NAVY MIL-STD-1323-159-1981 UNIT LOAD FOR UNDERWAY REPLENISHMENT CARTRIDGE SIGNAL PRACTICE BOMB MARK 4 MOD 3 OR CXU-3A B IN BOX AMMUNITION M2A1《M2A1弹药箱装MARK 4 MOD 3 OR CXU-3A B 信号练习.pdf

1、a a a ,I - MIL-STD-1323 -157 1 797731 0071438 5 MILITARY STANDARD M IL-STD-1323 -1 59 UNIT LOAD 14 M 1981 FOR UNDERWAY REPLENISHMENT CARTRIDGE, SIGNAL, PRACTICE BOMB, MK 4 MOD 3 OR CXU-BA/B IN BOX, AMMUNITION M2A1 UNIT LOAD DATA DODIC/NALC/NO. NUMBER OF CARTRIDGES PER CONTAINER NUMBER OF CONTAINERS

2、PER UNIT LOAD NUMBER OF,CARTRIDGES PER UNIT LOAD GROSS VEIGHT OF ONE CONTAINER (APPROX) . WEIGHT OF WOOD DUNNAGE (APPROX) WEIGHT OF STEEL STRAPPING (APPROX) WEIGHT OF PALLET (APPROX) . GROSS WEIGHT OF UNIT LOAD (APPROX) CUBE MK 4 F562 60 112 6720 13.04 LBS. 12 LBS. 10 LBS. 94 LBS. 1576 LBS. 40.8 CU.

3、 FT. CXU-BMB NA 50 112 5m 16.78 LBS. 12 LBS. 10 LBS. 94 LBS. 1995 LBS. 40.8 CU.FT. CONTAINER, Ma1 SHIPPING AND STORAGE ICWI-DL 2267153 HAZARD CLASSIFICATION CLASS c I IIC DOT - CLASS C CG - CLASS I NOTES: 1. 2. UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN INCHES. FOR CROSS REFRENCE TO ASSOCIATED TRU

4、CKLOADING, CONTAINERLOADING AND CARLOADING MILITARY STANDARDS, REFER TO INDEX TO STANDARDS, MIL-HDBK-236 (NAW) ir U.S. GOVERNMENT PRINTING OFflCE1981-703-023/3466 THIS UNIT LOAD IS AUTHORIZED AND RELEASED FOR SHIPPING, HANDLING, STORAGE AND TRANSFER-AT-SEA. IT MAY ALSO BE USED FOR DOMESTIC SHIPMENT

5、IN COMPLIANCE WITH DOT REGULATIONS. AIRSYSCOM 8)( DIRECTION REQUIREMENTS FOR CONSTRUCTION OF THIS UNIT LOAD SHALL CONSIST OF THIS DOCUMENT AND THE LATEST ISSUE OF MIL-STD-1323 (NAVY) DATE OR IG IN ATOR NAVAL WEAPONS HANDLING CENTER WPNSTA EARLE, NEW JERSEY 1- Provided by IHSNot for ResaleNo reproduc

6、tion or networking permitted without license from IHS-,-,-VIL-STD-1323 -159 81 9999711 0071437 7 W M IL-STD-1323 -1 59 (NAVY) PALLETIZING PROCEDURE (a) THREAD STRAPPING, ITEM 2, BETWEEN DECK WIRES OF PALLET, ITEM 1, AS SHOWN IN DETAIL A. b) POSITION THE CONTAINERS ON THE PALLET DECK WITH CLOSURES IN

7、 ONE DIRECTION. (c) POSITION STRAPPING, ITEM 3, UNDER THE PALLET DECK AND AROUND THE UNIT LOAD, TENSION AND DOUBLE NOTCH SEAL, ITEM 5. (d) POSITION STRAPPING, ITEM 2, AROUND THE END PANEL ASSEMBLY. THE CLEATS OF THE PANEL MUST BE POSITIONED AGAINST THE LOWER SECTION OF THE CONTAINERS, AS SHOWN. TENS

