ARMY MIL-DTL-3628 138A-2000 BADGE IDENTIFICATION POLICE CAP DEFENSE PROTECTIVE SERVICE OFFICE OF THE SECRETARY OF DEFENSE.pdf

1、AMSC N/ A 1 of 2 FSC 8455DISTRIBUTION STATEMENT A . Approved for public release; distribution is unlimited.INCH-POUNDMIL-DTL-3628/138A21 September 2000SUPERSEDINGMIL-DTL-3628/13815 November 1996DETAIL SPECIFICATION SHEETBADGE, IDENTIFICATION, POLICE, CAP, DEFENSE PROTECTIVE SERVICE,OFFICE OF THE SEC

2、RETARY OF DEFENSEInactive for new design after 13 January 1999.This specification is approved for use by all Departments and Agenciesof the Department of Defense.The requirements for acquiring the product described herein shall consist of thisspecification sheet and the issue of MIL-DTL-3628 listed

3、in that issue of the Department ofDefense Index of Specifications and Standards ( DoDISS) specified in the solicitation.MATERIAL: Gilding MetalFINISH: Hard Enameled, Soft Baked Enameled, Gold Plated, Mirror-like Polished andshall match The Institute of Heraldry (TIOH) Metal Finish Chip Number 6.DIME

4、NSIONS:HEIGHT (overall) 3 inches (REF)WIDTH (overall) : 2 inches (REF)THICKNESS (at “POLICE“ lettering) : 0.085 inch 0.010 inchProvided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-3628/138A2 of 2NOTES:1. The term (REF) refers to the measurements t

5、aken from the Government furnishedhub or die. TIOH Drawing Number B-16-10 may be used as additional reference.2. A full forcer shall be used to bring up the details of the design.3. Piercing shall be as indicated.4. Epoxy resin (stoning epoxy) may be used in lieu of both hard enamel and softbaked en

6、amel at the option of the manufacturer. When epoxy resin is used in lieu of softbaked enamel , the epoxy resin shall not be stoned. Enamel and epoxy colors shallconform to TIOH Hard Enamel Chip Numbers listed below:COLOR CHIP NUMBERGreen 12Black 26Blue 335. The attaching device shall be a screw post

7、 and thumb nut with two registeringprongs.a. The screw post shall be located on the vertical center line of the badge 1-3/4 inch 1/64 inch from the bottom of the badge.b. The registration prongs shall be located on a horizontal line 1 /8 inch 1/64 inchin from the widest portion of the top of the shi

8、eld on each side.c. The screw post shall be 9/16 inch 1/32 inch long and 0.125 inch 0.10 inch indiameter and shall have a NO. 5-4 OUNC-2A thread.d. The thumb nut shall be 0.625 inch 0.010 inch in diameter and shall have a NO.5-4 OUNC-2B thread.e. The registration prongs shall be 1 /4 inch 1/64 inch

9、in length and 0.045 inch 0.002 inch in diameter.CHANGES FROM PREVIOUS ISSUE : Marginal notations are not used in this revision toidentify changes with respect to the previous issue due to the extent of the changes.Custodian: Preparing activity:Army - IH Army - IHReview activities: (Project No. 8455-0027)DLA - CTProvided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-