ANSI CTA-2063-2017 Small Unmanned Aerial Systems Serial Numbers.pdf

1、 ANSI/CTA Standard Small Unmanned Aerial Systems Serial Numbers ANSI/CTA-2063 April 2017 NOTICE Consumer Technology Association (CTA) Standards, Bulletins and other technical publications are designed to serve the public interest through eliminating misunderstandings between manufacturers and purcha

2、sers, facilitating interchangeability and improvement of products, and assisting the purchaser in selecting and obtaining with minimum delay the proper product for his particular need. Existence of such Standards, Bulletins and other technical publications shall not in any respect preclude any membe

3、r or nonmember of the Consumer Technology Association from manufacturing or selling products not conforming to such Standards, Bulletins or other technical publications, nor shall the existence of such Standards, Bulletins and other technical publications preclude their voluntary use by those other

4、than Consumer Technology Association members, whether the standard is to be used either domestically or internationally. Standards, Bulletins and other technical publications are adopted by the Consumer Technology Association in accordance with the American National Standards Institute (ANSI) patent

5、 policy. By such action, the Consumer Technology Association does not assume any liability to any patent owner, nor does it assume any obligation whatever to parties adopting the Standard, Bulletin or other technical publication. This document does not purport to address all safety problems associat

6、ed with its use or all applicable regulatory requirements. It is the responsibility of the user of this document to establish appropriate safety and health practices and to determine the applicability of regulatory limitations before its use. This document is copyrighted by the Consumer Technology A

7、ssociation (CTA) and may not be reproduced, in whole or part, without written permission. Federal copyright law prohibits unauthorized reproduction of this document by any means. Organizations may obtain permission to reproduce a limited number of copies by entering into a license agreement. Request

8、s to reproduce text, data, charts, figures or other material should be made to the Consumer Technology Association (CTA). (Formulated under the cognizance of the CTA R6 Portable, Handheld and In-Vehicle Electronics Committee.) Published by CONSUMER TECHNOLOGY ASSOCIATION 2017 Technology & Standards

9、Department www.cta.tech All rights reserved ANSI/CTA-2063 iFOREWORD This standard was developed by the Consumer Technology Associations R6 Portable Handheld and In-Vehicle Electronics Committee WG 23 Unmanned Aerial Systems. ANSI/CTA-2063 ii(This page intentionally left blank.)ANSI/CTA-2063 iiiCONTE

10、NTS 1 Scope . 1 2 References 1 2.1 Informative References 1 2.1.1 Informative Reference List . 1 2.1.2 Informative Reference Acquisition . 1 2.2 Compliance Notation 1 2.3 Symbols and Abbreviations 1 3 Serial Number General 1 3.1 Physical Serial Number 2 3.1.1 Physical Serial Number Format 2 3.2 Elec

11、tronic Serial Number . 2 3.2.1 Electronic Serial Number Format . 2 ANSI/CTA-2063 iv(This page intentionally left blank.)ANSI/CTA-2063 1Small Unmanned Aerial Systems Serial Numbers 1 Scope This standard outlines the elements and characteristics of a serial number to be used by small unmanned aerial s

12、ystems. 2 References 2.1 Informative References The following references contain provisions that, through reference in this text, constitute informative provisions of this standard. At the time of publication, the edition indicated was valid. All standards are subject to revision, and parties to agr

13、eements based on this standard are encouraged to investigate the possibility of applying the most recent edition of the standard indicated below. 2.1.1 Informative Reference List 1. 3GPP TS 23.003, Numbering, addressing and identification 2.1.2 Informative Reference Acquisition 1. 3GPP, 650, route d

14、es Lucioles, 06921 Sophia Antipolis Cedex, France, www.3GPP.org 2.2 Compliance Notation As used in this document “shall” and “must” denote mandatory provisions of the standard. “Should” denotes a provision that is recommended but not mandatory. “May” denotes a feature whose presence does not preclud

15、e compliance, and implementation of which is optional. “Optional” denotes items that may or may not be present in a compliant device. 2.3 Symbols and Abbreviations ESN Electronic Serial Number IMEISV International Mobile Station Equipment Identity and Software Version MFR Manufacturer PSN Physical S

16、erial Number UAS Unmanned Aircraft Systems 3 Serial Number General All UASs shall be assigned a unique serial number that becomes part of a Physical Serial Number (PSN), to be printed on the UAS, and an Electronic Serial Number (ESN) that may be associated with the UAS. ANSI/CTA-2063 23.1 Physical S

