CROSS

5、 STRAPS. ANI) RETURN THROUGH THE FORK POCKETS OF THE CONTAINERS IKMEDIATELY BELOW THE TOP CONTAINERS. TENSION STRAPS AND SEAL WITH ONE 1 1/4 SEAL DOUBLE NOTCHED. BOTH CHAINS AND LOAD BINDERS AND STEEL STRAPS MAY BE USED FOR TIE DOWNS. PROTECTOK BOARDS MUST BE USED (DOUBLED 2 X 65) FOR BOTH CHAINS AN

6、D STRAPS. CHAINS, FITTINGS, LOAD BINDERS, AND ALL OTHER MATERIALS (UNLESS OTHERWISE SYECIFIEDJ SHALL MEET THE REQUIREMENTS OF THE BASIC TRUCKLOADING DOCUMENT, MIL-STD- 1320. PRIOR TO LOADING THE TRAILER AND DURING THB PRELOADING INSPECTION REQUIRED BY NAVSEA OP 2165 AND REPORTED ON DD FORM 626, THE

7、CHAINS, FITTING AND LOA0 BINDERS HAVE BEEN INSPECTED FOR STRETCH, GOUGING, BENT LINKS, WEAR AND ANY OTHBR NOTICMBLE DEFECTS. THE INSPECTOR SHALL CONFIRM HAT THE CHAINS AND LOAD BINDERS HAVE BEEN INSPECTED AND SHALL SO NOTE IN ITEM NO. 72 OF DD FORM 626. ANY DEFICIENCY SIiALL BE CAUSE FOR REJECTION O

8、F A CHAIN OR LOAD BINDER. THE MAXIMUM GROSS WEIGHT OF THE TRACTOR-TRAILER AND THE ALLOHABLE AXLE WEIGHTS AXE THE RESPONSIBILITY OF THE CARRIER. THE CARRIER HILL ADVISE THE SHIPPER OF THBSE LIMITATIONS AND THE SHIPPER SHALL LOAD THE TRAILER IN SUCH A MANNER THAT THE TRACTOR-TRAILBR WILL NOT EXCEED TH

9、ESE LIMITATIONS. AFTER BLOCKING AND BRACING HAS BBEN INSPECTED, ATTACH SHIPPING DOCUMENTS TO AN ACCESSIBLE AREA AHD ATTACH “EXPLOSIVES A“ PLACARD TO BOTH SIDES, FRONT AND REAR OF THE TRAILER. DUE TO THE CRATE STRUCTURE, THE TIEDOWN CHAINS AND PROTECTOR BOARDS MUST BE PLACED OVER THE COVER RETAINING

10、STRAPS. SEE DETAIL A. DO NOT USE TRAILERS -. THBSE STRAPS PASS THROUGH TilE FORK POCKETS OF THE TOP CONTAINERS . FTL 40 FT & LONGER TRAILER (FLATBED) L. A FULL TRUCKLOAD CONSISTS OF FOUR STACKS OF FOUR CONTAINBRS FOR A TOTAL OF I6 CONTAINERS. 2. LOCATE THE END OF THE FORWARD BACKUP CLEAT SIX INCHES

11、FROM THE FORWARD FiDGE OF THE TRAILER 140 FTJ. FOR 42 FT TRAILERS LOCATE THE SAME MEMBERS 18 INCHES FROM THE EDGE AND SIMILARLY FOR 44-45 FT TRAILERS, IIICRMSE THE DISTANCE TO 42 INCHES. 3. WHEN STATE LAW PERMITS, “DOUBLES“ MAY BE USED. BLOCK AND TIE DOWN USIHC THE PRINCIPLES OF THIS DOCUMENT. PAGE

12、2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-SPD-1320-217 (NAVY 9 SEE 2 X 6 DOUBLED, NAIL 2hi PIECE TO IST HITH 1-16d NAIL EVERY 8 6 SEE FTL NOTE 2 Z X 4 TRIPLED, NAIL 1ST PIECE TO TRAILER FLOOR WITH 1-16d NAIL EVERY 8 INCHES. NAIL ZND PIECE

13、 To 1ST ANJI 3RD TO 2ND IN LIKE WER. 2 X 4 DOUBLED. NAIL 1ST PIECE TO TRAILER FLOOR 1/4-l6d NAILS. NAIL 2ND PIECE TO 1ST IN LIKE MANNER. Z X 6 TRIPLED. NAIL 1ST PIECE TO TRUCKLOAD DATA TRAILER FLOOR W/5-16d NAILS. NAIL 2ND PIECE TO 1ST AND 3RD TO 2ND IN LIKE MANNER. HUMBER OF CONTAINERS . . . . . .

