NAVY MS18229 REV B-1986 PLUG FOR O RING GASKET《接插头》.pdf

1、Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-FED. SUP CLASS4730NOTES :1. Each plug shall be marked on the hex head in accordance with MIL-STD-792with one of the following material designators:Ferrous metal DesignatorCarbon steel CS Stainless steel

2、 SSCorrosion resistant steel CRNon-ferrous metalCopper nickel CNNickel copper NCTin bronze TBTitanium TIProcuring activities shall specify material identification by addingthe appropriate designator to the dash number. The designator is onlyfor identification purposes and does not replace pertinent

3、materialdata required by the applicable material specification.2. When non-ferrous designators are specified in accordance with Note 1above, the notched hex corners (60 included angle, .030 to .045 deep)shall be provided.3. Lockwire holes shall be specified by adding “L” after the materialdesignator

4、.4. Lanyard retainer posts shall be specified by adding “Y” after the materialdesignator or lockwire hole (if applicable).Example of part numbers:MS18229-6CS - Plug, 3/8 Tubing, Carbon SteelMS18229-6TIL - Plug, 3/8 Tubing, Titanium, with Lockwire Hole (HexNotches)MS18229-6NCY - Plug, 3/8 Tubing, Nic

5、kel Copper, with Lanyard RetainerPost (Hex Notches)MS18229-6CRLY - Plug, 3/8 Tubing, Corrosion Resistant Steel, with LockwireHole, and Lanyard Retainer PostAMSC N/ADISTRIBUTION STATEMENT A Approved for public release; distribution unlimitedINTERNATIONAL TITLEINTEREST MILITARY STANDARDPLUG FOR “O” RING GASKET MS18229(SH)PROCUREMENT Specification SUPERSEDES:NONE SHEET OF2 2Denotes changesProvided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-