1、INCH- POUND MIL-C-48697 (AR) AMENDMENT 5 SUPERSEDING AMENDMENT 4 3 April 1995 31 May 2000 MILITARY SPECIFICATION CARTRIDGE, 60MM, TP, M50A3 LOADING, ASSEMBLING AND PACKING IMIL-C-48697 was inactivated after 13 Auqust 1997 for new desiqn This amendment forms a part of MIL-C-48697(AR), dated 11 August
2、 1987, and is approved for use by the U.S. Army Armament Research, Development and Engineering Center, and is available for use by all Departments and Agencies of the Department of Defense. PAGE 3 * 3.3.5, Add new sentence as follows: ?When a round is less than 80% of average horizontal range but no
3、t less than 60% of average horizontal range (calculated without this round), this round shall not be included in the calculation of range precision.? * 3.3.5.1, Delete ?80 percent? and substitute ?60 percent?. PAGE 6 * 4.4.2, Delete in its entirety and substitute: ?4.4.2 Examination. See MIL-A-48078
4、. a. Sampling plans. Unless otherwise specified in the classification of defects and test tables, sampling plans for major and minor defects shall be in accordance with MIL-STD- 105, Inspection Level II.? 1 of 3 AMSC N/A FSC 1310 DISTRIBUTION STATEMENT A. Approved for public release; distribution is
5、 unlimited. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-C-48697 (AR) AMENDMENT 5 PAGE 10 4.4.2.4, Critical Defect 2, Delete in its entirety. Major 101, Delete in its entirety. Major 103, Delete: “(except as described by Critical 2 above) . Ma
6、jor 105 and 106, Add as follows: “105 Sealing compound bead improperly located, missing or not full 360 degrees in base of cartridge housing cavity (prior to insertion of ignition cartridge) . Visual 106 Sealing compound bead improperly located, missing or not full 360 degrees on red end of ignition
7、 cartridge (prior to seating of primer into fin cavity) . Visual“. Major 107 and 108, Add as follows: “107 Fuze not fully seated . 0.40% . 3.2 . Visual 108 Fin and fin extension not fully seated . 0.40% . 3.2 . Visual“. * Major 109 and 110, Delete in their entirety. Minor 203, Delete in its entirety
8、. PAGE 11 * 4.4.2.5, Major Defect 101, Delete and substitute: “101 Propellant sheets damaged . 100% . 3.2 . Visual“. PAGE 14 * Change 4.4.3.2f to read as follows: Iff. Short rounds (horizontal range less than 60 percent of average horizontal range), Critical defect (see 3.3.5.1).“ * Add new paragrap
9、h 4.4.3.29- as follows: Ilg. Short rounds (horizontal range less than 80 percent of average horizontal range but not less than 60 percent of horizontal range) , Major defect .I 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-C-48697 (AR) AMENDM
10、ENT 5 PAGE 14 (cont) * Change 4.4.3.2.1 to read as follows: !IC. One or more short rounds with less than 60 percent of average horizontal range occur.” * Add new paragraph 4.4.3.2.19- as follows: Ilg. Two or more short rounds with less than 80 percent of average horizontal range but not less than 60
11、 percent of horizontal range occur.” * Change 4.4.3.2.2 to read as follows: !IC. One or more short rounds with less than 60 percent of average horizontal range occur.” PAGE 15 * Add new paragraph 4.4.3.2.29- as follows: Ilg. Two or more short rounds with less than 80 percent of average horizontal ra
12、nge but not less than 60 percent of horizontal range occur.” The margins of this amendment are marked with an asterisk or vertical lines to indicate where changes (modifications, additions, corrections, deletions) from the previous amendment were made. This was done as a convenience only and the Gov
13、ernment assumes no liability whatsoever for any inaccuracies in this notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous amendment. Custodian: Army-AR Preparing activity: Army-AR (Project 1310 - 0594) 3 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
copyright@ 2008-2019 麦多课文库(www.mydoc123.com)网站版权所有
备案/许可证编号:苏ICP备17064731号-1