ImageVerifierCode 换一换
格式:PDF , 页数:5 ,大小:187.99KB ,
资源ID:981856      下载积分:10000 积分
快捷下载
登录下载
邮箱/手机:
温馨提示:
如需开发票,请勿充值!快捷下载时,用户名和密码都是您填写的邮箱或者手机号,方便查询和重复下载(系统自动生成)。
如填写123,账号就是123,密码也是123。
特别说明:
请自助下载,系统不会自动发送文件的哦; 如果您已付费,想二次下载,请登录后访问:我的下载记录
支付方式: 支付宝扫码支付 微信扫码支付   
注意:如需开发票,请勿充值!
验证码:   换一换

加入VIP,免费下载
 

温馨提示:由于个人手机设置不同,如果发现不能下载,请复制以下地址【http://www.mydoc123.com/d-981856.html】到电脑端继续下载(重复下载不扣费)。

已注册用户请登录:
账号:
密码:
验证码:   换一换
  忘记密码?
三方登录: 微信登录  

下载须知

1: 本站所有资源如无特殊说明,都需要本地电脑安装OFFICE2007和PDF阅读器。
2: 试题试卷类文档,如果标题没有明确说明有答案则都视为没有答案,请知晓。
3: 文件的所有权益归上传用户所有。
4. 未经权益所有人同意不得将文件中的内容挪作商业或盈利用途。
5. 本站仅提供交流平台,并不能对任何下载内容负责。
6. 下载文件中如有侵权或不适当内容,请与我们联系,我们立即纠正。
7. 本站不保证下载资源的准确性、安全性和完整性, 同时也不承担用户因使用这些下载资源对自己和他人造成任何形式的伤害或损失。

版权提示 | 免责声明

本文(NAVY MIL-STD-1320-15-1976 TRUCKLOADING ROCKET MOTOR MK 1 MOD 0 OR MK 37 MOD 0 (ASROC) IN CONTAINER MK 178 MOD 0《火箭发动机MK 1 MOD 0 或 MK 37 MOD 0(反潜火箭)在MK 1 MOD 0 或 MK 37 MOD 0集装箱的装车》.pdf)为本站会员(jobexamine331)主动上传,麦多课文库仅提供信息存储空间,仅对用户上传内容的表现方式做保护处理,对上载内容本身不做任何修改或编辑。 若此文所含内容侵犯了您的版权或隐私,请立即通知麦多课文库(发送邮件至master@mydoc123.com或直接QQ联系客服),我们立即给予删除!

NAVY MIL-STD-1320-15-1976 TRUCKLOADING ROCKET MOTOR MK 1 MOD 0 OR MK 37 MOD 0 (ASROC) IN CONTAINER MK 178 MOD 0《火箭发动机MK 1 MOD 0 或 MK 37 MOD 0(反潜火箭)在MK 1 MOD 0 或 MK 37 MOD 0集装箱的装车》.pdf

1、F T i ia a f 8 MILITARY STANDARD MIL-STD-1320-15 (NAVY) 3 AUGLST 1976. TRUCKLOADING ROCKET MOTOR MK 1 MOD O OR MK 37 MOD O (ASROC) . IN CONTAINER MK 178 MOD O SUPERSEDING WR-51/15 30 JULY 1961 CONTAINER DATA LENGTH 76 7/8 WIDTH 20 1/4 HEIGHT . 22 1/8 GROSS WT (APPROX) . TARE WT (APPROX) CUBE 19.9CU

2、FT . DWG NO . LD 497698 DOT HAZARD MSSIFICATION . EXPLOSIVES B 613 LBS 219 LBS d INDEX ITEM PAGE GENERAL NOTES 2 FTt 40 FT TRAILER 3 NOTES: 1, UNLESS OTHERWISE SPEJFIED DIMENSIONS ARE IN INCHES. LTL-ALL TRAILERS 4 2. FOR CROSS REFERENT TO ASSOCIATED PALLETIZING, CONTAINERLOADING AND STACKING i STRAP

3、PING 5 CARLOADING Pr?iTAXY STANDARDS, REFER TO INDEX TO STANDARDS, MIL-HDRK-236 (NAVY). I FSC 8140 AUT!iORIZED FOR HIGHWAY SHIPMENT ONLY7 - *.-. I Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,- MIL-STD-2320 -25 2 7777722 0070233 O -_ MIL-STD-1320-1

4、5 (NAVY) GENERAL NOTES I. 2. 3. 4 . 5. 6. 7. 8. 9. THIS DOCUMENT PROVIDES DETAILED INSTRUCTIONS FOR TRUCKLOADING MK 1 MOD O AND MK 37 MOD O ROCKET MOTORS WHEN IN THE MOTOR IS IN THE CONTAINER MK 178 MOD O. THE PROCEDURES AND PRACTICES DESCRIBED HEREIN ARE INTENDED FOR40, 42, 44AND45 FT VAN TRAILERS

