1、 NFPA 414 Standard for Aircraft Rescue and Fire-Fighting Vehicles 2017IMPORTANT NOTICES AND DISCLAIMERS CONCERNING NFPA DOCUMENTS NOTICE AND DISCLAIMER OF LIABILITY CONCERNING THE USE OF NFPA DOCUMENTS NFPA codes, standards, recommended practices, and guides (“NFPA Standards”), of which the document
2、 contained herein is one, are developed through a consensus standards development process approved by the American National Standards Institute. This process brings together volunteers representing varied viewpoints and interests to achieve consensus on re and other safety issues. While the NFPA adm
3、inisters the process and establishes rules to promote fairness in the development of consensus, it does not independently test, evaluate, or verify the accuracy of any information or the soundness of any judgments contained in NFPA Standards. The NFPA disclaims liability for any personal injury, pro
4、perty or other damages of any nature whatsoever, whether special, indirect, consequential or compensatory, directly or indirectly resulting from the publication, use of, or reliance on NFPA Standards. The NFPA also makes no guaranty or warranty as to the accuracy or completeness of any information p
5、ublished herein. In issuing and making NFPA Standards available, the NFPA is not undertaking to render professional or other services for or on behalf of any person or entity. Nor is the NFPA undertaking to perform any duty owed by any person or entity to someone else. Anyone using this document sho
6、uld rely on his or her own independent judgment or, as appropriate, seek the advice of a competent professional in determining the exercise of reasonable care in any given circumstances. The NFPA has no power, nor does it undertake, to police or enforce compliance with the contents of NFPA Standards
7、. Nor does the NFPA list, certify, test, or inspect products, designs, or installations for compliance with this document. Any certication or other statement of compliance with the requirements of this document shall not be attributable to the NFPA and is solely the responsibility of the certier or
8、maker of the statement. REMINDER: UPDATING OF NFPA STANDARDS Users of NFPA codes, standards, recommended practices, and guides (“NFPA Standards”) should be aware that NFPA Standards may be amended from time to time through the issuance of Tentative Interim Amendments or corrected by Errata. An ofcia
9、l NFPA Standard at any point in time consists of the current edition of the document together with any Tentative Interim Amendment and any Errata then in effect. In order to determine whether an NFPA Standard has been amended through the issuance of Tentative Interim Amendments or corrected by Errat
10、a, visit the Document Information Pages on NFPAs website. The Document Information Pages provide up-to-date, document specic information including any issued Tentative Interim Amendments and Errata. To view the Document Information Page for a specic Standard, go to http:/www.nfpa.org/docinfo to choo
11、se from the list of NFPA Standards or use the search feature on the right to select the NFPA Standard number (e.g., NFPA 101). The Document Information Page includes postings of all existing Tentative Interim Amendments and Errata. It also includes the option to register for an “Alert” feature to re
12、ceive an automatic email notication when new updates and other information are posted regarding the document. ISBN: 978-145591401-2 (Print) ISBN: 978-145591402-9 (PDF)IMPORTANT NOTICES AND DISCLAIMERS CONCERNING NFPA STANDARDS ADDITIONAL NOTICES AND DISCLAIMERS Updating of NFPA Standards Users of NF
13、PA codes, standards, recommended practices, and guides (“NFPA Standards”) should be aware that these documents may be superseded at any time by the issuance of new editions or may be amended from time to time through the issuance of Tentative Interim Amendments or corrected by Errata. An ofcial NFPA
14、 Standard at any point in time consists of the current edition of the document together with any Tentative Interim Amendments and any Errata then in effect. In order to determine whether a given document is the current edition and whether it has been amended through the issuance of Tentative Interim
15、 Amendments or corrected through the issuance of Errata, consult appropriate NFPA publications such as the National Fire Codes Subscription Service, visit the NFPA website at www.nfpa.org, or contact the NFPA at the address listed below. Interpretations of NFPA Standards A statement, written or oral
16、, that is not processed in accordance with Section 6 of the Regulations Governing the Development of NFPA Standards shall not be considered the ofcial position of NFPA or any of its Committees and shall not be considered to be, nor be relied upon as, a Formal Interpretation. Patents The NFPA does no
17、t take any position with respect to the validity of any patent rights referenced in, related to, or asserted in connection with an NFPA Standard. The users of NFPA Standards bear the sole responsibility for determining the validity of any such patent rights, as well as the risk of infringement of su
