FORD FLTM BN 014-3-2001 FRICTION TEST FOR AUTOMOTIVE SEAT MATERIALS.pdf

1、FORD LABORATORY TEST METHOD BN 014-03 2001 0822 FRICTION TEST FOR AUTOMOTIVE SEAT MATERIALS Revised Editorial - no technical change A. Cockman Application This procedure is used to determine the surface friction properties of truck fabrics. Apparatus Required Electronic Testing Machine Instron Model

2、 7M or equivalent. Source: Instron Corporation 100 Royal1 Street Canton, MA 02021 (781) 828-2500 Aluminum Plate 100 x 64 x 64 mm (3180 +/- 57 9). Pulley 38 mm diameter Load Cell Tensile load cell “C“. Available from Instron. Materials Required No. 10 Duck Fabric Masking Tape Conditioning and Test Co

3、nditions All test values indicated herein are based on material conditioned in a controlled atmosphere of 23 +/- 2 OC and 50 +/- 5 % relative humidity for not less than 24 h prior to testing and tested under the same conditions unless otherwise specified. I Date I Action I Revisions I Copynght02001,

4、 Ford Global Technologies, Inc FORD LABORATORY TEST METHOD BN 014-03 1. 2. 3. 4. 5. 6. 7. 8. 9. 1 o. 11. 12. Procedure Cut a 500 x 150 mm sample of truck fabric in both warp and filling direction and a 64 x 150 mm sample of No. 1 O duck fabric. Calibrate the instrument following the directions in th

5、e instruction manual. Set crosshead speed to 125 mm/rninute and chart speed to 250 mm/minute by using proper gear combination as shown in gear selection chart for various speeds (see manual). Set load scale to 22.2 N. Attach steel plate to crosshead. Mount the truck fabric on the aluminum plate and

6、fasten securely at each end with clamps or masking tape so that the fabric does not wrinkle when conducting test. Mount No. 10 duck fabric on the steel block and fasten securely with masking tape. Center the steel block on front edge of aluminum plate. Hook the wire in screw eye of the metal block,

7、through pulley on back edge of the aluminum plate and into the top jaws of the Instron. (See Figure 1 .) Start test with no tension and ignore first 25 mm of chart. Allow test to run at least 125 mm on the fabric. Record the surface friction in Newtons from the chart and report as required by the En

8、gineering Material Specification. Chemicals, materials, parts, and equipment referenced in this document must be used and handled properly. Each party is responsible for determining proper use and handling in its facilities. Page 2 of 3 Copynght02001, Ford Global Technologies, Inc FORD LABORATORY TE

9、ST METHOD BN 014-03 FRICTION TEST FOR AUTOMOTIVE SEAT MATERIALS n ALUMINUM PLATE RIC TO BE TESTED STEEL BLOCK STEEL MOUNTING PIN FOR INSTRON ALUMINUM PLATE AS MOUNTED TO BE PARALLEL TO MACHINE BASE Direction of pull on block to be slightly down by assembling fixture so that wire height at pulley is approximately 6 mm and wire height at block is approximately 25 mm. TEST APPARATUS Page 3 of 3 Copynght02001, Ford Global Technologies, Inc