JIS Z 3400-2013 6250 Quality requirements for fusion welding of metallic materials《金属材料熔焊的质量要求》.pdf

相关资源

JIS Z 2201-1998 中文版 金属材料拉伸试验.pdf

JIS Z 2201-1998 英文版 金属材料抗拉试验用试样.pdf

JIS Z 2242-2005 金属材料冲击试验方法.pdf

JIS Z 2254-2008 中文版 薄板金属材料的塑性变形比试验方法.pdf

JIS Z 2254-2008 英文版 薄板金属材料的塑性变形比试验方法.pdf

JIS Z 3422-1-2003 金属材料焊接程序规范及认可.焊接程序试验.第1部分钢的电弧焊及气焊和镍及镍合金的电弧焊.pdf

JIS Z3420-2003 金属材料焊接过程的规范及认可.总则 Specification and approval of welding procedures for metallic materials -- Welding procedure specification for arc welding.pdf

JIS G0564-1999 金属材料.平面应变断裂强度的测定.pdf

JIS H7503-2003 超塑变形金属材料孔穴体积百分率的测量方法.pdf

YB T 5293-2006 金属材料.顶锻试验方法.pdf

猜你喜欢

NASA NACA-TN-3663-1956 Discharge coefficients for combustor-liner air-entry holes《燃烧器衬垫进气孔的流量系数》.pdf

NASA NACA-TN-3669-1956 Perforated sheets as a porous material for distributed suction and injection《对于分布式抽吸和注射的作为多孔材料的冲孔薄板》.pdf

NASA NACA-TN-3671-1956 Wind-tunnel investigation of the effect of clipping the tips of triangular wings of different thickness camber and aspect ratio - transonic bump method《使用跨音速.pdf

NASA NACA-TN-3693-1956 Preliminary investigation of the effectiveness of a sliding flap in deflecting a propeller slipstream downward for vertical take-off《对于垂直起飞将螺旋桨滑流偏转向下滑行襟翼有效性的.pdf

NASA NACA-TN-3696-1956 A study of the high-speed performance characteristics of 90 degrees bends in circular ducts《圆形风管内90弯曲高速性能特性的研究》.pdf

NASA NACA-TN-3782-1957 Handbook of structural stability part II buckling of composite elements《结构稳定性手册第II部分 复合装置的屈曲》.pdf

NASA NACA-TN-3784-1957 Handbook of structural stability part IV - failure of plates and composite elements《结构稳定性手册第IV部分 平板和复合装置的故障》.pdf

NASA NACA-TN-3785-1957 Handbook of structural stability part V - compressive strength of flat stiffened panels《结构稳定性手册第V部分 平坦硬化板的压缩强度》.pdf

NASA NACA-TN-3793-1956 Exploratory investigation of the use of area suction to eliminate air-flow separation in diffusers having large expansion angles《使用抽吸区域消除带有大膨胀角扩散器气流分离的探索性研究》.pdf