DLA A-A-50366 A-1996 SWEATER MAN-S WOOL《男式羊毛毛线衫》.pdf

1、A-A-503bbA 9999974 OL29bL bT m IINC“D1 A-A-50366A A-A-50366 March 1,1989 COMMERCIAL ITEM DESCRIPTION SWEATER, MANS, WOOL The General Services Administration has authorized the use of this commercial item description for all Federal agencies. 1. SCOPE. This commercial item description covers the requ

2、irements for the mans wool sweater intended for use by male Navy personnel as part of the utility uniform. 2. CLASSIFICATION. The sweater shall be one type and color in the following sizes: Extra-Small (32-34) Large (44-46) Medium (40-42) Small (36-38) Extra-Large (48-50) 3. SALENT CHARACTERISTICS 3

3、.1 Description. The sweater shall be a pullover style; with or without side seams; a one-piece mock-turtle neck (crew) collarette; rib knit skirt; and set-in long sleeves with rib knit cuffs. The collarette may be tubular or with one seam at the left shoulder. The shoulder seams shall be reinforced

4、with a black, 3/16 inch cotton tape. The skirt and cuffs shall be an integral part of the body sleeves (not seamed or looped). The color of the sweater shall be Navy Blue shade 3346. The skirt and cuff shall finish not less than 3-1/4 inch nor more than 3-3/4 inches in height (course direction). The

5、 collarette shall not finish not less than 2 inches nor more than 2-1/2 inches in height (course direction) (see Figure 1). Beneficial comments, recommendations, additions, deletions, clarifications, etc. and any data which may improve this document should be sent to: Defense Personnel Support Cente

6、r, Clothing and Textiles Directorate, Attn: DPSC-FNS, 2800 South 20th Street, Philadelphia, PA 19 145-5099. AMSC N/A FSC 8405 DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IH

7、S-,-,-A-A-50366A Characteristic Type of knit stitch: Body Skirt Sleeves Cuffs Collarette Waleslcourses per inch (min.) Body Skirt Sleeves Cuffs Collarette Colorfastness to: Light Laundering Wet-Drycleaning Perspiration Crocking Non-fibrous material content (percent, max.) - 1/ One determination shal

8、l be performed in pH 3.2 Material. Requirements Test method Jersey Visual I/ 2x2 rib Visual I/ Jersey Visual 11 2x2 rib Visual i/ 1x1 rib Visual I/ Wales Courses 6 9 ASTM-D-3887 6 11 ASTM-D-3887 6 9 ASTM-D-3 887 6 11 ASTM-D-3 8 87 13 21 ASTM-D-3887 Good 21 3.5 Good 21 AATCC 132 Good 21 AATCC 15 z/ 3

9、 .O AATCC 8 3.0 ASTM-D-629, Section 9 AATCC 16, Opt. A AATCC 6 1, Test IA 3/ 4 4.0-8.0 FED-STD-191, TM 2811 each area of the sample unit, and the results reported 3.2.1 Basic material. The sweater shall be made of 2-ply worsted made of fleece or pulled sheeps wool or a combination of both not lower

10、in grade than 54s US Standard. The use of reprocessed, reused, or waste wool is prohibited. The wool shall be mothproofed. The color shall match the standard sample under artificial daylight having a color temperature of 7500 K and shall be a good approximation to the standard sample under incandesc

11、ent lamplight at 2800 K. The finished fabric shall contain not less than 95 percent wool based on the dry weight of the desized specimen. The sweater shall conform to the requirements listed in Table I. TABLE I. Sweater physical requirements 3.2.2 Thread. The thread for seaming and stitching the swe

12、ater shall be cotton or nylon-covered polyester and the shade shall approximate the knit fabric. 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-503hhA 9999974 0372763 470 W A-A-50366A XSmall (32-34) Small (36-38) Medium (40-42) Large (44-46) X

13、-Large (48-50) 8 lbs., 4 oz. 9 lbs., 8 oz. 10 lbs., 8 oz. 12 lbs. 14 lbs. 3.3 Label. A commercial-type label is acceptable, provided that an additional printed cloth label containing the contractors name, contract number, size and National Stock Number (NSN) is caught on the stitching of the commerc

14、ial label. The commercial label shall include fiber and laundering information. The laundering instructions shall be as follows: HAND LAUNDER IN LUKEWARM WATER USING A MILD SOAP. DO NOT WRING OR TWIST. RINSE IN CLEAR COLD WATER, RESHAPE, AND DRY FLAT. 3.3.1 Labelhag. Each item shall be individually

