FORD FLTM BP 003-2-2000 FRICTION TEST FOR WEATHERSTRIP COATINGS.pdf

1、 FORD LABORATORY TEST METHOD BP 003-02 Date Action Revisions 2000 11 09 Revised Editorial no technical change A. Cockman 1992 07 29 Printed copies are uncontrolled Page 1 of 5 Copyright 2000, Ford Global Technologies, Inc. FRICTION TEST FOR WEATHERSTRIP COATINGS Application This procedure is used to

2、 determine the surface friction properties of coatings for weatherstrips (door, luggage compartment and roof rail). Apparatus Required Electronic Testing Machine Instron Mod el TM or equivalent. Accessories Tensile Load Cell CT Aluminum Plate 18 by 6 by 15/32 inches. Weight 5 lbs. Pulley 1 1/2 inch

3、diameter Conditioning and Test Conditions All test values indicated herein are based on material conditioned in a controlle d atmosphere of 23 +/ - 2 C and 50 +/ - 5 % relative humidity for not less than 24 h prior to testing and tested under the same conditions unless otherwise specified. Procedure

4、 1. Prepare test panel by cutting sections from the test weatherstrip and bond ing to an enameled panel as shown in the attached Figures 1 and 2. 2. Calibrate the instrument, following the directions in the instruction manual. 3. Set crosshead speed to 5 inches/minute and chart speed to 5 inches/min

5、ute by using proper gear combinat ions as shown in gear selection chart for various speeds (see manual). FORD LABORATORY TEST METHOD BP 003-02 Page 2 of 5 Copyright 2000, Ford Global Technologies, Inc. 4. Set load scale to 20 lbs. 5. Attach plate to crosshead. 6. Mount painted 4 by 12 inch metal pan

6、el prepared to ESB - M2P4 - A on aluminum plate with “C“ clamps. 7. Place test panel o n the painted panel and add 5 lb. weight as shown in the attached photograph. 8. Hook wire into hole in test panel, through pulley on the back edge of plate and into the jaw of the Instron unit. 9. Start test with

7、 no tension and allow to run at least 6 i nches on the painted panel. 10. Record the surface friction in pounds (maximum reading) and report as required by the material specification. Chemicals, materials, parts, and equipment referenced in this document must be used and handled properly. Each party

8、 is responsible for determining proper use and handling in its facilities. FORD LABORATORY TEST METHOD BP 003-02 Page 3 of 5 Copyright 2000, Ford Global Technologies, Inc. FRICTION TEST FOR WEATHERSTRIP COATINGS Figure 1 FORD LABORATORY TEST METHOD BP 003-02 Page 4 of 5 Copyright 2000, Ford Global Technologies, Inc. FRICTION TEST FOR WEATHERSTRIP COATINGS Figure 2 FORD LABORATORY TEST METHOD BP 003-02 Page 5 of 5 Copyright 2000, Ford Global Technologies, Inc. FRICTION TEST FOR WEATHERSTRIP COATINGS