ARMY A-A-52299 B-2004 LEVELS SURVEYING LOCATOR'S HAND-TYPE《测水准仪 定位器 手动型》.pdf

1、Comments, suggestions, or questions on this document should be addressed to: U.S. ARMY TOPOGRAPHIC ENGINEERING CENTER, ATTN: CEERD-TS-T, 7701 TELEGRAPH ROAD, ALEXANDRIA, VA 22315-3864 or emailed to pd-tetec.army.mil . Since contact information can change, you may want to verify the currency of this

2、address information using the ASSIST Online database at www.dodssp.daps.mil . FSC 6675 Distribution Statement A. Approved for public release; distribution is unlimited. INCH-POUND A-A-52299B 22 July 2004 SUPERSEDING A-A-52299A 29 August 1999 COMMERICAL ITEM DESCRIPTION LEVELS, SURVEYING: LOCATORS, H

3、AND-TYPE The General Services Administration has authorized the use of this Commercial Item Description (CID) for all federal agencies. The original issue of this CID replaced GG-L-261D. 1. SCOPE. 1.1 Abstract. This commercial item description covers hand held, surveying levels used for line of sigh

4、t determination of relative elevation. 2. CLASSIFICATION: 2.1 Type. The hand levels shall be of the following types as specified (see 6.2): Type I Non-telescoping. Type II Telescoping (draw tube). 3. SALIENT CHARACTERISTICS. 3.1 Construction. The hand level, regardless of type, shall have the follow

5、ing characteristics: a. A tubular body with an objective lens at one end and at the other, a removable eyepiece suitably sealed to preclude the entry of dust into the instrument. b. Horizontal and vertical cross hairs for use in determining the exact target intercept and vertical orientation of the

6、level. c. An integral focusing arrangement to accommodate the individual eye. d. A permanently mounted instrument level to indicate when the line of sight is horizontal. e. A mechanism that shall project the image or readout of the level indicator magnified 4x to one side of the field of view. f. A

7、lanyard to suspend the instrument from the users neck. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-A-A-52299B 23.2 Configuration. The levels shall be constructed in accordance with the following: a. Type I. The tubular body shall be non-telescoping

8、, with no magnification of the field of view. The overall length of the level shall not be greater than 6.5 inches. b. Type II. The tubular body shall telescope, to afford a 2X magnification of the field of view. With the telescoping portion fully retracted, the overall length of the level shall not

9、 be greater than 6.5 inches. 3.3 Level indicator. The instrument level indicator shall be accurate to within a 0.25 percent gradient from horizontal and shall maintain this accuracy in normal use, handling, and storage for the life of the instrument. 3.4 Carrying case. A carrying case, to fit and pr

10、otect the instrument, shall be provided with each level. The case shall have a securable closure and a loop(s) compatible with a belt 3.00 inches wide. The carrying case shall be fungus resistant. 4. REGULATORY REQUIREMENTS. 4.1 Recycled, recovered, or environmentally preferable materials. The offer

11、or/contractor is encouraged to use recovered materials to the maximum extent practicable, in accordance with paragraph 23.403 of the Federal Acquisition Regulation (FAR). 5. QUALITY ASSURANCE PROVISIONS. 5.1 Market acceptability. The levels offered shall be the latest version of the standard product

12、 of the supplier, that has been used in the field for at least one year by commercial organizations. 5.2 Product conformance. The levels offered shall meet the salient characteristics of this CID, conform to the manufactures drawings, specifications, standards, and quality assurance practices, and b

13、e the same product offered for sale in the commercial market. The government reserves the right to require proof of such conformance. 5.3 Examination. The levels shall be examined for compliance with requirements specified in Section 2. Each element of inspection shall encompass all examinations of

14、performance and dimensional requirements. Failure to comply with any specified requirement, or the presence of one or more defects lessening required capabilities, shall constitute cause for rejection. 6. PACKAGING. 6.1 Packaging. Preservation, packing, and marking shall be as specified in the contr

15、act or order (see 7.2) 7. NOTES 7.1 Intended use. The levels are intended to be used to determine approximate differences in elevation, between points a short distance apart. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-A-A-52299B 37.2 Ordering data

16、. Acquisition documents must specify the following: a. Title, number, and date of this document. b. Type of level required (see 2.1). c. Level of preservation and packing required (se 6.1). 7.3 Data requirements. The contracting officer should include, in the contract or order, requirements for inst

17、ructional material and other documentation normally supplied with the level when sold on the commercial market. 7.4 Part identification number (PIN). The following part identification numbering procedure is for government purposes and does not constitute a requirement for the contractor.This example

18、 describes a part numbering system for CID A-A-52299B AA52299I Level type I = Non-telescoping II = Telescoping, 2X magnification Document identifier 7.5 National Stock Numbers (NSNs). The following NSN is assigned to a product that conforms to this CID: 6675-00-880-1820. This may not be indicative o

19、f all possible NSNs associated with the CID. 7.6 Subject term (key word) listing. Measure, plane Optics Telescoping Transit Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-A-A-52299B 4The preparing activity for this document is: The U.S. Army Topograph

20、ic Engineering Center, 7701 Telegraph Road, Alexandria, VA 22315-3864. Custodian: Preparing activity: Army - CE3 Army - CE3 Air force - 99 (Project 6675-0168) DLA IS Navy YD Review activities: Army - CR Navy - MC Civil Review Agency: GSA - FSS Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-