ARMY MIL-T-50611 (1)-1993 TRINITRORESORCINOL (STYPHNIC ACID)《(收敛酸)三硝基间苯二酚》.pdf

1、LINCH-POUND 1 MIL-T-50611 (AR) AMENDMENT 1 26 October 1993 MILITARY SPECIFICATION TRINITRORESORCINOL (STYPHNIC ACID) This Amendment forms a part of Military Specification MIL-T-50611 (MU), dated 6 May 70, and is approved for use within the U.S. Army Armament, Munitions and Chemical Command and is av

2、ailable for use by all Departments and Agencies of the Department of Defense. PAGE 3 3.2 Add : Table I, Chemical and Physical Properties: ProDe rtv Moi s t Ure, alternate, percent (for =Q!Eu 20% min. “me II 20% min. on-site use to produce lead styphnate only) NOTE: tured on a facility and to be used

3、 on that same facility and will not be packaged and shipped to another facility.“ “On-site use“ applies to the trinitroresorcinol manufac- 1 Of 2 RYSC K/A O FSC 1376 DISTRIBUTION STATEMENT k. Approved for public release; distribution is unlimited. Provided by IHSNot for ResaleNo reproduction or netw

4、orking permitted without license from IHS-,-,-MIL-T-50611 (AR) AMENDMENT 1 PAGE 5 4.5.1 Test Procedure. mo- : Delete “Transfer 3 grams of the sample to a tared weighing dish (6 cm in diameter). Break up any lumps with a spatula, cover the weighing dish and weigh the dish plus sample. Uncover the dis

5、h and heat at 68 $r 2 degrees C for 8 to 16 hours. Cool in desiccator containing drierite or an- hydrone and weigh. Calculate the percent moisture as follows:“ and substitute the following: “Transfer 2-6 grams of the sample to a tared weighing dish. Break up any lumps with a spatula, cover the weigh

6、ing dish and weigh the dish plus sample. Uncover the dish and heat at 68 - + 2 degrees C for a minimum of 4 1/2 hours. Cool in a desiccator containing a suitable desiccant (drierite, anhydrone, etc.) and weigh. Calculate the percent moisture as follows:“ PAGE 10 4.5.8 Sulfate: Delete “Transfer 5 gra

7、ms of the dried sample to a 250 ml. beaker“, and substitute the following: “If a dried sample is not available, transfer 6 to 8 grams of a wet sample to a porcelain dish, a watch glass, or a conductive container at least 5 cm in diameter. Break up any lumps with a conductive spatula. Heat uncovered

8、at 68 2 2 degrees C for a minimum of 4.5 hours. Cool for a minimum of 15 minutes in a desiccator. Transfer approximately 4 to 6 grams of the dried sample to a tared, 250 ml beaker.“ Delete “42.02 (A-BI I and substitute “42.02 (A-BI I. B w Custodian: Army-AR Preparing activity: Aw-AR ( Pro j ect 13 7 6 -A4 66 ) 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-