INTERN CEMS GT-17-2009 Oil Compatibility of Paint《油漆的油兼容性》.pdf

1、 This document is restricted and may not be sent outside Navistar, Inc. or reproduced without permission from Corporate Technical Standards. Suppliers are required to assume all patent liability. 2009 by Navistar, Inc. AUGUST 2009 Page 1 of 1 NAVISTAR, INC. CEMS (CORPORATE ENGINEERING MATERIAL SPECI

2、FICATION) NUMBER: CEMS GT-17 TITLE: Oil Compatibility of Paint CURRENT ISSUE DATE: August 2009 WRITTEN/REVIEWED BY: Materials Engineering APPROVED BY: Materials Engineering SUPERSEDES ISSUE OF: August 2001 PRINTED COPIES OF THIS DOCUMENT MUST BE VERIFIED FOR CURRENT REVISION This specification may i

3、nvolve hazardous materials, equipment, and procedures. This specification does not purport to address all of the safety issues associated with its use. The user is responsible to consult appropriate safety and health practices and to determine the applicability of regulatory limits prior to use. Cha

4、nge Notice: Replaced “International Truck and Engine Corporation” with “Navistar, Inc.” per corporate directive. 1.0 SCOPE This is a method for evaluating the ability of paint to cover oily substrates. 2.0 APPARATUS Recirculating oven capable of maintaining a temperature up to 93 3C (200 5F). 3.0 MA

5、TERIAL 3.1 Bonderite CD-10 or Bonderite 958 zinc phosphated steel panels, 100 x 300 mm (4 x 12 inches), available from Advanced Coatings Technologies, 273 Industrial Drive, Hillsdale, Michigan 49242. 3.2 SAE 10W30 Series 3 engine oil or equivalent 3.3 Absorbent paper, Kleenix, Kimwipes or equivalent

6、 4.0 PROCEDURE 4.1 Dip two panels in the engine oil to a depth equivalent to one half the panel length. 4.2 Remove the panels and allow to drain in vertical position for 15 minutes. 4.3 Place panels vertically in a recirculating oven for 30 minutes at 88 to 93 C (190 to 200 F) 4.4 Remove the panels

7、and allow to cool in still air at 21 to 27 C (70 to 80 F). 4.5 Using absorbent paper, remove excess oil from bottom edge of the panels. 4.6 Prepare two panels according to the method specified for the grade tested in Test Method GT-13, panel preparation, except eliminate the cleaning and priming ste

8、ps. 4.7 After drying, age the prepared panels in a recirculating oven for 72 hours at 49 3 C (120 5 F). Remove and cool to 21 to 27 C (70 to 80 F). 4.8 Examine the panels: any evidence of cratering, paint film “crawl” or dissolution on either the oiled or unoiled portions of the panel will constitute a failure. 5.0 REPORT Report whether the paint passes or fails this test. Copyright Navistar International Corporation Provided by IHS under license with INTERNNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-