1、 AMSC N/A Page 1 of 2 FSC 8455 INCH-POUND MIL-DTL-3628/203A 15 August 2009 SUPERSEDING MIL-DTL-3628/203 16 April 1998 DETAIL SPECIFICATION SHEET BADGE, QUALIFICATION, FMF COMBAT INFANTRY TROPHY, MARINE CORPS This specification is approved for use by all Departments and Agencies of the Department of
2、Defense. The requirements for acquiring the product described herein shall consist of this specification sheet and the latest issue of MIL-DTL-3628. MATERIAL: Red Brass FINISH (Pendant and Suspension Bar): OBVERSE: Gold Plated, Matte Finish, Polished Highlights and shall match The Institute of Heral
3、dry (TIOH) Metal Finish Chip Number 8. REVERSE: Gold Plated, Mirror-like Polished and shall match TIOH Metal Finish Chip Number 6. DIMENSIONS: Height (Overall): ASSEMBLED: 2-1/16 inches (REF) PENDANT: (Excluding Lugs): 1-1/2 inches (REF) SUSPENSION BAR: (Excluding Lugs): 11/32 inch (REF) WIDTH (Over
4、all): PENDANT: 1-1/2 inches (REF) SUSPENSION BAR: 1-9/16 inches (4.00 cm) (REF) Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-3628/203A Page 2 of 2 THICKNESS: PENDANT (Thickest Point): 1.91 inch + 0.10 inch SUSPENSION BAR (Thickest Point):
5、0.82 inch + 0.10 inch NOTES: 1. The term (REF) refers to the measurements taken from the Government furnished hub or die. 2. The links shall be oblong shaped, 7/32 + 1/32 long by 5/32 inch + 1/32 inch wide and shall be formed from 0.040 inch + 0.002 inch diameter wire. 3. The lugs are an integral pa
6、rt of both the pendant and the suspension bar. 4. The attaching device shall be prong and flat ball clutch type. The prongs shall be located on the horizontal center line of the back of the suspension bar equidistant from each end and 1-3/32 inch + 1/32 inch apart. CHANGES FROM PREVIOUS ISSUE: The m
7、argins of this specification are marked with vertical lines to indicate where changes from the previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate t
8、he requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous issue. Custodian: Preparing activity: Army - IH Army - IH Navy MC (Project No. 8455-2009-105) Review activities: DLA - CT NOTE: The activities listed above were i
9、nterested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