18、ch rights, and the NFPA disclaims liability for the infringement of any patent resulting from the use of or reliance on NFPA Standards. NFPA adheres to the policy of the American National Standards Institute (ANSI) regarding the inclusion of patents in American National Standards (“the ANSI Patent P
19、olicy”), and hereby gives the following notice pursuant to that policy: NOTICE: The users attention is called to the possibility that compliance with an NFPA Standard may require use of an invention covered by patent rights. NFPA takes no position as to the validity of any such patent rights or as t
20、o whether such patent rights constitute or include essential patent claims under the ANSI Patent Policy. If, in connection with the ANSI Patent Policy, a patent holder has led a statement of willingness to grant licenses under these rights on reasonable and nondiscriminatory terms and conditions to
21、applicants desiring to obtain such a license, copies of such led statements can be obtained, on request, from NFPA. For further information, contact the NFPA at the address listed below. Law and Regulations Users of NFPA Standards should consult applicable federal, state, and local laws and regulati
22、ons. NFPA does not, by the publication of its codes, standards, recommended practices, and guides, intend to urge action that is not in compliance with applicable laws, and these documents may not be construed as doing so. Copyrights NFPA Standards are copyrighted. They are made available for a wide
23、 variety of both public and private uses. These include both use, by reference, in laws and regulations, and use in private self-regulation, standardization, and the promotion of safe practices and methods. By making these documents available for use and adoption by public authorities and private us
24、ers, the NFPA does not waive any rights in copyright to these documents. Use of NFPA Standards for regulatory purposes should be accomplished through adoption by reference. The term “adoption by reference” means the citing of title, edition, and publishing information only. Any deletions, additions,
25、 and changes desired by the adopting authority should be noted separately in the adopting instrument. In order to assist NFPA in following the uses made of its documents, adopting authorities are requested to notify the NFPA (Attention: Secretary, Standards Council) in writing of such use. For techn
26、ical assistance and questions concerning adoption of NFPA Standards, contact NFPA at the address below. For Further Information All questions or other communications relating to NFPA Standards and all requests for information on NFPA procedures governing its codes and standards development process,
27、including information on the procedures for requesting Formal Interpretations, for proposing Tentative Interim Amendments, and for proposing revisions to NFPA standards during regular revision cycles, should be sent to NFPA headquarters, addressed to the attention of the Secretary, Standards Council
28、, NFPA, 1 Batterymarch Park, P.O. Box 9101, Quincy, MA 02269-9101; email: stds_adminnfpa.org For more information about NFPA, visit the NFPA website at www.nfpa.org. All NFPA codes and standards can be viewed at no cost at www.nfpa.org/freeaccess.414-1 NFPA, and National Fire Protection Association
29、are registered trademarks of the National Fire Protection Association, Quincy, Massachusetts, 02169 Copyright 2016 National Fire Protection Association . All Rights Reserved. NFPA 414 Standard for Aircraft Rescue and Fire-Fighting Vehicles 2017 Edition This edition of NFPA 414, Standard for Aircraft
30、 Rescue and Fire-Fighting Vehicles, was prepared by the Technical Committee on Aircraft Rescue and Fire Fighting. It was issued by the Standards Council on May 13, 2016, with an effective date of June 2, 2016, and supersedes all previous editions. This edition of NFPA 414 was approved as an American
31、 National Standard on June 2, 2016. Origin and Development of NFPA 414 In 1960, a tentative edition of this standard was adopted by the Association. The original document was further revised in 1962, 1963, 1964, 1965, 1967, 1968, 1969, 1970, 1975, and 1978. In 1984, the standard was revised complete
32、ly to identify three types of vehicles and to make the document easier to use. The text also was rewritten to conform with the NFPA Manual of Style. The standard was revised again in 1990, and a chapter was added to provide a test method to verify the design requirements. Notable revisions to the 19
33、95 edition included the removal of requirements for a separate category of rapid intervention vehicle. The major change for the 2001 edition was the combination of major re-ghting vehicles and combined agent vehicles. Additionally, a table concisely provided many requirements that previously were co
