1、1 of 2NOT MEASUREMENT SENSITIVEMIL-DTL-3628/19723 September 1997DETAIL SPECIFICATION SHEETBADGE, QUALIFICATION, COMMAND-AT SEA,NATIONAL OCEANIC AND ATMOSPHERIC ADMINISTRATIONThis specification is approved for use by all Departmentsand Agencies of the Department of Defense.The requirements for acquir
2、ing the product described herein shallconsist of this specification sheet and the issue of MIL-DTL-3628 listed inthat issue of the Department of Defense Index of Specifications andStandards (DoDISS) specified in the solicitation.DASH NO.-1: Regular SizeMATERIAL: Red Brass -2: Miniature SizeFINISH: G
3、old Plated, Matte Finish with the Small Triangles in the Top Scroll having Polished Highlighted and shall match TIOH Metal Finish Chip Number 8.DIMENSIONS:DIAMETER (Circumscribed):-1: 1-1/2 inches (3.81 cm) (REF)-2: 3/4 inch (1.91 cm) (REF)THICKNESS (At Thickest Point):-1: 0.200 inch + .010 inch (0.
4、508 cm + 0.025 cm)-2: 0.110 inch + .010 inch (0.279 cm + 0.025 cm)AMSC N/A FSC 8455DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-3628/1972 of 2NOTES:1. The ter
5、m (REF) refers to the measurements taken from theGovernment furnished hub or die.2. The attaching device for Dash No. -1 shall be prong and clutchtype. Three prongs shall be located on an approximate 1-3/8 inch (3.49cm) diameter circle. Each prong shall be spaced 120 degrees apart withthe bottom pro
6、ng located on the vertical center line at the bottom of thebadge. The attaching device for Dash No. -2 shall be prong and clutchtype. Two prongs shall be located equidistant from each side and 5/8 inch+ 1/32 inch (1.59 cm + 0.08 cm) apart.3. A mock forcer may be used to bring up the center of the badge.Custodian: Preparing activity:Army - IH Army - IHReview activities: (Project No. 8455-0909)DLA - CTProvided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
