GOST ISO 1795-1996 Rubber raw natural and synthetic Sampling and further preparative procedures《天然及合成橡胶 试样的抽取及进一步制备的程序》.pdf

相关资源

CB T 3700-1995 增强合成橡胶或增强塑料充气艇.pdf

SH T 0691-2000 润滑剂的合成橡胶溶胀性测定法.pdf

SH T 0429-1992 润滑脂与合成橡胶相容性测定法.pdf

SH T 1760-2007 合成橡胶胶乳中残留单体和其他有机成分的测定 毛细管柱气相色谱 直接液体进样法.pdf

SH T 1799-2016 合成橡胶胶乳 玻璃化转变温度的测定 差示扫描量热法（DSC）.pdf

SH T 1149-2006 合成橡胶胶乳 取样.pdf

GB T 5577-2008 合成橡胶牌号规范.pdf

GB 6735-1986 合成橡胶试样制备.pdf

SH T 1153-2011 合成橡胶胶乳.凝固物含量（筛余物）的测定.pdf

SH T 1154-2011 合成橡胶胶乳总固物含量的测定.pdf

猜你喜欢

AGMA 06FTM04-2006 Precision Planetary Servo Gearheads《精密行星伺服齿轮头》.pdf

AGMA 06FTM05-2006 Development of a Gear Rating Standard - A Case Study of AGMA 6014--A06《齿轮分级标准的发展.AGMA 6014--A06的案例研究》.pdf

AGMA 06FTM06-2006 An Analytical Approach to the Prediction of Micropitting on Case Carburised Gears《层渗碳齿轮微点蚀的预测分析方法》.pdf

AGMA 06FTM07-2006 Improvement of Standardized Test Methods for Evaluating the Lubricant Influence on Micropitting and Pitting Resistance of Case Carburized Gears《评估润滑剂对层渗碳齿轮上微点蚀和抗点.pdf

AGMA 06FTM08-2006 An Evaluation of FZG Micropitting Test Procedures and Results for the Crowned AGMA Test Gears《鼓形AGMA测试齿轮用FZG微点蚀测试程序和结果的评估》.pdf

AGMA 06FTM09-2006 Opportunities to Replace Wrought Gears with High Performance PM Gears in Automotive Applications《在汽车应用中用高性能PM齿轮替换精加工齿轮的时机》.pdf

AGMA 06FTM10-2006 Fabrication Assembly and Test of a High Ratio Ultra Safe High Contact Ratio Double Helical Planetary Transmission for Helicopter Applications《直升机设施用双螺旋混合行星齿轮传动高接触.pdf

AGMA 06FTM11-2006 On Tooth Failure Analysis in Small--Teeth--Number Gearing An Analytical Approach《小齿数齿轮上轮齿故障分析 分析方法》.pdf

AGMA 06FTM12-2006 A Crane Gear Failure Analysis -- Case Study Observations Lessons Learned Recommendations《起重机齿轮疲劳分析.案例研究、观察、课程学习、介绍》.pdf