1、AMSC N/A 1 of 2 FSC 8455 DETAIL SPECIFICATION SHEET LAPEL BUTTON, SENIOR LEADERSHIP AND SCIENTIFIC AND PROFESSIONAL COMMUNITIES, U.S. ARMY This specification is approved for use by all Departments and Agencies of the Department of Defense The requirements for acquiring the product described herein s
2、hall consist of this specification sheet, the latest issue of MIL-DTL-11484, MATERIAL: Red Brass 85/15 (UNS Alloy C-230) FINISH: Brass, Oxidized, Buffed Relieved and shall match The Institute of Heraldry Metal Finish Chip number 4. DIMENSIONS: HEIGHT: 1/2 inch (REF) WIDTH: 25/64 inch (REF) THICKNESS
3、 (Across top of protruding rays): 0.060 0.010 inch ATTACHING DEVICE: 1. Attaching device shall be prong with pick and wing type clutch. 2. The prong shall be centered on the reverse side and fused or soldered to the lapel button. INCH-POUND MIL-DTL-11484/354 14 June 2013 Provided by IHSNot for Resal
4、eNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-11484/354 2 of 2 DECORATION CASE: Each lapel button presented in a case shall be mounted and centered on a polyethylene pad and placed in a rigid hinged plastic box having a transparent lid and opaque bottom section. The b
5、ox shall have two plastic hinges and catches and shall be approximately 1-1/8 inches square and 5/8 inch in overall depth. The pad shall be sufficient depth to restrict movement of the lapel button. NOTE: The term (REF) refers to the measurements taken from the Government furnished hub or die. Custo
6、dian: Preparing activity: Army - IH Army - IH Review Activity: (Project No. 8455-2013-142) DLA - CT NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
