TIA-329 3-2011 Minimum Standards for Communications Antennas Part 3 Portable Antennas《通信天线的最低标准 第3部分 便携式天线》.pdf

1、 TIA-329.3 March 2011Minimum Standards for Communications Antennas Part 3: Portable Antennas NOTICE TIA Engineering Standards and Publications are designed to serve the public interest through eliminating misunderstandings between manufacturers and purchasers, facilitating interchangeability and imp

2、rovement of products, and assisting the purchaser in selecting and obtaining with minimum delay the proper product for their particular need. The existence of such Standards and Publications shall not in any respect preclude any member or non-member of TIA from manufacturing or selling products not

3、conforming to such Standards and Publications. Neither shall the existence of such Standards and Publications preclude their voluntary use by Non-TIA members, either domestically or internationally. Standards and Publications are adopted by TIA in accordance with the American National Standards Inst

4、itute (ANSI) patent policy. By such action, TIA does not assume any liability to any patent owner, nor does it assume any obligation whatever to parties adopting the Standard or Publication. This Standard does not purport to address all safety problems associated with its use or all applicable regul

5、atory requirements. It is the responsibility of the user of this Standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations before its use. (From Project No. 3-4606.3, formulated under the cognizance of the TIA TR-8 Mobile and Personal

6、Private Radio TR-8.11 Subcommittee on Antenna Systems). Published by TELECOMMUNICATIONS INDUSTRY ASSOCIATION Standards and Technology Department 2500 Wilson Boulevard Arlington, VA 22201 U.S.A. PRICE: Please refer to current Catalog of TIA TELECOMMUNICATIONS INDUSTRY ASSOCIATION STANDARDS AND ENGINE

7、ERING PUBLICATIONS or call IHS, USA and Canada (1-877-413-5187) International (303-397-2896) or search online at http:/www.tiaonline.org/standards/catalog/ All rights reserved Printed in U.S.A. NOTICE OF COPYRIGHT This document is copyrighted by the TIA. Reproduction of these documents either in har

8、d copy or soft copy (including posting on the web) is prohibited without copyright permission. For copyright permission to reproduce portions of this document, please contact the TIA Standards Department or go to the TIA website (www.tiaonline.org) for details on how to request permission. Details a

9、re located at: http:/www.tiaonline.org/standards/catalog/info.cfm#copyright or Telecommunications Industry Association Technology (b) there is no assurance that the Document will be approved by any Committee of TIA or any other body in its present or any other form; (c) the Document may be amended,

10、modified or changed in the standards development or any editing process. The use or practice of contents of this Document may involve the use of intellectual property rights (“IPR”), including pending or issued patents, or copyrights, owned by one or more parties. TIA makes no search or investigatio

11、n for IPR. When IPR consisting of patents and published pending patent applications are claimed and called to TIAs attention, a statement from the holder thereof is requested, all in accordance with the Manual. TIA takes no position with reference to, and disclaims any obligation to investigate or i

12、nquire into, the scope or validity of any claims of IPR. TIA will neither be a party to discussions of any licensing terms or conditions, which are instead left to the parties involved, nor will TIA opine or judge whether proposed licensing terms or conditions are reasonable or non-discriminatory. T

13、IA does not warrant or represent that procedures or practices suggested or provided in the Manual have been complied with as respects the Document or its contents. If the Document contains one or more Normative References to a document published by another organization (“other SSO”) engaged in the f

14、ormulation, development or publication of standards (whether designated as a standard, specification, recommendation or otherwise), whether such reference consists of mandatory, alternate or optional elements (as defined in the TIA Engineering Manual, 4thedition) then (i) TIA disclaims any duty or o

15、bligation to search or investigate the records of any other SSO for IPR or letters of assurance relating to any such Normative Reference; (ii) TIAs policy of encouragement of voluntary disclosure (see Engineering Manual Section 6.5.1) of Essential Patent(s) and published pending patent applications

16、shall apply; and (iii) Information as to claims of IPR in the records or publications of the other SSO shall not constitute identification to TIA of a claim of Essential Patent(s) or published pending patent applications. TIA does not enforce or monitor compliance with the contents of the Document.