14、16 2 X 6 TRIPLED. NAIL 1ST PIECE TO TRAILER FLOOR NITH 1-16d NAIL EVERY 8 INCHES. NAIL ZND PIECE TO 1ST AND 3RD TO ZND IN LIKE MANNER. HUMBER OF MINES . . . . . . . . . 16 WEIGHT (APPROXJ . 28,000 LBS 2 I BACKUP CLEAT I SEE FIELD KOTE 12 x 6 x 18 61 1 I CROSSMEFIBER I SEE FIELD ROTE 12 X 6 X 70 REQD

15、 ITEM DESCRIPTION MATL/DWG DIMENSIONS I LIST OF MATERIALS PAGE 3 I Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,- MIL-STD-1320 -217 1 9999911 OLOb323 0 - M IL-STD-1320-217 (NAVY) LTL 40 FT & LONGER TRAILER (FLATBED) 1. WHEN REQUIRED TO SHIP LESS-TH

16、AN-TRUCKLOAD, SELECT THE CORRECT LOAD PATTERN FOR THE NUMBER OF CONTAINERS TO BE SHIPPED FROH TABLE I. 2. FIFTEEN, ELEVEN, AND SEVEN CONTAINERS CREATES A STACK UNEVEN IN HEIGHT AND SHOULD NOT BE SHIPPED BECAUSE OF TIE DOWN PROBLEMS. 3. POSITION CONTAINERS ON TRAILER AS SHOWN IN TABLE, BLOCK AND TIE

17、DOWN USIHG THE PRINCIPLES SHOWN ON PAGES 3 AND 5 AND THE GENERAL DOCUMENT, HIL-STD- 1320. 4. THE LTL PLAN SHOWN ON PAGE 5 IS THE CORRECT LESS-THAN-TRUCKLOAD POR THE QUANTITY OF CONTAINERS SHOWN. qUANTITY, SINCE LTL SHIPMENTS MAY CONSIST OF A LESSER NUMBER OF CONTAINERS. THIS DOES NOT LIMIT SHIPMENTS

18、 TO THIS 5. WHEN STATE LAW PERMITS, “DOUULES“ AY BE USED. BLOCK AND TIE DOWN USIliG TH6 PRINCIPLES OF THIS DOCUMENT. NO. OF TABLE I NO. OF LOAD PATTERN 9K CONTAINERS -c FWD CONTAINERS 1-1 121 2 121 12 * LOAD PATTERN SHOWS PLOOR PLAN FOR TRAILER. NUMBER INDICATBS THB NUMBER OF CONTAINERS IN A LAYER.

19、. * SEE DETAILS c AND D FOR FLOOR BLOCKING. 121 I 4- I J PAGE 4 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-M I 1- STD -1 3 2 0-21 7 (MA VY) PROTECTOR EOAKDS DETAIL 0 NOTE - PROTECTOR BO.WDS A?iD TIE DOIi?S CHAI#S/STRAPS ARE PLACED DInECTLY OVER

20、COVER STRAPS AS SHOWN. COVER STRAP DETAIL 0 SOTE - FOR LTL?S MARKED * USE DETAILS C 6 D. FOR THE SINGLE CRATE USE ONE DETAIL D AT EACH END DETAIL 0 PAGE 5 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,- _- 4 I, MIL-STD-L320 -217 81 77977LL 010b325 M

21、IL-STD-1320-217 (NAVY) 2 X 6 DOUBLED, NAIL 2ND PIECE TO 1ST WITH 1-1bd NAIL EVERY INCHES. 2 x 6 WUBLED TRAILER FLOOR W/l-l6d NAIL EVERY 8 INCHES. NAIL 2ND PIECE TO 1ST AND 3RD TO 2ND IN LIKE MANNER. UBLED. NAIL 1ST PIECE TO FLOOR H/4-16d NAILS. NAIL 2 X 6 TRIPLED. NAIL 1ST PIECE To TRAILER FLOOR W/5

22、-16d NAILS. NAIL ZND PIEC TO 1ST AND 3RD TO 2ND IN LIKE MANNER. 2 X 6 TRIPLED. NAIL IST PIECE To TRAILER FLOOR W/S-lbd NAILS. NAIL ZND PIBCE TO 1ST AND 3RD TO ZND IN LIKE MANNER. SE E DETAIL 4 10 SEAL SEE oV5TE 5 PG 2 1 114 SEE NOTE 5 PG 2 1 1/4 X 035 X 12 F 4 7 CROSS STRAP 6 8 CHAIN A:ID LOA3 SIHDE

23、R SEE ROTE 5 PG 2 5/16 OR 3/8 4 7 PROTECTOR BOARD SEE FIELD XOTE 2 X 6 X 27 1/2 r SAMPLE LTL TRUCKLOAD DATA NUMBER OF CONTAINERS , , 9 NUMBER OP MINES . 9 WEIGHT (APPR0X.J ,. 15,800 LBS 8 6 PROTECTOR BOARD SEE FIEU, NOTE 2 X 6 X 62 i/% 24 5 SLEEPER SEE FIELD HOTE la 3 4 CROSSMGlBER SEE FIELD NOTE 2

24、X 4 X 35 3 3 CROSSlEWBEI SEE FIELD HOTE 2 x 6 x 70 24 2 BACKUP CLEAT SEE FIEUi NOTE 2 X 6 X 18 CR0SS:iEWBER SEE FIELD IIOTE 2 X 6 X 70 6 1 REQD ITEM DESCRIPTION MATL/DWG DIMENSION! LIST OF MATERIALS PAGE 6 LTL 40 FT &LONGER TRAILER (FLATBED) REVIEW ACTIVITY: NAVY - OS PREPARING ACTIVITY: NAVY-OS (PROJECT NO. 8140-N6lSJ CIOVEANMENT PRINTING OFFICE: 1086 - 606-036/24494 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-