15、bar-coded with a paper tag for personal clothing items. The paper tag shall be standard bleached sulfate having a basis weight of 100 pounds. The paper used for the tags shall have a smooth finish to accept thermal transfer and direct printing. The tags shall be clearly legible and readable by a sca

16、nner. The bar coding element shall be a 13 digit national stock number (NSN). The bar code type shall be a medium to high code density and shall be located so that it is completely visible on the item when it is folded and/or packaged as specified and so that it causes no damage to the item. 3.4 Wei

17、ghts. The weights of the finished sweater shall be as specified in Table II: TABLE II. Finished weights of sweaters L/ 3.5 Sizes and measurements. The finished sweater shall conform to the measurements in Table III. The measurements and tolerances are expressed in inches. TABLE III. Finished measure

18、ments A. B. C. D. E. F. I Extra-Large (48-50) I 9 1 23 I 28-1/2 I 24-1/2 I 9-1/4 I 3-1/2 I 7 Neck width. Measurement shall be taken from the intersection of the collarette seam and shoulder seam across neck front to similar intersection on opposite side. Chest. Measurement shall be taken across fron

19、t approximately 1 inch below armhole seams, folded edge to edge. When two full side seams are used, measure from seam to seam. Length. Measurement shall be taken from the intersection of the collarette seam and shoulder seam perpendicular to bottom edge of skirt. Overarm sleeve length. Measurement s

20、hall be taken along outside folded edge of sleeve from the intersection of the armhole seam and shoulder seam to the bottom edge of the cuff. Armhole length. Measurement shall be taken from the intersection of the armhole seam and shoulder seam on a straight line to the intersection of the armhole s

21、eam and sleeve inseam. Cuff width. Measurement shall be taken at center of wristlet on a straight line, folded edge to seamed edge. 3 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-503bbA 7999974 0372964 307 A-A-50366A i G. Sleeve length. Measur

22、e across width from the folded edge to the sleeve seam at a point 12 inches below the shoulder NOTE: For location of A-G, see Figure 1. 4. QUALITY ASSURANCE PROVISIONS 4.1 Product Conformance. The products offered shall meet the salient characteristics of this commercial item description, conform to

23、 the producers own drawings, specifications, standards, and quality assurance practices, and be a similar product that is offered for sale to the commercial market. The Government reserves the right to require proof of such conformance. 4.2 Market acceptance criteria. The item offered, or a generic

24、equivalent, must have been sold to the commercial market or to the Government for at least two years. 4.3 Visual examination. Each sweater shall be examined for the defects listed below. 4.3.1 Defects. Any hole, cut, mend, or tear; broken or missing yarn or stitch; any uneven diameter yarn; color no

25、t as specified; shaded part or shade variation; any spot or stain (outside); thread ends not trimmed; any component part not as specified or omitted; seam puckered, distorted, pleated, irregular, or open; loose or tight tension; any material defects, distorted parts or poor workmanship; any componen

26、t part omitted; missing, broken, or misplaced button; buttonhole missing; improper size; misaligned; not cleanly or formed; label missing, incorrect, or illegible; measurement of item not as specified; bar code omitted or not readable by scanner; human-readable interpretation (HRI) omitted or illegi

27、ble; bar code not visible on folded, packaged item; bar code causes damage to the item; any items not packaged in accordance with the contract or purchase order. 4.4 Acceptance criteria. Acceptance criteria shall be as specified in the contract or purchase order. 5. PACKAGING 5.1 Preservation, packi

28、ng, and marking. The preservation, packing, and marking shall be as specified in the contract or purchase order. 6. NOTES 6.1 Source of Government documents. Copies of military and Federal documents are available from: Standardization Documents Order Desk Bldg. 4D 700 Robbins Avenue Philadelphia, PA

29、 19 1 1 1-5094 6.2 Source of non-Government documents ASTM Test Methods 4 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-503bbA 9999974 0372965 243 A-A-50366A (Applications for copies should be addressed to American Society For Testing and Mater

30、ials (ASTM), 100 Barr Harbor Drive, West Conshohocken, PA 19428-2959.) AATCC Test Method (Applications for copies should be addressed to American Association of Textile Chemists and Colorists (AATCC), P.O. Box 12215, Triangle Park, NC 27709-2215.) MILITARY INTERESTS: Custodian: Navy - NU CIVIL AGENC

31、Y COORDINATING ACTIVITY: GSA - FSS PREPARING ACTIVITY: DLA - CT Project 8405-0305 5 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,- A-A-503bbA 74 OL72bb L8T A-A-50366A PIGUIBE I. SWEATEBB, MAWS, WIDIDL 6 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-