5、WITH NAIIABLE OR NON- NAILABLE FLOORS. ALL TRAILERS SHALL HAVE THEIR TANDEM AXLES LOCATED IN THE “WESTERN“ POSITION (AT THE EXTREME REAR OF THE TRAILER). THE CONTAINERS, WHEN STACKED TWO HIGH, SHALL BE STRAPPED TOGETHER IN UNITS OF FOUR AS SHOWN ON PAGE 5. IF REQUIRED BY THE LENGTH OF THE TRAILER, T

6、WO CONTAINERS MAY BE STACKED (ONE ON TOP OF THE OTHER) AND STRAPPED TOGETHER. PLACE THIS UNIT OF TWO AT THE REAR OF THE LOAD. IT SHALL BE LOCATED A MINIMUM OF TWO UNITS FORWARD OF THE REAR OF THE UNITS STRAPPED IN FOURS. THE REAR BLOCKING ASSEMBLY, DETAIL 8, SHALL FILL THE VOID BETWEEN THE IADING AN

7、DTHE TRAILER DOORS WHEN THE DOORS ARE . CLOSED. DO NOT USE TRAILERS WITH ROLL UP DOORS WHEN BLOCKING BY THIS METHOD. WHEN A TRAILER hS NON-NAILABLE FLOORS AND SLEEPERS CANNOT BE NAILED TO THE FLOOR, SUBSTITLIIE FILLER ASSEMBLY, DETAIL C, FOR THE SLEEPERS. THE FILLER ASSEMBLYS SHALL FILL THE VOID BET

8、WEEN THE IADING AND THE TRAILER WALLS. ONE-HALF INCH SIACK IS PERMITTED. THE MIMUM GROSS WEIGHT OF THE TRACTOR-TRAILER AND THE ALLOWABLE AXLE WEIGHTS ARE THE RESPONSIBILITY OF THE CARRIER. THE CARRIER WILL ADVISE THE SHIPPER OF THESE LIMITATIONS AND THE SHIPPER SHALL LOAD THE TRAILER IN SUCH A MANNE

9、R THAT THE TRACTOR-TRAILER WILL NOT EXCEED THESE LIMITATIONS. AFTER BLOCKING AND WCING HAS BEEN INSPECTED, ATTACH SHIPPING DOCUMENTS TO INSIDE OF TRAILER IN AN ACCESSIBLE AREA, CLOSE AND SEAL TRAILER DOORS AND ATTACH “EXPLOSIVE 8“ PLACARD TO BOTH SIDES, FRONT AND BACK ORTRAILER. APPLICABLE WTERIAL S

10、PECIFICATIONS: DUNNAGE LUMBER, MM-L-751; NAILS, FF-N-l5, TYPE II STYLE IO, COMMON BRIGHT; STRAP- PING, QQ-5-781, PIPE I CLASS A. FOR GENERAL TRUCKLOADING PROCEDURES REFER TO THE GENERAL TRUCKLOADING DOCUMENT, MIL-STD-1324 (NAVY). FTL 40,42,44 _A_- MIL-STD-1320-15 (NAVY) STACKING AND STRAPPING FOR TR

11、UCKLOADING ONLY TO EXPEDITE TRUCKLOADING HANDLING AND LOADING OPERATIONS AND TO ASSURE THAT THE STACKING FEATURES REMIN ENGAGED, FOUR CONTAINERS SHALL BE STACKED AND STRAPPED TOGETHER IN ACCORDANCE WITH THE FOLLOWING PROCEDURE. i. 2. POSLTION BOTTOM CONTAINERS SIDE BY SIDE WITH THE FORE AND AFT ENDS

12、 IN THE SAME DIRECTION. POSITION THE TOP CONTAINERS ON THE BOTTOM CONTAINERS WITH THE FORE AND AFf ENDS IN THE SAME DIRECTION AS THE BOTTOM CONTAINERS. 1-1 ALL STACKING FEATURES MUST BE IN ALIGNMENT. 3. POSITION TWO 3/4 X .O35 X 13 FT STEEL STRAPS UNDER THE BODY OF THE BOTTOM TWO CONTAINERS AND OVER

13、 THE SKIDS OF THE TOP TWO CONTAINERS AS SHOWN. 4. TENSION AND SEAL WITH ONE DOUBLE NOTCHED 3/4 IN. SEAL(0R WO DOUBLE CRIMPED 3/4 IN SEALS). (WARNINOI STRAPPING SHALL BE REMOVED FROM CONTAINERS INDIRECTLY AFTER UNLOADING THE TRAILER. REVIEW ACTIVITY: NAVY - os , PREPARING ACTIVITY: .i NAW - OS (PROJECT NO. 8140-N342) - PAGE 5 7 i- - - _- Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-

copyright@ 2008-2019 麦多课文库(www.mydoc123.com)网站版权所有
备案/许可证编号:苏ICP备17064731号-1