34、vered by numerous paragraphs. The 2007 revision included minor changes to the document plus the addition of a new chapter on interior access vehicles. For the 2012 edition of NFPA 414, the committee went through the entire document and made a multitude of changes to the requirements. Those changes i
35、ncluded the addition of an equivalency statement, to provide the AHJ or purchaser some exibility when it comes to meeting the requirements. There was also a new emphasis placed on Chapter 5, which deals with aircraft interior access vehicles. This was due largely to the increase in need for these ve
36、hicles based on the increased size of aircraft as well as some limitations to traditional aircraft rescue and re-ghting (ARFF) vehicles, whose primary function is re ghting. These vehicles assist in the evacuation of passengers from aircraft in addition to the use of evacuation slides or if the slid
37、es are not appropriate for use and deployment. Another important item addressed in the 2012 edition was that many ARFF vehicles are operated by a single person and that many of the devices and warnings/alarms are now designed with a single user/operator in mind. Generally speaking, many of the chang
38、es or enhancements that were introduced into the 2012edition revolved around the development and use of larger aircraft, such as the A-380 and the Boeing Dreamliner, as well as the composite materials from which they are manufactured. The capacities for ARFF vehicles have to be increased to address
39、this change in aircraft as well as to ensure that the vehicles are still able to meet prescribed response time standards. The committee has also addressed the environmental impact some extinguishing agents pose and have either limited them or removed them from the document and replaced them with acc
40、eptable alternatives. The committee also reviewed the entire document to ensure that it is consistent with the source documents, with commonly accepted practices as they relate to the ARFF industry, and with the Manual of Style for NFPA Technical Committee Documents. The 2017 edition revisions inclu
41、de updates to referenced publications and denitions and a rewrite of Chapter 5, Aircraft Interior Access Vehicles. This rewrite includes the addition of language to address cab visibility, cab construction, equipment, AIAV body, docking platform, acceptance criteria, and testing. Revisions also incl
42、ude extracted language from NFPA 1901 on SCBA mounting and a full extract of NFPA 1901 language for Chapter 6, Electrical System Performance Tests.AIRCRAFT RESCUE AND FIRE-FIGHTING VEHICLES 414-2 2017 Edition Technical Committee on Aircraft Rescue and Fire Fighting Duane F. Kann, Chair Greater Orlan
43、do Aviation Authority, FL E John W. McDonald, Secretary U.S. General Services Administration, MD U Rep. U.S. General Services Administration Keith W. Bagot, U.S. Federal Aviation Administration, NJ RT Rep. U.S. Federal Aviation Administration Ralph Colet, JRI Inc., CA M Howard Costa, Massport Fire R
44、escue, MA U Ross A. Davidson, U.S. Department of the Navy, CA E Rep. U.S. Department of the Navy Graeme Day, LHR Airports Limited, United Kingdom U Hanh Deniston, Metropolitan Washington Airports Authority, VA L Rep. International Association of Fire Fighters Fred B. Goodnight, Amerex Corporation, A
45、L M Rep. Fire Equipment Manufacturers Association Neil Gray, United Kingdom Civil Aviation Authority, United Kingdom E Michael A. Greenup, Los Angeles Fire Department, CA U John M. Huffman, Rosenbauer America General Safety, MN M Rep. Fire Apparatus Manufacturers Association Ronald E. Jones, E-One,
46、Inc., FL M Randy J. Krause, Port of Seattle Fire Department, WA E Rep. International Association of Fire Chiefs D. Scott Lanter, Blue Grass Airport, KY C Rep. Airports Council International-North America Stephen Listerman, Cincinnati/Northern Kentucky International Airport Fire Department, OH E John
47、 Anderson Maddox, Lakeland Fire Department, FL U Douglas C. Mangels, Denver Fire Department, CO SE Rep. Aircraft Rescue & Fire Fighting Working Group, Inc. Graydon L. Matheson, King County Sheriffs Ofce-ARFF Division, WA U Robert C. Mathis, The Boeing Company, WA SE John E. McLoughlin, Fire Research
48、 Corporation, NY M Kevin J. Petit, Akron Brass Company, OH M Pam L. Phillips, Port Authority of New York & New Jersey, NJ C Rep. American Association of Airport Executives Danny M. Pierce, ARFF Solutions, CA SE James E. Podolske, Jr., U.S. Department of the Air Force, FL E Joseph L. Scheffey, JENSEN
49、 HUGHES, MD SE Jason Shively, Oshkosh Corporation, WI M Jeremy Souza, Rhode Island Airport Corporation, RI U Marc S. Tonnacliff, U.S. Federal Aviation Administration, DC E Rep. U.S. Federal Aviation Administration Christopher A. Toten, U.S. Marine Corps, CA E Alternates Gerard G. Back, JENSEN HUGHES, MD SE (Alt. to Joseph L. Scheffey) Ralph B. Colet, JRI Inc., CA M (Alt. to Ralph Colet) Bradford Colton, American Pacic Corporation, NV M (Alt. to Fred B. Goodnight) Robert L. Darwin, Engility Co
