FORD WSS-M1H904-A-2008 FABRIC STREETLINE PATTERN WOVEN JACQUARD UNLAMINATED TO BE USED WITH FORD WSS-M99P1111-A 《STREETLINE图案的不分层提花机织织物 与标准FORD WSS-M99P1111-A一起使用 》.pdf

1、 ENGINEERING MATERIAL SPECIFICATIONDate Action Revisions 2008 12 05 N-STATUS No Replacement L. Schmalz, FNA / M. Montgomery, FOE 2004 07 12 Activated N. J. Komatsu Printed copies are uncontrolled Copyright 2008, Ford Global Technologies, LLC Page 1 of 2 FABRIC, STREETLINE PATTERN, WOVEN JACQUARD, WS

2、S-M1H904-A UNLAMINATED NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a jacquard woven polyester face fabric. 2. APPLICATION This specification was released originally for material used as an interior trim fabric for BE-146 2002.75 Model Year. 3. REQUIREMENTS In

3、 addition to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A2/A3/A4 as applicable for commercial vehicle application. Material specification requirements are to be used for initial qualification of materials. 3.1 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS

4、 Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.2 FABRIC CONSTRUCTION 3.2.1 Fabric Count, +/- 5% tolerance (ASTM D 3775) Warp 346 ends/10 cm Weft 156 picks/10 cm 3.2.2 Fabric Weight, +/- 15% tolerance (FLTM BN 106

5、-01) 290 - 320 g/m23.3 COMPOSITION (ASTM D 629) Fabric 100% polyester 3.4 YARN CONSTRUCTION (ASTM D 1244) Warp 540 dtex f128 (PES, semi- dull, air texturized, round) Weft 540 dtex f144 (air texturized, bright, trilobal, PES) ENGINEERING MATERIAL SPECIFICATIONWSS-M1H904-APrinted copies are uncontroll

6、ed Copyright 2008, Ford Global Technologies, LLC Page 2 of 2 3.5 METHOD OF DYEING Yarn dyed or as approved by Materials Engineering. 3.6 FINISHING OPERATION As approved by Materials Engineering 4. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. 4.1 Purchase departments will ensure that both materials defined in this specification and shipped to any one assembly plant will be produced by one supplier only.