NF R15-703-2-1996 Road vehicles Sheath-type glow-plugs with conical seating and their cylinder head housing Part 2 M12 X 1 25 glow-plugs 《道路车辆 带圆锥形支座的护套型电热塞及其圆柱体头盖外壳 第2部分 M12 x 1 .pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

NC 00-38-1987 National System for Standardizaron Metrology and Quality Control Standard Reference Samples General Principies《国家标准化，度量和质量控制系统，标准参考示例，基本原则》.pdf

NC 00-40-1985 National System for Standardizaron Metrology and Quality Control Guide for Drawing-Up of Verification Methods and Means Standards《国家标准化，度量和质量控制系统，检验方法和标准手段制订指南》.pdf

NC 01-01-1967 Selection of deviations and fits of ISA from IT 5 to IT 12《从IT5到IT12 ISA偏差和装配选择》.pdf

NC 01-02-1967 Selection of deviations ISA from IT 13 to IT 16《ISA从IT13到IT16偏差选择》.pdf

NC 01-03-1968 Selection of deviations and fits of ISA from 500 to 3 150 mm《从500到150mm ISA偏差和装配选择》.pdf

NC 01-04-1-1987 Ordenamiento y Regulaciones Generales MARCACION DE LAS CARGAS Marcas de manipulación《总体规定和次序 载重标记 操作标志》.pdf

NC 01-04-1987 General Ordering and Regulations oad Marking General Rules《一般定制命令和全尺寸标记通则》.pdf

NC 01-05-1967 Deviation of dimensions without tolerance indication 《没有标注公差的尺寸偏差》.pdf

NC 01-06-1967 Conversion of toleranced dimensions from inches into milimetres and viceversa 《公差尺寸转换：从英寸转换成毫米或者相反》.pdf