SANS 10120-5 HE-1983 Code of practice for use with standardized specifications for civil engineering construction and contract documents Part 5 Contract administration Section HE S.pdf

1、 Collection of SANS standards in electronic format (PDF) 1. Copyright This standard is available to staff members of companies that have subscribed to the complete collection of SANS standards in accordance with a formal copyright agreement. This document may reside on a CENTRAL FILE SERVER or INTRA

2、NET SYSTEM only. Unless specific permission has been granted, this document MAY NOT be sent or given to staff members from other companies or organizations. Doing so would constitute a VIOLATION of SABS copyright rules. 2. Indemnity The South African Bureau of Standards accepts no liability for any

3、damage whatsoever than may result from the use of this material or the information contain therein, irrespective of the cause and quantum thereof. Clause SABS 0120 : Part 5 Section HE-1983 structural alminiumrk PART 5 .r CONTRACT ADMINISTRATION SECTION HE CONTENTS Page Number START OF CONSTRUCTION .

4、 1 General 1 IMMEDIATELY AFTER THE HANDING OVER OF THE SITE 1 Approval of Shop Details and working rawings . 1 DURING CONSTRUCTION 1 Methods of Construction 1 ivets and bolts 1 dministration 1 Contractor provides shop details 1 QUALITY CONTROL AND OTHER CONSIDERATIONS 1 November 1983 Approved by the

5、 COUNCIL OF THE SOUTH AFRICAN BUREAU OF STANDARDS SABS 0120 : Part 5 Section hE-1983 structural aluminiumwork SN)S l200 HE : STRUCTURAL ALUMINIUMWORK NOTE: The clause nunber(s) given at the beginning or after the heading of a clause is/are, unless otherwise stated, the number(s) of the relevant clau

6、se(s) of SABS 1200 HE. START OF CONSTRUCTION GENERAL. For the purposes of this part of the code, contract administration starts with instructions to the contractor to commence work as set out in Clause 4 of Section 0. IMMEDIATELY AFTER THE HANDING OVER OF THE SITE APPROVAL OF SHOP DETAILS AND WORKIN

7、G DRAWINGS (Subclause 5.1). The engineer should, when applicable, ensure that agreement has been reached and approval given on all details of working drawings for fabrication and erection by a date that is early enough to avoid delays in the supply of materials and in commencing the work. (See also

8、Subclause 3.2.1 of Section H.) 3. DURING CONSTRUCTION 3.1 METHODS OF CONSTRUCTION 3.1.1 Rivets and Bolts (Subclause 3.5). Bolts commonly known as huckbolts comply with the applicable requirements of Subclause 3.5 of SABS 1200 HE. 3.2 ADMINISTRATION 3.2.1 Contractor Provides Shop Details (Subclause 5

9、.1). Shop details should be submitted by the contractor in good time to allow an agreed or specified period for scrutiny and approval by the engineer, and no work should be put in hand before the engineers approval has been obtained. In general, if the engineer takes lonqer than one month (or the pe

10、riod agreed between the engineer and the contractor or stated in the project specification) to give his approval of properly prepared details, the contractor could claim that he has been unreasonably delayed. QUALITY CONTROL AND OTHER CONSIDERATIONS The relevant recommendations of SABS 0157) should be applied to the fabrication and erection of structural aluminiumwork. 1) Quality management systems. sabs pta