FORD SB1-19-1988 NEOPRENE COATED GAUNTLET GLOVE《氯丁橡胶涂层的长防护手套》.pdf

1、FORD MANUFACTURING STANDARDS SBl-19 JULY, 1988 NEOPRENE COATED GAUNTLET GLOVE SBl-19 Page 1 1. 2. 3. 4. 5. 6. USE: Designed for handling sharp objects in bath solutions. Recommended for protection agains.t oils, acids, alkali and brake fluid. The actual use of this glove shall be approved by the Saf

2、ety Unit. Additional information regarding glove usage can be found in industrial Hygiene- Technical Bulletin No. 8 data 212976 entitled Skin Protection From Chemicals - Glove Selection. RATERIAL: Neoprene coating shall meet the minimum requirements of SAE J200l!2BC617A14E034. Shell shall be of cant

3、on flannel with a minimum warp and f i 11 thread count of 44 x 36 per square inch (645 square mm) . Cuffing material shall be nonwicking to oils, fuels, water and etc. 40/3 thread is required. WEIGHT: Approximately six pounds (2.7 kg.) per dozen pairs SIZE: Minimum length from base to tip of middle

4、finger 14 Hinimum width at thumb crotch 5-l/4 in. (133mm). Hinimum w at flared end 6-l/2 in. (1691s). CONSTRUCT I ON : Clute type pattern with a wing thumb. The s n. (3561nm) . dth of cuff l l 1 of the palm and thumb to be one piece. Shell to be securely sewn with a minimum of 8 chain stitches to th

5、e inch (25mm). Base of cuff shall be finished with a nontear bead. Gloves shall be fully coated forming a permanent bond without penetration to the inside of sheil. Gauge of neoprene coating shall be .030 to .038 (0.76 to 0.97mm). Gloves to be water proof and shall be free from blisters, pockmarks,

6、lumps, strip marks and weak spots between f i ngers. SUPPLIERS RESPONSIBILITY: All material supplied to this standard must be equivalent in all characteristics to the material upon which approval was originally granted, and shall be satisfactory for the intended appl ication. APPROVAL OF NEW SUPPLIE

7、RS: i 7.2 Pricing of gloves from proposed new suppliers should be determined to be.cost competitive by Purchasing and Supply Staff prior to obtaining laboratory and shop trial approvals. After the product has been determined to be cost competitive, gloves submitted by new manufacturers to this stand

8、ard and concluded to be cost competitive must have laboratory and shop trial approvals. Recommendations for the addition of new manufacturers to the Manufacturing Approved Source List (ASL) must be made by the appropriate division standards activity in writing to the Plant Engineering Office, Hanufacturing Staff. All supporting data must accompany the written request. The Plant Engineering Office, Hanufacturing Staff, and the Environmental Health and Safety Hanager, Employee Relations Staff, will review requests to determine approval.