1、 SAE Technical Standards Board Rules provide that: “This report is published by SAE to advance the state of technical and engineering sciences. The use of this report is entirely voluntary, and its applicability and suitability for any particular use, including any patent infringement arising theref
2、rom, is the sole responsibility of the user.” SAE reviews each technical report at least every five years at which time it may be reaffirmed, revised, or cancelled. SAE invites your written comments and suggestions. Copyright 2006 SAE International All rights reserved. No part of this publication ma
3、y be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SAE. TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada) Tel: 724-776-4970 (outside USA)
4、Fax: 724-776-0790 Email: custsvcsae.org SAE WEB ADDRESS: http:/www.sae.org AMS 2451/1A AEROSPACE MATERIAL SPECIFICATION Issued JUL 1998 Revised MAY 2006 Superseding AMS 2451/1 Plating, Brush, Nickel General Purpose RATIONALE AMS 2451/1A is a Five Year Review and update of this specification. 1. SCOP
5、E 1.1 Purpose This specification establishes the requirements for a general purpose brush plating of nickel applied by electrodeposition. 1.2 Application See AMS 2451. 1.3 Safety - Hazardous Materials See AMS 2451. 2. APPLICABLE DOCUMENTS See AMS 2451. 3. TECHNICAL REQUIREMENTS See AMS 2451 3.1 Proc
6、edure 3.1.1 Nickel shall be electrodeposited from a sulfate, sulfate-organic, sulfamate or other suitable brush plating solution in accordance with processing instructions from the solution manufacturer. 4. QUALITY ASSURANCE PROVISIONS See AMS 2451. 5. PREPARATION FOR DELIVERY See AMS 2451. Copyrigh
7、t SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SAE AMS 2451/1A - 2 - 6. ACKNOWLEDGMENT See AMS 2451. 7. REJECTIONS See AMS 2451. 8. NOTES See AMS 2451. 8.1 Plating meeting the requirements of this specifica
8、tion will meet the requirements of AMS 2403. 8.2 Key Words Nickel plate, brush plating, selective plating, repair, worn parts, mismachined parts, brazing aid PREPARED BY AMS COMMITTEE “B” Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