17、TIA does not certify, inspect, test or otherwise investigate products, designs or services or any claims of compliance with the contents of the Document. ALL WARRANTIES, EXPRESS OR IMPLIED, ARE DISCLAIMED, INCLUDING WITHOUT LIMITATION, ANY AND ALL WARRANTIES CONCERNING THE ACCURACY OF THE CONTENTS,

18、ITS FITNESS OR APPROPRIATENESS FOR A PARTICULAR PURPOSE OR USE, ITS MERCHANTABILITY AND ITS NONINFRINGEMENT OF ANY THIRD PARTYS INTELLECTUAL PROPERTY RIGHTS. TIA EXPRESSLY DISCLAIMS ANY AND ALL RESPONSIBILITIES FOR THE ACCURACY OF THE CONTENTS AND MAKES NO REPRESENTATIONS OR WARRANTIES REGARDING THE

19、 CONTENTS COMPLIANCE WITH ANY APPLICABLE STATUTE, RULE OR REGULATION, OR THE SAFETY OR HEALTH EFFECTS OF THE CONTENTS OR ANY PRODUCT OR SERVICE REFERRED TO IN THE DOCUMENT OR PRODUCED OR RENDERED TO COMPLY WITH THE CONTNTS. TIA SHALL NOT BE LIABLE FOR ANY AND ALL DAMAGES, DIRECT OR INDIRECT, ARISING

20、 FROM OR RELATING TO ANY USE OF THE CONTENTS CONTAINED HEREIN, INCLUDING WITHOUT LIMITATION ANY AND ALL INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES (INCLUDING DAMAGES FOR LOSS OF BUSINESS, LOSS OF PROFITS, LITIGATION, OR THE LIKE), WHETHER BASED UPON BREACH OF CONTRACT, BREACH OF WARRANTY

21、, TORT (INCLUDING NEGLIGENCE), PRODUCT LIABILITY OR OTHERWISE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. THE FOREGOING NEGATION OF DAMAGES IS A FUNDAMENTAL ELEMENT OF THE USE OF THE CONTENTS HEREOF, AND THESE CONTENTS WOULD NOT BE PUBLISHED BY TIA WITHOUT SUCH LIMITATIONS. TIA-329.3 iii Ta

22、ble of Contents 1.0 Scope 1 2.0 Normative References 3 3.0 Definitions and Abbreviations 4 3.1 Definitions 5 3.2 Abbreviations . 5 4.0 Types of Portable Antennas 6 4.1 Hand-held portable transceivers 7 4.2 Packset portable transceivers 8 4.3 Paging receivers 10 4.4 Hand-held mobile (cellular/PCS/wir

23、eless) telephones . 10 4.5 Devices intended to be plugged-in to a laptop computer . 11 4.6 Other Wireless Portable information devices . 12 4.7 Electrically-Small Antennas . 12 5.0 Measurement Techniques General . 15 5.1 Antenna Gain Measurements 15 5.2 Measurements on Integral Antennas . 18 5.2.1 R

24、eceiving Devices 18 5.2.3 Transmitting Antennas 19 6.0 Measurement Techniques Specific . 22 6.1 Common Issues . 23 6.1.1 Statistical Issues . 23 6.1.2 Measurements in Motor Vehicles . 24 6.1.3 The effects of Reflections . 25 6.2 Hand-Held Portable Transceivers 26 6.3 Packset Portable Transceivers 29

25、 6.4 Paging Receivers 29 6.5 Hand-Held Mobile Telephones 29 6.6 Devices Intended to be Plugged into Laptop Computers . 29 6.7 Other Wireless Portable Information Devices 30 7.0 Presentation of Results . 31 Bibliography 33 Annex A Electrically-Small Antennas Impedance, Bandwidth, and Realizable Gain

26、35 A.1 Power Factor, Bandwidth and Q 35 A.2 Realizable Gain . 37 TIA-329.3 iv Blank Page TIA-329.3 v FOREWORD This Standard was prepared by TIA Working Group 8.11.3 and was approved by TIA Engineering Subcommittee TR-8.11. This Standard is new and does not supersede any other TIA Standard. This Stan

27、dard is Part 3 of the TIA-329.* series of standards relating to Antenna Systems. Annex A is informative. (This Foreword is not part of this Standard.) TIA-329.3 vi Blank Page TIA-329.3 vii INTRODUCTION Over the years, manufactures of antennas for portable communications devices (including the manufa

28、cturers of the devices, themselves) have, when they stated measurement results at all, failed to state the methods that were used to obtain those measurements. There is reason to believe that one of the reasons for that failure is that it would require a complex explanation. Having a well-defined pu

29、blished method for making such measurements, based on industry consensus, will give the manufacturers a simple shorthand way of stating their methods and will give the customer community confidence that such measurements were done in a relatively consistent manner.TIA-329.3 viii Blank Page TIA-329.3

30、 1 Minimum Standards for Communications Antennas, Portable Antennas 1.0 Scope The TIA-329.* series standards deal with antenna systems. TIA-329.1-* deals with requirements for and measurements of Base Station antennas. TIA-329.2-* deals with measurements of mobile antennas. This standard, TIA-329.3,

31、 deals with measurements of portable antennas. The term “portable antennas” in this context is taken to mean any antenna mounted on or built-in to a portable communication device. It also includes any human-worn antenna intended to be used exclusively with a portable communication device. The term “