17、erial Number Each PSN shall comprise three basic components: the Manufacturers Code, the Length Code, and the Serial Number. CTA, in collaboration with all stakeholders, is responsible for developing and maintaining procedures that specify the procedure to be followed pertaining to the acquisition a

18、nd regulation of the PSN Manufacturers Codes. As Manufacturer Code Administrator, CTA manages the PSN Manufacturers Code component. The remaining segment of the PSN, the Serial Number, will be directly administered by the manufacturer to which the PSN Manufacturer Code is assigned. 3.1.1 Physical Se

19、rial Number Format The format of the PSN is: The Manufacturer (MFR) Code is a 4 character alphanumeric code (Note: MFR Codes shall include any combination of digits and uppercase letters, except the letters O and I, but may include all digits.) The Length Code is a single alpha character that corres

20、ponds to the number of characters in the serial number that is included in the PSN. The alpha characters range from A to T signifying the range of 1 to 20 characters in the serial number (e.g., A = 1, B=2, H=8, T=20). The Length Code will not be included in the ESN. The Serial Number, which is gener

21、ated by the manufacturer, is an alphanumeric code with a maximum of 20 characters (Note: Serial Number shall include any combination of digits and uppercase letters, except the letters O and I, but may include all digits.) The actual number of characters used by the manufacturer shall be indicated b

22、y the preceding Length Code. Example: MFR1L123456789ABC MFR Code = MFR1 Length Code = L, signifying 12 characters in the following SERIAL NUMBER Serial Number = 123456789ABC 3.2 Electronic Serial Number Each ESN shall comprise four basic components: the Manufacturers Code, the Serial Number, the IME

23、ISV Identifier, and Performative Characteristics. 3.2.1 Electronic Serial Number Format The format of the ESN is: The ESN is a fixed format and therefore when transmitted the ESN is always transmitted as 47 characters. PSN = Manufacturers CodeLength Code Serial Number PSN = 4 Character MFR CODE 1 ch

24、aracter LENGTH CODE20 character SERIAL NUMBER ESN = Manufacturers Code Serial Number IMEISV Performative Characteristics ESN = 4 Character MFR CODE 20 character SERIAL NUMBER 16 character IMEISV 7 Performative Characteristics ANSI/CTA-2063 3The Manufacturer (MFR) Code is a 4 character alphanumeric c

25、ode as defined in Section 3.1.1 Physical Serial Number. The Serial Number, which is generated by the manufacturer, is a 20 character alphanumeric code as defined in Section 3.1.1 Physical Serial Number. This serial number shall be represented electronically using ASCII coding of the serial number ch

26、aracters. The serial number shall be a fixed length of 20 bytes. If the physical serial number is less than 20 characters the manufacturer shall pad the serial number with leading bytes with the value 0x00. Example: The Physical Serial Number in the example in 3.1.1 would be represented as the hex s

27、tring: MFR Code SN 4D 46 52 31 00 00 00 00 00 00 00 00 31 32 33 34 34 36 37 38 39 41 42 43 Note: there is no Length Code in the Electronic Serial Number. The International Mobile Station Equipment Identity and Software Version Number (IMEISV) is16 character decimal digit code and shall be defined by

28、 3GPP TS 23.003. Per 3GPP TS 23.003, the IMEISV includes the following: Type Allocation Code (TAC) 8 digits. Serial Number (SNR) in an individual serial number uniquely identifying each equipment within each TAC 6 digits. Software Version Number (SVN) identifies the software version number of the mo

29、bile equipment up to 2 digits. If an IMEISV is not used, the IMEISV field shall be filled with 16 bytes with the value 0x00. Seven characters are reserved for performative characteristics of the UAS where the first character indicates the standards body from which the following 6 performative charac

30、teristics are defined. CTA will manage the assignment of the code for the standards body responsible for defining the performative characteristics. If any of the 7 performative characteristics characters are not used they shall be padded with bytes with the value 0x00. Consumer Technology Associatio

31、n Document Improvement Proposal If in the review or use of this document a potential change is made evident for safety, health or technical reasons, please email your reason/rationale for the recommended change to standardsCTA.tech. Consumer Technology Association Technology & Standards Department 1919 S Eads Street, Arlington, VA 22202 FAX: (703) 907-7693 standardsCTA.tech