FORD WSS-M1H1001-A-2008 FABRIC AVANETTE PATTERN WOVEN JACQUARD UNLAMINATED TO BE USED WITH FORD WSS-M99P1111-A 《AVANETTE图案的非层压提花机织织物 与标准FORD WSS-M99P1111-A一起使用 》.pdf

1、 ENGINEERING MATERIAL SPECIFICATIONDate Action Revisions 2008 12 09 N-STATUS No Replacement L. Schmalz, FNA / M. Montgomery, FOE 2005 11 11 Activated N. J. Komatsu Printed copies are uncontrolled Copyright 2008, Ford Global Technologies, LLC Page 1 of 2 FABRIC, AVANETTE PATTERN, WOVEN JACQUARD, WSS-

2、M1H1001-A UNLAMINATED NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a woven jacquard polyester face fabric. 2. APPLICATION This specification was released originally for material used as an interior trim fabric for use in CD340/345. 3. REQUIREMENTS In addition

3、to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A2/A3/A4 as applicable. 3.1 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.2

4、 FABRIC CONSTRUCTION 3.2.1 Fabric Count, +/- 10% tolerance (ASTM D 3775) Warp 270 ends/10 cm Weft 170 picks/10 cm 3.2.2 Fabric Weight, +/- 15% tolerance (FLTM BN 106-01) 430 g/m23.3 COMPOSITION (ASTM D 629) Fabric 100% polyester ENGINEERING MATERIAL SPECIFICATIONWSS-M1H1001-APrinted copies are uncon

5、trolled Copyright 2008, Ford Global Technologies, LLC Page 2 of 2 3.4 YARN CONSTRUCTION (ASTM D 1244) Warp 785-870 dtex f 144-188 (air texturized, PES, semi-dull) Weft 589-651 dtex f 129-159 (air texturized, semi-dull, round) 4237-4683 dtex f 594-726(air texturized, twisted, semi-dull, round) 646-71

6、4 dtex f 1 (mono fill, (bright, round) 3.5 METHOD OF DYEING Yarn dyed or as approved by Materials Engineering 3.6 FINISHED OPERATIONS As approved by Materials Engineering 4. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. 4.1 Purchase departments will ensure that both materials defined in this specification and shipped to any one assembly plant will be produced by one supplier only.