ImageVerifierCode 换一换
格式:PDF , 页数:3 ,大小:109.53KB ,
资源ID:446940      下载积分:10000 积分
快捷下载
登录下载
邮箱/手机:
温馨提示:
如需开发票,请勿充值!快捷下载时,用户名和密码都是您填写的邮箱或者手机号,方便查询和重复下载(系统自动生成)。
如填写123,账号就是123,密码也是123。
特别说明:
请自助下载,系统不会自动发送文件的哦; 如果您已付费,想二次下载,请登录后访问:我的下载记录
支付方式: 支付宝扫码支付 微信扫码支付   
注意:如需开发票,请勿充值!
验证码:   换一换

加入VIP,免费下载
 

温馨提示:由于个人手机设置不同,如果发现不能下载,请复制以下地址【http://www.mydoc123.com/d-446940.html】到电脑端继续下载(重复下载不扣费)。

已注册用户请登录:
账号:
密码:
验证码:   换一换
  忘记密码?
三方登录: 微信登录  

下载须知

1: 本站所有资源如无特殊说明,都需要本地电脑安装OFFICE2007和PDF阅读器。
2: 试题试卷类文档,如果标题没有明确说明有答案则都视为没有答案,请知晓。
3: 文件的所有权益归上传用户所有。
4. 未经权益所有人同意不得将文件中的内容挪作商业或盈利用途。
5. 本站仅提供交流平台,并不能对任何下载内容负责。
6. 下载文件中如有侵权或不适当内容,请与我们联系,我们立即纠正。
7. 本站不保证下载资源的准确性、安全性和完整性, 同时也不承担用户因使用这些下载资源对自己和他人造成任何形式的伤害或损失。

版权提示 | 免责声明

本文(ARMY MIL-P-70762 (2)-1996 PROPELLANT COMPOSITE CAST FOR USE IN SIMULATOR MISSILE SAGGER XM27《赛格(SAGGER)XM27式导弹仿真器用模铸复合推进剂》.pdf)为本站会员(inwarn120)主动上传,麦多课文库仅提供信息存储空间,仅对用户上传内容的表现方式做保护处理,对上载内容本身不做任何修改或编辑。 若此文所含内容侵犯了您的版权或隐私,请立即通知麦多课文库(发送邮件至master@mydoc123.com或直接QQ联系客服),我们立即给予删除!

ARMY MIL-P-70762 (2)-1996 PROPELLANT COMPOSITE CAST FOR USE IN SIMULATOR MISSILE SAGGER XM27《赛格(SAGGER)XM27式导弹仿真器用模铸复合推进剂》.pdf

1、 MIL-P-70762 (2) 9999906 2016662 319 MILITARY I INCH-POUNDI MIL-P-70762 (AR) AMENDMENT 2 SUPERSEDING AMENDMENT 1 30 September 1991 O1 Februarv 1996 SPECIFICATION PROPELLANT, COMPOSITE, CAST, FOR USE IN SIMULATOR, MISSILE: SAGGER XM27 This Amendment forms a part of Military Specification MIL-P- 70762

2、 (AR), dated 12 April 1990, and is approved for use by the U;S. Army Armament, Research, Development and Engineering Center and is available for use by all Departments and Agencies of the Department of ,Defense. PAGE 1 * Title: Delete “SIMULATOR, MISSILE: SAGGER XM27“ and substitute “SIMULATOR, ANTI

3、-TANK GUIDED MISSTLE SIGNATURE: M27.“ PAGE 6 3.3.4 Delete “.890 50 calories per gram“ and substitute “850 2 50 calories per gram.“ PAGE 7 4.3.1 Delete paragraph 4.3.1 in its entirety and substitute the following paragraph: “4.3.1 Sub mission. The contractor shall submit a first article sample as des

4、ignated by the Contracting Officer for evaluation in accordance with the provisions of 4.3.2. The first article sample shall consist of five (5) blocks of propellant for lots of multiple mixer loads or three (3) blocks of propellant forlots of a single mixer load. The sample propellant shall have be

5、en vacuum cast and cured in accordance with note two (2) of drawing 12576572. Each block shall be large enough for all first article tests of Section 4.3.2, but -YSC N/A 1 of 3 FSC 1376 NT A. Approved for public release; distribution is unlimited. Provided by IHSNot for ResaleNo reproduction or netw

6、orking permitted without license from IHS-,-,-i MIL-P-70762 (AR) AMENDMENT 2 shall not be larger than 700 cubic inches. One of the five sample blocks shall be cast from the first mixer load and one from the last mixerload of the propellant lot. The three remaining sample blocks shall be randomly tak

7、en from the ,propellant mix if the lot contains more than one mixer load. If the lot is one mixer load, then one sample block shall be taken from the top, one from the bottom, and one from the middle. These samples shall be,obtained from the first production lot which has been produced by the contra

8、ctor using the same production process, procedures and equipment as will be used in fulfilling the contract. All material shall be obtained from the sources of supply as will be used in regular production. I PAGE 9 4.4.4 Delete paragraph 4.4.4 in its entirety, and substitute with: “4.4.4 mlitv confo

9、mce sou and testinq . The quality conformance sample shall consist of five (5) blocks of propellant for lots of multiple mixer loads or three (3) blocks of propellant for lots of a single mixer.load. These sample blocks shall have been vacuum cast and cured in accordance with note two (2) of drawing

10、 12576572. Each sample block shall be large enough to do the testing required but not larger than 300 cubic inches. One of the five sample blocks shallbe cast from the first mixer load and one from the last mixer load of propellant lot. The remaining three (3) sample blocks shall be randomly taken f

11、rom the propellant lot if a lot contains more than one mixer load. If the lot contains only one mixer load, then one sample block shall be cast from the top, one from the bottom, and one from the middle of the lot. Each of the sample blocks shall be subjected to all the tests of Section 3 and Sectio

12、n 4 of this specification. If any of the samples do not meet the requirements of Section 3, the lot shall be rejected.“ Note: The margins of this amendment are rkrked with asterisks to indicate where changes (additions, modifications, corrections, deletions) from the previous issue were made. This w

13、as done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the las

14、t previous issue. 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-Custodian: AITIIY - AR MIL-P-70762 (AR) AMENDMENT 2 Preparing activity: AW - AR (Project: 1376-0026) 3 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-

copyright@ 2008-2019 麦多课文库(www.mydoc123.com)网站版权所有
备案/许可证编号:苏ICP备17064731号-1