8、ION THE STRAPPING AND DOUBLE NOTCH SEAL. (e) POSITION THE GIRTHWISE STRAPPING, ITEM 4, OVER THE THIRD CLEAT OF THE END PANEL ASSEMBLY, AS SHOWN, TENSION AND DOUBLE NOTCH SEAL. (f) SECURE THE GIRTHWISE STRAPPING, WITH STAPLES, ITEM 6. MARKING: IN ADDITION TO ANY SPECIAL MARKING REQUIRED BY CONTRACT O

9、R ORDER, THE UNIT LOAD SHALL BE MARKED IN ACCORDANCE WITH MIL-STD-1323. W APPLY THESE STRAPS FIRST NOTES: I, ,031 COLD ROLLED, HEAT TREATED, MAY BE SUBSTITUTED. 2. 3. DO NOT USE TYPE I STRAPPING WITH POWER MACHINES. UNLESS OTHERWISE SPECIFIED ALL MATERIAL SHALL BE AS SPECIFIED IN THE GENERAL DOCUMEN

10、T, MIL-STD-1323. REQoD AS 9 NAIL, BOX SEE NOTE3 2d DEPALLETIZING PROCEDURE (a) REMOVE STAPLES. 6) CUT AND REMOVE STRAPPING. (c) REMOVE END PANELS. (d) REMOVE CONTAINERS. !8 8 CLEAT, END SEE NOTE 3 41 X 5/8 X 1/2 2 7 PANEL, END SEE NOTE 3 41 X 28 3/4 X 1/4 t 4 6 STAPLES COMCL 3/4 3/4 8 5 SEAL 1 GIRTH

11、WISE SEE NOTES SEE 1,2 & 3 STRAPPING, 1,2 & 3 3/4 X .O35 X 15 FT 6 SEE NOTES 3/4 x .o35 x 13 FT 6 PALLET, MK3 MOD O 40 x 48 x 4 3/4 REQ. ITEM DESCRIPTION MATL/DWG DIMENSIONS PAGE 2 I LIST OF MATERIALS P! . a Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IH

12、S-,-,- . MIL-STD-1323 -359 83 W 9999933 007LL)L)O 3 = NO. OF NO.0F NO.OF CARTRIDGES LAYERS CONTAINERS DIMENSIONS MK 4 MOD 3 CXU-3 I M IL-STD-1323-159 (NAVY) WEIGHT LBS. (APPROX) CU. Fr. MK 4 MOD 3 CXU-3 n/B I LESS THAN FULL UNIT LOAD 3 2 1 1. LESS THAN FULL UNIT LOADS ARE AUTHORIZED, HOWEVER COMPLET

13、E LAYERS MUST BE MAINTAINED. 2. A LESS THAN FULL UNIT LOAD MAY CONSIST OF 1, 2 OR3 COMPLETE LAYERS. . 3. WHEN PALLETIZING LESS THAN FULL UNIT LOADS, ADJUST THE HEIGHT OF THE END PANEL ASSEMBLIES AND THE LENGTH OF STRAPS,ITEMS 2 AND 3, FOR THE APPROPRIATE HEIGHT. STRAP THE UNIT LOAD USING THE PRINCIP

14、LES SHOWN ON PAGE 2. ALL LOADS SHALL HAVE EIGHT STRAPS, PIECES NUMBERS, 3 AND 4. 4. USE TABLE I FOR DATA ON LESS THAN FULL UNIT LOAD. 84 5040 4200 48 1/2 X 42 3/4X 26 3/4 1210 1525 32.1 56 3360 2800 48 1/2 X 42 3/4 X 19 1/2 845 1055 23.4 28 1680 1400 48 1/2 X 42 3/4 X 12 114 480 585 14.7 TABLE I LES

15、S THAN FULL UNIT LOAD DATA THREAD STRAPPING BETWEEN THE 11th AND 12th WIRE, AT THE CENTER OF THE PALLET. THREAD STRAPPING BETWEEN THE 5th AND 6th WIRE. V DETAIL A END PANEL ASSEMBLY (2 REQUIRED) REVIEWACTIVITIES. NAVY-OS, AS PREPARING ACTIVITY: NAVY-OS (PROJECT NO. 8140-N502) PAGE 3 I Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-