ImageVerifierCode 换一换
格式:PDF , 页数:3 ,大小:29.71KB ,
资源ID:447388      下载积分:10000 积分
快捷下载
登录下载
邮箱/手机:
温馨提示:
如需开发票,请勿充值!快捷下载时,用户名和密码都是您填写的邮箱或者手机号,方便查询和重复下载(系统自动生成)。
如填写123,账号就是123,密码也是123。
特别说明:
请自助下载,系统不会自动发送文件的哦; 如果您已付费,想二次下载,请登录后访问:我的下载记录
支付方式: 支付宝扫码支付 微信扫码支付   
注意:如需开发票,请勿充值!
验证码:   换一换

加入VIP,免费下载
 

温馨提示:由于个人手机设置不同,如果发现不能下载,请复制以下地址【http://www.mydoc123.com/d-447388.html】到电脑端继续下载(重复下载不扣费)。

已注册用户请登录:
账号:
密码:
验证码:   换一换
  忘记密码?
三方登录: 微信登录  

下载须知

1: 本站所有资源如无特殊说明,都需要本地电脑安装OFFICE2007和PDF阅读器。
2: 试题试卷类文档,如果标题没有明确说明有答案则都视为没有答案,请知晓。
3: 文件的所有权益归上传用户所有。
4. 未经权益所有人同意不得将文件中的内容挪作商业或盈利用途。
5. 本站仅提供交流平台,并不能对任何下载内容负责。
6. 下载文件中如有侵权或不适当内容,请与我们联系,我们立即纠正。
7. 本站不保证下载资源的准确性、安全性和完整性, 同时也不承担用户因使用这些下载资源对自己和他人造成任何形式的伤害或损失。

版权提示 | 免责声明

本文(ARMY MIL-PRF-49471 14 A-2000 BATTERY NON-RECHARGEABLE LITHIUM MANGANESE DIOXIDE HIGH PERFORMANCE BA-5374 U《BA-5374 U型高性能的锂 二氧化锰一次性电池》.pdf)为本站会员(outsidejudge265)主动上传,麦多课文库仅提供信息存储空间,仅对用户上传内容的表现方式做保护处理,对上载内容本身不做任何修改或编辑。 若此文所含内容侵犯了您的版权或隐私,请立即通知麦多课文库(发送邮件至master@mydoc123.com或直接QQ联系客服),我们立即给予删除!

ARMY MIL-PRF-49471 14 A-2000 BATTERY NON-RECHARGEABLE LITHIUM MANGANESE DIOXIDE HIGH PERFORMANCE BA-5374 U《BA-5374 U型高性能的锂 二氧化锰一次性电池》.pdf

1、 INCH - POUND MIL - PRF - 49471/14A(CR) 30 November 2 000 Superseding MIL - PRF - 49471/14(CR) 20 April 1998 PERFORMANCE SPECIFICATION SHEET BATTERY, NON - RECHARGEABLE, LITHIUM MANGANESE DIOXIDE, HIGH PERFORMANCE, BA - 5374/U This specification is approved for use wi thin the Communications Electro

2、nics Command, Department of the Army, and is available for use by all Departments and Agencies of the Department of Defense. The requirements for acquiring the product herein shall consist of this specification sheet and MIL - PRF - 49471(CR). Figure 1. Battery dimensions and terminal markings . AMS

3、C N/A Page 1 of 3 FSC 6135 DISTRIBUTION STATEMENT A. Approved for public release; distributi on is unlimited. Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL - PRF - 49471/14A

4、( CR) 2 NOTES : 1. All dimensions are in inches. Fractional tolerances are + 1/32” 2. +6V markings required on battery near or on the positive terminal. REQUIREMENTS : Dimensions and configuration: See figure 1. Maximum voltage: 6.6 volts Cut - off voltage for capacity: 4 volts Terminals: Flat surfa

5、ce (see figure 1). Weight (Maximum): 2.5 ounces (71 grams). Charge protection: Not applicable. Battery short circuit test: Applicable. High temperature protection: Applicable. Comp lete discharge device: Not applicable. State of Charge Indicator: Not applicable. Capacity tests: When the battery is t

6、ested in accordance with the methods of examination and tests of this specification, the minimum capacity test requirements shall be as specified below. Capacity test Minimum Capacity in Hours to 4.0 volts I 22 L 10 H 21 HT 18 LT 9 IT 21 LR1 48 Initial voltage delay: During all tests except the LR1,

7、 initial voltage below 4.0 volts cannot exceed a 0.1 second duration. Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL - PRF - 49471/14A( CR) 3 METHODS OF EXAMINATION AND TEST

8、: (1) Storage: Details on storage conditions for all specified capacity tests are described in the basic specification. (2) Discharge Cells (Forced Discharge): Two cells shall be discha rged at 45 milliamperes at 70 + 5F to 2.0 volts. Each discharged cell shall then be connected in series with one f

9、resh cell. Each string shall then be force discharged at 45 milliamperes at 70 + 5F for 22 hours. Batteries: For all capacity tests except t he LR1, the batteries shall be discharged at 45 milliamperes constant current to cut - off volts (zero volts for the I test). For the LR1 test, batteries shall

10、 be discharged at 25 milliamperes to 4.5 volts, then at 0.4 watts to 3.5 volts. Forced Discharge: After the batteries have been discharged to zero volts on the I test, batteries shall be force discharged at 45 milliamperes for a minimum of 5 minutes. Overload: Batteries shall be discharged at 100 mi

11、lliamperes. Abuse test predischarge: Designated samples shall be discharged at 45 milliamperes for 11 hours. Abuse test, pulse discharge: Batteries shall be discharged at 90 milliamperes for 1 minute followed by 40 milliamperes for 4 minutes, cycled continuously to cut - off voltage. Closed circuit

12、vol tage (battery and cell strings): Load resistance of 90 ohms shall be used. Voltage shall be above 4.0 volts within 5 seconds. Cell closed circuit voltage: Load resistance of 45 ohms shall be used. Voltage shall be above 2.0 volts within 5 seconds. Ma rginal notations are not used in this revisio

13、n to identify changes with respect to the previous issue due to the extent of the changes. Custodian: Preparing activity: Army - CR Army - CR (Project 6135 - 0417 - 14) Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-

copyright@ 2008-2019 麦多课文库(www.mydoc123.com)网站版权所有
备案/许可证编号:苏ICP备17064731号-1