1、 AMSC N/A Page 1 of 2 FSC 8455 INCH-POUND MIL-DTL-3628/63G 15 November 2009 SUPERSEDING MIL-DTL-3628/63F 15 November 1996 DETAIL SPECIFICATION SHEET BADGE, QUALIFICATION, AIR ASSAULT, ARMY This specification is approved for use by all Departments and Agencies of the Department of Defense. The requir
2、ements for acquiring the product described herein shall consist of this specification sheet and the latest issue of MIL-DTL-3628. DASH NO. -1: Regular Size -2: Dress Miniature Size -3: Regular Size, Subdued MATERIAL: Red Brass or Nickel Silver or Zinc Aluminum FINISH: -1, -2: Nickel Plated (Red Bras
3、s only), Silver Plated, Oxidized, Relieved, Matte Finish and shall match The Institute of Heraldry (TIOH) Metal Finish Chip Number 14. Zinc Aluminum: Copper Plated, Nickel Plated, Silver Plated, Oxidized, Relieved, Matte Finish and shall match TIOH Metal Finish Chip Number 14. -3: Dull Flat Black En
4、amel Finish. DIMENSIONS: HEIGHT (overall): -1, -3: 3/4 inch (REF) -2: 7/16 inches (REF) Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-3628/63G Page 2 of 2 WIDTH (overall): -1, -3: 1-17/32 inches (REF) -2: 7/8 inches (REF) THICKNESS (center
5、of rotor): -1, -3: 0.090 inch + 0.005 inch -2: 0.065 inch + 0.005 inch NOTES: 1. The term (REF) refers to the measurements taken from the Government furnished hub or die. 2. Piercing shall be as indicated. 3. The attaching device shall be prong and clutch type. The prongs shall be located at each in
6、tersection of the horizontal center line of the badge and the center of the wings. 4. A forcer may be used to bring up the nose of the helicopter. 5. The dull, flat black enamel for Dash No. -3 shall match FED-STD-595, Chip No. 37038. 6. Dash No. -1 and -2 may be nickel or rhodium plated with a mirr
7、or-like finish which shall match TIOH Metal Finish Chip Number 16 for commercial sale only. For nickel plated or rhodium plated items, the silver plating requirements shall not apply. CHANGES FROM PREVIOUS ISSUE: The margins of this specification are marked with vertical lines to indicate where chan
8、ges from the previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the m
9、arginal notations and relationship to the last previous issue. Custodian: Preparing activity: Army - IH Army - IH (Project No. 8455-2010-008) Review activities: DLA - CT NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
