1、VCH-POUND MIL-T-49303(CR) AMENDMENT I 20 December 1988 MILITARY SPECIFICATiON TRANSPONDER SET AN/PPN-l9(V) This amendment forms a part of MIL-T-B9303(CR), dated 18 August 88, and is approved for use by the Communications-Electronics Command, Department of the Army, and is available for use by all D
2、epartments and Agencies of the Department of Defense Page 1, add new pragraph: I 1.2 Configuration Versions. The (V)2 version of Transformer Set AN/PPN-lS(V) is identical to the (V)i version, with the addition of a Battery Box.“ ?age 2, paidgraph 2.1.2., see the drawings list, delete: 4tDLC5r)83030
3、 Transponder Set Assembly, AN/PPN-19“, and replace with: 11DLC5083030 - Transponder Set Assembly, AN/PPN-lS(V)2“. Add: “DLC5083073 - Transponder Set Assembly, AN/PPN-l9(V)l“. Page 3, paragraph 2.2, line 2, change flesceptf to “except“, Page 4, paragraph 3.2, delete: “The Transponder Set AN/PPN- 19(
4、V) shall be constructed in accordance with the requirements of this specification, DLC5083030, and the following list of major components:“ and replace with: “The Transponder Set AN/PPN-I 9(V) shall be constructed in accordance with the rquirements of this specification, DLC5083073 for configuration
5、 (V)l, DLC5083030 for configuration (VI2 and the following list of major components common to both configurations, except for the Battery Box Assembly, which is used in the (V)2 configuration only:“ At the bottom f: component list, after C5083329, add: “(V)Z configuration only.“ AMSC - N/A FSC 5895
6、DISTRIBUTION STATEMENT A. Approved for public release; distribution unlimited. THIS DOCUMENT CONTAINS 2 PAGES. 9 - 1. ! Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,- MIL-T-4930
7、3 (1) 58 W 9999906 0163275 9 C MIL-T- 49333(CR) Page 11, paragraph 4.5.1, Table II - correct test paragraph numbers as follows: Visual and mechanical 4*13 System safety IC, 13- 1“ Page 13, paragraph 4.6, see list of drawings - correct drawing number for Preliminary Alignment and Test Procedure t1C50
8、S7106t1. Page 15, paragraph 4.10 - add the following sentence to the paragraph: “Test data from these measurements shall be within the pass criteria identified in the ATPs listed in 4.9 above.“ Page 18, paragraph 4.13, line 3 - correct references to requirements paragraph is: “.requirements of 3.6 and 3.1 cC1 Custodian: ARMY-CR Preparing activity: Project 5895-A387 ARMY - CR 2 Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
