ImageVerifierCode 换一换
格式:PDF , 页数:2 ,大小:87.40KB ,
资源ID:785918      下载积分:10000 积分
快捷下载
登录下载
邮箱/手机:
温馨提示:
如需开发票,请勿充值!快捷下载时,用户名和密码都是您填写的邮箱或者手机号,方便查询和重复下载(系统自动生成)。
如填写123,账号就是123,密码也是123。
特别说明:
请自助下载,系统不会自动发送文件的哦; 如果您已付费,想二次下载,请登录后访问:我的下载记录
支付方式: 支付宝扫码支付 微信扫码支付   
注意:如需开发票,请勿充值!
验证码:   换一换

加入VIP,免费下载
 

温馨提示:由于个人手机设置不同,如果发现不能下载,请复制以下地址【http://www.mydoc123.com/d-785918.html】到电脑端继续下载(重复下载不扣费)。

已注册用户请登录:
账号:
密码:
验证码:   换一换
  忘记密码?
三方登录: 微信登录  

下载须知

1: 本站所有资源如无特殊说明,都需要本地电脑安装OFFICE2007和PDF阅读器。
2: 试题试卷类文档,如果标题没有明确说明有答案则都视为没有答案,请知晓。
3: 文件的所有权益归上传用户所有。
4. 未经权益所有人同意不得将文件中的内容挪作商业或盈利用途。
5. 本站仅提供交流平台,并不能对任何下载内容负责。
6. 下载文件中如有侵权或不适当内容,请与我们联系,我们立即纠正。
7. 本站不保证下载资源的准确性、安全性和完整性, 同时也不承担用户因使用这些下载资源对自己和他人造成任何形式的伤害或损失。

版权提示 | 免责声明

本文(INTERN CEMS GT-1A-2009 Nonvolatile Content Of Paint By Weight《油漆的非挥发物的重量含量》.pdf)为本站会员(explodesoak291)主动上传,麦多课文库仅提供信息存储空间,仅对用户上传内容的表现方式做保护处理,对上载内容本身不做任何修改或编辑。 若此文所含内容侵犯了您的版权或隐私,请立即通知麦多课文库(发送邮件至master@mydoc123.com或直接QQ联系客服),我们立即给予删除!

INTERN CEMS GT-1A-2009 Nonvolatile Content Of Paint By Weight《油漆的非挥发物的重量含量》.pdf

1、 This document is restricted and may not be sent outside Navistar, Inc. or reproduced without permission from Corporate Technical Standards. Suppliers are required to assume all patent liability. 2009 by Navistar, Inc. AUGUST 2009 Page 1 of 2 NAVISTAR, INC. CEMS (CORPORATE ENGINEERING MATERIAL SPECI

2、FICATION) NUMBER: CEMS GT-1A TITLE: Nonvolatile Content Of Paint By Weight CURRENT ISSUE DATE: August 2009 WRITTEN/REVIEWED BY: Materials Engineering APPROVED BY: Materials Engineering SUPERSEDES ISSUE OF: August 2001 PRINTED COPIES OF THIS DOCUMENT MUST BE VERIFIED FOR CURRENT REVISION This specifi

3、cation may involve hazardous materials, equipment, and procedures. This specification does not purport to address all of the safety issues associated with its use. The user is responsible to consult appropriate safety and health practices and to determine the applicability of regulatory limits prior

4、 to use. Change Notice: Replaced “International Truck and Engine Corporation” with “Navistar, Inc.” per corporate directive. 1.0 SCOPE This is a method to determine nonvolatile (solids) content of paint by weight. 2.0 APPARATUS 2.1 2.1 Plastic disposable syringe, 5 ml capacity, B-D Luer Lok No. 805

5、L/S or equivalent. 2.2 2.2 Recirculating oven which maintains a temperature of118 3C (245 5F). 2.3 2.3 Balance with a sensitivity of 0.0001. 2.4 2.4 Desiccator. 2.5 2.5 A syringe holding yoke, constructed from Nichrome wire. 2.6 2.6 This attachment is used to hold syringe vertically during weighing

6、operation. (See illustration) 3.0 MATERIAL 3.1 Aluminum foil pan, 60 mm in diameter, Wilkens-Anderson No. 29025 or equivalent 3.2 Absorbent paper, Kleenex, Kimwipes or equivalent 4.0 PROCEDURE 4.1 Run this test five times for each paint sample being tested. 4.2 Determine the weight of the aluminum p

7、an to + 0.0001 gram and record as weight W1. 4.3 Transfer 2 to 3 milliliters of paint which has been prepared for testing according to the steps outlined in CEMS G-5, Part I, Section B, under ”Sampling Procedure”, to the plastic syringe. Do not allow perspiration to accumulate on the syringe during

8、handling. 4.4 After transferring the sample to the syringe, pull the syringe piston back slightly to draw the sample deeply into the orifice tip. Wipe the syringe tip with absorbent paper to clean the paint away. 4.5 Determine the total weight of the sample and syringe to + 0.0001 gram and record as

9、 weight W2. Weigh as rapidly as possible, preferably on a projection balance, keeping syringe in vertical position with a yoke accessory so that syringe opening is on top. 4.6 After transferring approximately 1 gram of paint from the syringe to the aluminum foil pan, reweigh the sample and syringe t

10、o + 0.0001 gram and record as weight W3. Copyright Navistar International Corporation Provided by IHS under license with INTERNNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-NUMBER: CEMS GT-1A TITLE: Nonvolatile Content Of Paint By Weight CURRENT ISSUE DATE: Augus

11、t 2009 This document is restricted and may not be sent outside Navistar, Inc. or reproduced without permission from Corporate Technical Standards. Suppliers are required to assume all patent liability. 2009 by Navistar, Inc. AUGUST 2009 Page 2 of 2 4.7 Flow the paint around the pan to obtain as thin

12、 a coat as possible by tilting the pan in various directions. Allow solvents to flash off for 15 minutes in still air at 21 to 27C (70 to 80F). 4.8 Place the foil pan and sample in a recirculating oven preheated to 118 + 3C (245 + 5F). After two hours, remove and cool in a dessicator to 21 to 27C (7

13、0 to 80F). 4.9 Reweigh the foil pan and sample to + 0.0001 gram and record as weight W4. 5.0 CALCULATIONS Calculate the nonvolatile content of the paint on a weight basis for each of the five test runs: Percent nonvolatile content by weight = W4-W1W2-W3x 100 6.0 REPORT Report the minimum percent nonvolatile content by weight obtained from the five test runs. Copyright Navistar International Corporation Provided by IHS under license with INTERNNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-

copyright@ 2008-2019 麦多课文库(www.mydoc123.com)网站版权所有
备案/许可证编号:苏ICP备17064731号-1