32、portable communications device” includes, but is not limited to, the following classes of devices: Hand-held portable transceivers (i.e. “walkie-talkies”) Packset portable transceivers Paging receivers Hand-held mobile (cellular) telephones Portable information devices Devices intended to be plugged

33、-in to a laptop computer via an Accessory Port or a USB port It is the intent of this document to present a method of measuring in situ portable antenna performance for application to network design. There are a number of factors that affect antenna operation on a portable device that are part of th

34、e ambient environment within a few wavelengths of the portable antenna. These factors from the ambient environment are detached from the portable transceiver and the portable antenna themselves. The factors include the dielectric and absorption properties of the bodies of the personnel holding the p

35、ortable device with their apparel, together with aspects of the posture, azimuth, and orientation of the antenna, and any furnishings, vehicles, or environmental edifices within a few wavelengths of the antenna. Other details of the ambient environment can also introduce factors, such as a factor fo

36、r precipitation or moisture. A measurement of portable antenna operation requires the selection of some sample of the portable devices, and any associated factors, combined with the technical means to make the measurement for all the selected samples. This selection of factors constitutes the test c

37、ondition(s) of an experiment. If the selection of the factors in the test condition is successful, then the measurement results will be distributed to permit statistically valid conclusions about portable TIA-329.3 2 device(s) operation in a network design. The method of measurement includes an expe

38、rimental design for the purposes of measuring portable antenna operation for receiving or transmitting messages with the selection of some set of test conditions that is within the technical means of effort to apply the measurement. The measurements results will then be a set of data points that are

39、 statistically analyzed to draw valid conclusions, if there are any. Since the factors from the ambient environment are likely to change for different applications or purposes, the repeatability of the measurement results may not be always possible, unless the experiment is designed to tightly const

40、rain the factors that affect portable antenna operation. Any extension of experimental test results to other portable devices, or other antennas, or to different ambient factors is not anticipated by this standard This document does not recommend performance limits for the antennas dealt with herein

41、. This document applies to portable antennas within the frequency range 25 MHz to 6.0 GHz. TIA-329.3 3 2.0 Normative References Land Mobile FM or PM - Communications Equipment - Measurement and Performance Standards, TIA-603-C, Telecommunications Industry Association, Arlington VA, 2004. TIA-329.3 4

42、 Blank Page TIA-329.3 5 3.0 Definitions and Abbreviations 3.1 Definitions Radiansphere: The boundary between the near field and the far field of a small antenna. Its radius is one radianlength (/2), at which distance the three terms of the field are equal in magnitude. 3.2 Abbreviations EIRP Effecti

43、ve Isotropic Radiated Power ERPd Effective Radiated Power referenced to a dipole ESA Electrically-small antenna PCMCIA Personal Computer Memory Card International Association PDA Portable Digital Assistant PTT Push-to-talk RSM Remote Speaker / Microphone SMA Speaker / Microphone / Antenna (not to be

44、 confused with the RF connector with the same designation) USB Universal Service Bus TIA-329.3 6 Blank Page TIA-329.3 7 4.0 Types of Portable Antennas 4.1 Hand-held portable transceivers A hand-held portable transceiver is typically used by organizations engaged in “dispatch”-type operations as well

45、 as “fireground” and “tactical” operations. Other applications exist as well. Their form factor generally reflects the fact that simplex or half-duplex are the most common modes of operation and it is uncommon for them to be used in a “telephone-type” full-duplex mode of operation. Such transceivers

46、 are generally a “rounded” parallelepiped in shape, with the microphone and speaker both installed near the top of the face that is regarded as the “front”. When transmitting, such devices are generally held in front of the users face with the microphone in front of the users mouth. Receiving can ta

47、ke place in whatever position the unit happens to be with respect to the body. Some typical positions are listed below: On the users belt In the radio pocket of a firefighters turnout coat (chest level) In the pocket of a flak jacket (waist level) Shoulder (as part of SMA accessory) Head (receiving

48、between transmissions) In addition, accessories exist such that the user can operate the transceiver without holding it. These can alter the antenna position from where it might otherwise be when held in front of the mouth. Some such accessories are listed below: Remote speaker microphone (RSM) Plac

49、es the speaker/microphone on the users shoulder, leaving the antenna on the users belt for both transmitting and receiving. The cable running from the transceiver to the RSM may alter the pattern of the antenna. Speaker/microphone/antenna (SMA) Places the antenna itself on the users shoulder, meaning that both transmitting and receiving takes place from there. Helmet-mounted speaker satisfies Wheelers condition for ESA with ka 0.5 TIA-329.3 15 5.0 Measurement Techniques General 5.1 Antenna Gain Measurements An initial componen