FORD SB1-23-1990 KEVLAR BLEND GLOVES《KEVLAR混合物手套》.pdf

1、. . SBl-23 KEVLARBLEND GLOVES SBl-23 APRIL, 1990 Page 1 1 USAGE: The Safety Unit must approve this glove prior to usage. The L. gloves are designed for the handling of metal stampings and various parts which pose above average hazards. 2. 2.1 MATERIAL: This glove to be knitted of 3 singles, with end

2、s as follows: One end of 8/l Kevlar yarn, 100% pure and unblended, shall comprise 34% of total material content and constitute said material pile, as in the percentage shown. 2.2 One end of 7/l long staple domestic cotton, four mists par inch plus or minus l/2 inch (13mm) minimum, which shall compri

3、se 23% of total material content, and constitute said material backing. 2.3 One end of 7/l long staple domestic cotton, of four twists per inch, plus or minus l/2 inch (1311) multiple minimum, which shall comprise 41% of total material content, and constitute said material pile as in the percentage

4、shown. Cotton shall be comprised of one white cotton fiber and one brown cotton fiber blended into a single strand. 2.4 Incorpixated cuff shall be 42 coke, rubber, double covered vith polyester nabber insert, and shall comprise 2% of total material content. 2.5 . Long fiber referencd in all material

5、; mandates a minimum length of l-1/2 inches (38ti) per stable fiber. 3 _* SIZE: .lhe glOV8 shall measure a minimum of 8 inches (203mm) from tip of middle finger to glove body base. The width of the glove shafl,Measuke a minimum of 4-3/4 inches.(l2lmm) at thumb crotch. Extended cuff-poly rubber inser

6、t shall be 4 inches (102nun) in the clear, p.roducing a glove measurement overall minimum of 12 inches (305atm) from tip of middle finger to base of glove. 4. CONSTRUCTION: These three ends shall be knitted pile out, vith 30 courses of the double polyester 42 core rubber to form the incorporated ext

7、ended cuff with secure overcast of 30/3 yarn, 42 core rubber insert. 5. UEIGHT: Gloves shall weigh a minimum of 63 grams each, or 3.2 pounds per dozen pair. 6. RECUIHING: This glove shall be impervious to proper laundering procedures over a prudent recycling span. Iha necessity to patch this product

8、 is an indication that the glove may be deteriorating. Therefore, patching should be scrutinized. FORD MANUFACTURING -STANDARDS SBl-23 APRIL, 1990 .-BLEND GLOVES SBl-23 Page 2 7. COLOR CODING: is optional. Color coding of the elastic band at the base of the glove 8. MANUFACTURERS RESPONSIBILITY: All material supplied to this standard must be equivalent in all characteristics to the material upon which approval was originally granted, and shall be satisfactory for the intended application.