FORD M2C95-A-2009 OIL LUBRICATING MEDIUM GRADE NON-DETERGENT《中等品质非清洁剂型润滑油》.pdf

1、 NON-PRODUCTION MATERIAL SPECIFICATION Material Name Specification Number Date Action Changes 2009 04 14 N-STATUS No Replacement Named L. Sinclair, FNA 1983 01 01 Page 1 of 2 OIL LUBRICATING, MEDIUM GRADE, M-2C95A NON-DETERGENT NOT TO BE USED FOR NEW DESIGN 1. SCOPE: The material desired under this

2、standard is a medium grade, non-detergent, petroleum (SAE 30) lubricating oil. 2. APPLICATION: This material is generally used for lubricating internal combustion engines which require non-detergent oil. 3. REQUIREMENTS: 3.1 VISCOSITY: (ASTM D 445) At 100 C 10.1 cSt (mm2/s) min At 40 C 108.4 cSt (mm

3、2/s) max 3.2 COLOR: (ASTM D 155) 6 max 3.3 FLASH POINT (ASTM D 92) 199 C min 3.4 FIRE POINT (ASTM D 92) 227 C min 3.5 POUR POINT (ASTM D 97) -3.89 C max 3.6 CARBON RESIDUE (Conradson) 0.5% max 3.7 COMPATIBILITY: All material to this Standard shall be compatible in all proportions with other material

4、s currently approved under these “M“ numbers. Separation, precipitation or flocculation of solids or gels shall not be permitted. 3.8 SUPPLIERS RESPONSIBILITY: All materials supplied to this Standard must be equivalent in all characteristics to the material upon which approval was originally granted

5、 and shall be suitable for the intended application. Changes in composition shall not be made without approval of the Plant Engineering Office, Manufacturing Staff. NON-PRODUCTION MATERIAL SPECIFICATION M2C95-A Page 2 of 2 4. APPROVAL OF NEW SUPPLIERS: Materials submitted by new manufacturers to thi

6、s Standards must have Industrial Hygiene, Environmental Engineering, Laboratory and Shop Trial approvals. Suppliers are required to complete and submit the Material Health and Safety Data Sheet, Form 1291, the Mandatory Reporting of Critical Materials, Form 68-100, prior to shop trial. Recommendatio

7、ns for the addition of new manufacturers to the Manufacturing Approved Source List (ASL) listing must be made in writing to the responsible Manufacturing Staff office by the appropriate Divisional Standards activity in accordance with Manufacturing Procedure IId1. 5. ENVIRONMENTAL CONTROL: Use of an

8、y material approved to this Standard must comply with the guidelines as established in the environmental review of the material, as they appear in the Materials and Toxicology (MATS) System. 6. HEALTH AND SAFETY: The following are recommended practices to be observed when working with petroleum prod

9、ucts: a. When contact with oil is unavoidable, impervious gloves should be worn as well as clean work clothes. b. When skin exposure cannot be avoided, removal of oil from the skin should be as prompt as possible. A mild soap or skin cleanser and water should be used to remove oil. Industrial solvents should not be used to clean the skin. c. All skin rashes,lesions, cuts and abrasions should receive prompt medical attention.