FORD WSS-M1H747-A-2008 FABRIC CHROME PATTERN WOVEN JACQUARD UNLAMINATED TO BE USED WITH FORD WSS-M99P1111-A 《CHROME图案的不分层提花机织织物 与标准FORD WSS-M99P1111-A一起使用 》.pdf

1、 ENGINEERING MATERIAL SPECIFICATION Material Name Specification Number Date Action Revisions 2008 12 03 N-STATUS No Replacement L. Schmalz, FNA / M. Montgomery, FOE 2003 04 10 Revised Para 3.0 inserted; Para 3.1, 3.2, 3.3, 3.10, 3.11, 4 deleted 1997 10 28 Activated N.J. Komatsu Printed copies are un

2、controlled Page 1 of 2 Copyright 2008, Ford Global Technologies, Inc. FABRIC, CHROME PATTERN, WOVEN JACQUARD, WSS-M1H747-A UNLAMINATED NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a woven jacquard polyester face fabric. 2. APPLICATION This specification was re

3、leased originally for material used as an interior trim fabric for 1999 SE161. 3. REQUIREMENTS In addition to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A2/A3/A4 as applicable. 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part

4、producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.4 FABRIC CONSTRUCTION 3.4.1 Fabric Count, +/- 5 % tolerance (ASTM D 3775) Warp 255 ends/10 cm Weft 175 picks/10 cm 3.4.2 Fabric Weight, range (FLTM BN 106-01) 255 - 295 g/m23.5 COMPOSITION (ASTM

5、 D 629) Fabric 100 % polyester ENGINEERING MATERIAL SPECIFICATION WSS-M1H747-A Page 2 of 2 Copyright 2008, Ford Global Technologies, Inc. 3.6 YARN CONSTRUCTION (ASTM D 1244) Warp 540 dtex f130 - 150 (air texturized, semi-dul round) Weft 540 dtex f130 - 150 (air texturized, bright, trilobal) 3.7 METH

6、OD OF DYEING Yarn dyed or as approved by Materials Engineering 3.8 FINISHED OPERATIONS As approved by Materials Engineering 3.9 FLAMMABILITY (ISO 3795/SAE J369) Burn Rate, max 100 mm/minute Note: Not required on face fabric when used as a fully bonded composite. 5. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification: 5.1 Purchase departments will ensure that both materials defined in this specification and shipped to any one assembly plant will be produced by one supplier only.