FORD FLTM BN 023-2-2000 THICKNESS TEST FOR PADDING MATERIALS.pdf

1、 FORD LABORATORY TEST METHOD BN 023-02 Date Action Revisions 2000 12 01 Revised Rev Source address & updated L. Graham 1992 07 09 Printed copies are uncontrolled Page 1 of 3 Copyright 2000, Ford Global Technologies, Inc. THICKNESS TEST FOR PADDING MATERIALS Application This procedure is used to meas

2、ure the thickness of padding materials used for seating or acoustical applications. Apparatus Required Thickness Tester The instrument required for this test is a modified thickness tester. A sketch of the instrument is attached. This is the same instrument used in FLTM BN 123-01. Source: Randen Tec

3、hnologies, Inc. R. R. #5 Strathroy, Ontario N7G 3H6 Canada Tel: 519-245-6115 Fax: 519-245-5062 Dial Indicator The dial indicator, Model #362, with .001 inch graduations. Source: B.C. Ames Co. Waltham, MA Weights 1 weight of 0.5 lb. Conditioning and Test Conditions All test values indicated herein ar

4、e based on material conditioned in a controlled atmosphere of 23 +/- 2 C and 50 +/- 5 % relative humidity for not less than 24 h prior to testing and tested under the same conditions unless otherwise specified. FORD LABORATORY TEST METHOD BN 023-02 Page 2 of 3 Copyright 2000, Ford Global Technologie

5、s, Inc. Procedure 1. Balance the instrument by turning the counter weight at the rear until the upper plate is 1/2 inch from the surface of the lower plate. Care should be taken not to jar instrument severely after balancing as this will change counter weight setting. 2. Apply 1/2 lb weight to the u

6、pper platen and leave through entire test. 3. Adjust dial indicator to zero with platens in contact. 4. Place 12 by 12 inch sample of padding material over lower platen of instrument. If material appears to be of different densities, the higher density should be placed on the bottom. If material has

7、 attached sheeting or resinated surface, the sheeting or resinated surface should be placed on top. 5. Lower upper platen with weight in place onto sample. The platen should not be dropped on the material abruptly. The scale reading of the material should be made within 10 s after applying weight. R

8、eport test results as required by the material specification. Chemicals, materials, parts, and equipment referenced in this document must be used and handled properly. Each party is responsible for determining proper use and handling in its facilities. FORD LABORATORY TEST METHOD BN 023-02 Page 3 of 3 Copyright 2000, Ford Global Technologies, Inc. THICKNESS TEST FOR PADDING MATERIALS Measure-Matic Apparatus for Thickness Test